RESUMO
Using high-strength steel (yield strength fy ≥ 460 MPa) in concrete-filled steel tubes is expected to provide a superior bearing capacity by achieving light weight and efficient construction, but the existing design limitation on diameter-to-thickness (D/t) ratios for concrete-filled high-strength steel tubular (CFHST) members inevitably obstructs its wide application. In this study, aiming at the application of circular CFHST members using Q690 steel (fy ≥ 690 MPa), a total of 15 CFHST beams were examined using a three-point loading test to investigate the failure mode, bearing capacity and plasticity evolution. Subsequently, finite element models (FEMs) were established to analyze the full-range curves, composite effect, failure mechanism and influences of key parameters including material strengths, D/t ratios, and shear-span ratios. A simplified calculation method for bearing capacity was finally proposed and verified. The results indicate that the full-range performance of tested CFHST members with out-of-code D/t ratios have ductile behavior, though they fail through the mode of steel fracture and concrete cracks in the tension zone as well as through local buckling in the compression zone; out-of-code CFHST members (e.g., D/t = 120) can perform reasonable composite behavior because of contact pressure larger than 2.5 MPa, where a thin-walled steel tube experiences an arch failure mechanism similar to core concrete at a trussed angle of 45°; the simplified bearing capacity model achieves a mean value of 0.97, and can be accepted as a primary tool to perform structural design and performance evaluation.
RESUMO
Studies have shown that periodontal pathogens can enter the bloodstream, causing a series of reactions that can lead to a variety of systemic diseases. Epidemiological investigations also found a tight correlation between periodontitis (PD) and osteoporosis. This study aimed to further explore the effect of periodontal pathogens on bone volume fraction like bone tissue and mass, and explain the relationship between PD and osteoporosis. Sprague Dawley rats (female, 16 weeks old) were divided into the wild-type (WT) control group (n=9) and PD group (n=9). After eight weeks, periodontal tissues and ligatures, the fourth lumbar vertebra, the femur, the tibia, and blood were extracted and analyzed by micro-computed tomography (micro-CT), hematoxylin and eosin (H&E) staining, tartrate-resistant acid phosphatase (TRAP) staining, polymerase chain reaction (PCR), and enzyme-linked immunoassay (ELISA), respectively. We found that the bone mass of the lumbar vertebra, femur, and tibia was decreased in the PD group. The number of osteoclasts was higher in bone tissue in the PD group than in the WT group (P<0.05). The levels of inflammatory mediators and type I collagen C-terminal peptide (CTX-1) were higher in the PD group than in the WT group (P<0.05), although no significant difference in bone glutamic acid protein (BGP) levels was observed (P>0.05). In addition, we detected several periodontal pathogens, such as Porphyromonas gingivalis, Actinobacillus actinomycetemcomitans, and Fusobacterium nucleatum, in blood samples from rats in the PD group. These findings suggest that periodontal pathogens can enter the blood circulation from periodontal tissue, promote a systemic inflammation response, and subsequently reduce systemic bone density.