Polyoxometalate-Intercalated Tremella-Like CoNi-LDH Nanocomposites for Electrocatalytic Nitrite-Ammonia Conversion.

The electrocatalytic reduction of NO2- (NO2RR) holds promise as a sustainable pathway to both promoting the development of emerging NH3 economies and allowing the closing of the NOx loop. Highly efficient electrocatalysts that could facilitate this complex six-electron transfer process are urgently desired. Herein, tremella-like CoNi-LDH intercalated by cyclic polyoxometalate (POM) anion P8W48 (P8W48/CoNi-LDH) prepared by a simple two-step hydrothermal-exfoliation assembly method is proposed as an effective electrocatalyst for NO2- to NH3 conversion. The introduction of POM with excellent redox ability tremendously increased the electrocatalytic performance of CoNi-LDH in the NO2RR process, causing P8W48/CoNi-LDH to exhibit large NH3 yield of 0.369 mmol h-1 mgcat-1 and exceptionally high Faradic efficiency of 97.0% at -1.3 V vs the Ag/AgCl reference electrode in 0.1 M phosphate buffer saline (PBS, pH = 7) containing 0.1 M NO2-. Furthermore, P8W48/CoNi-LDH demonstrated excellent durability during cyclic electrolysis. This work provides a new reference for the application of POM-based nanocomposites in the electrochemical reduction of NO2- to obtain value-added NH3.

Ratiometric electrochemiluminescence sensing and intracellular imaging of ClO- via resonance energy transfer.

Electrochemiluminescence resonance energy transfer (ECL-RET) is a versatile signal transduction strategy widely used in the fabrication of chem/biosensors. However, this technique has not yet been applied in visualized imaging analysis of intracellular species due to the insulating nature of the cell membrane. Here, we construct a ratiometric ECL-RET analytical method for hypochlorite ions (ClO-) by ECL luminophore, with a luminol derivative (L-012) as the donor and a fluorescence probe (fluorescein hydrazide) as the acceptor. L-012 can emit a strong blue ECL signal and fluorescein hydrazide has negligible absorbance and fluorescence signal in the absence of ClO-. Thus, the ECL-RET process is turned off at this time. In the presence of ClO-, however, the closed-loop hydrazide structure in fluorescein hydrazide is opened via specific recognition with ClO-, accompanied with intensified absorbance and fluorescence signal. Thanks to the spectral overlap between the ECL spectrum of L-012 and the absorption spectrum of fluorescein, the ECL-RET effect is gradually recovered with the addition of ClO-. Furthermore, the ECL-RET system has been successfully applied to image intracellular ClO-. Although the insulating nature of the cell itself can generate a shadow ECL pattern in the cellular region, extracellular ECL emission penetrates the cell membrane and excites intracellular fluorescein generated by the reactions between fluorescein hydrazide and ClO-. The cell imaging strategy via ECL-RET circumvents the blocking of the cell membrane and enables assays of intracellular species. The importance of the ECL-RET platform lies in calibrating the fluctuation from the external environment and improving the selectivity by using fluorescent probes. Therefore, this ratiometric ECL sensor has shown broad application prospects in the identification of targets in clinical diagnosis and environmental monitoring.

Hair analysis, a reliable and non-invasive method to evaluate the contamination by clenbuterol.

The illegal use of clenbuterol has been an increasingly serious issue in today's livestock products industry. It becomes an important project to develop a reliable approach to detect its content in food animals. A simple and sensitive LC-MS/MS method was developed to detect clenbuterol residue in hair, with the low limit of quantitation (LLOQ) about 0.5ng/g. Hogs fed with 340µg/day of clenbuterol for 2 weeks were found a high clenbuterol residue in their hair approximately at 1-2 months after withdrawal. There remained 3.31ng/g clenbuterol in hog hair approximately 5 months after the last administration, focused on the tip of the hair (mainly in hogs with dark hair). An extensive contamination was observed in twenty investigated market hogs whose dark hair obviously had a higher clenbuterol residue than the light ones (p=0.017, t test). Volunteers (60.3 percent) from Xuhui district (Shanghai) were found to have a detectable amount of clenbuterol in their hair (>0.5ng/g). In conclusion, hair residue detection is a reliable method to evaluate the clenbuterol contamination in animals and humans. Meat supply in the Xuhui district might have serious potential safety risks which should be further investigated and discussed to determine the safety range of clenbuterol residue.

MoP/Mo2C@C: A New Combination of Electrocatalysts for Highly Efficient Hydrogen Evolution over the Entire pH Range.

During the exploration of highly efficient noble-metal-free electrocatalysts for the hydrogen evolution reaction (HER), a promising and challenging strategy is to fabricate composite nanocatalysts by finely tuning metal and/or nonmetal element components. Herein, we report a new HER electrocatalyst, which is composed of molybdenum phosphide and molybdenum carbide composite nanoparticles (NPs) coated by few-layer N-doped graphitic carbon shells (denoted as MoP/Mo2C@C). Such a new combination mode of electrocatalysts is realized by a one-step annealing route with the mixture of a Mo/P-based polyoxometalate (POM) and dicyandiamide. On the basis of this method, the simultaneous phosphorization and carbonization in a nanoscale confined space can be easily achieved by the use of POM as the molecular-element-regulating platform. MoP/Mo2C@C exhibits more remarkable HER performance over the whole pH range than those of MoP, Mo2C, and the physical mixture of MoP and Mo2C. The low overpotentials of 89, 136, and 75 mV were obtained at a current density of 10 mA cm-2 in the media of pH = 0, 7, and 14, respectively. Furthermore, MoP/Mo2C@C shows a long-term durability for 14 h over the entire pH range (0-14). Because of the protection of carbon shells, such composite electrocatalyst also possesses better transition-metal tolerance exemplified by Fe2+, Co2+, and Ni2+ than that of 20% commercial Pt/C. This work demonstrates the advantage of POM precursors in adjusting the component and properties of nanoscale composite electrocatalysts for HER, which may suggest new options for the fabrication of highly efficient composite electrocatalysts.