ABSTRACT
An application of mechanical energy was explored as a new non-thermal method to drive H2 emission from undoped sodium alanate at room temperature. It was found that mild rubbing of NaAlH4 pellets under vacuum led to intensive and almost instantaneous gas emission. The dominating species in the emitted gases was H2 (>99%). Traces of mono- and polyalanes, NaAlH4 vapours, CO2 and other non-identified gases were registered. H2 emission involved several first-order processes, whose characteristic time constants ranged widely from 0.6 to 465 s. None of the dehydrogenation reactions could be connected to either the thermal effect of friction or the direct coupling of mechanical forces to the energy landscape of chemical reactions. In turn, it was suggested that the tribochemical reactions can be triggered by plastic deformation and shearing. A linked diffusion-wear model of NaAlH4 triboinduced dehydrogenation, which consistently explains all empirical findings, was put forward.
ABSTRACT
In the last decades, a broad family of hydrides have attracted attention as prospective hydrogen storage materials of very high gravimetric and volumetric capacity, fast H2 -sorption kinetics, environmental friendliness and economical affordability. However, constraints due to their high activation energies of the different H2 -sorption steps and the Gibbs energy of their reaction with H2 has led to the need of high thermal energy to drive H2 uptake and release. High heat leads to significant degradation effects (recrystallization, phase segregation, nanoparticles agglomeration ) of the hydrides. In this context, this short review aims to summarize alternative non-thermal methods and non-straightforward thermally driven methods to overcome the previous constraints. The phenomenology lying behind these methods, i. e. tribological activation, sonication, and electromagnetic radiation, and the effect of these processes on hydrogen sorption properties of hydrides are described. These non-usual approaches could boost the capability of the next generation of solid-hydride materials for hydrogen conversion in energy sector, in mobile devices and as hydrogen reservoirs.
ABSTRACT
This work investigates the growth of B-C-N layers by chemical vapor deposition using methylamine borane (MeAB) as the single-source precursor. MeAB has been synthesized and characterized, paying particular attention to the analysis of its thermolysis products, which are the gaseous precursors for B-C-N growth. Samples have been grown on Cu foils and transferred onto different substrates for their morphological, structural, chemical, electronic and optical characterizations. The results of these characterizations indicate a segregation of h-BN and graphene-like (Gr) domains. However, there is an important presence of B and N interactions with C at the Gr borders, and of C interacting at the h-BN-edges, respectively, in the obtained nano-layers. In particular, there is a significant presence of C-N bonds, at Gr/h-BN borders and in the form of N doping of Gr domains. The overall B:C:N contents in the layers is close to 1:3:1.5. A careful analysis of the optical bandgap determination of the obtained B-C-N layers is presented, discussed and compared with previous seminal works with samples of similar composition.
ABSTRACT
Tuning the electrocatalytic properties of MoS2 layers can be achieved through different paths, such as reducing their thickness, creating edges in the MoS2 flakes, and introducing S-vacancies. We combine these three approaches by growing MoS2 electrodes by using a special salt-assisted chemical vapor deposition (CVD) method. This procedure allows the growth of ultrathin MoS2 nanocrystals (1-3 layers thick and a few nanometers wide), as evidenced by atomic force microscopy and scanning tunneling microscopy. This morphology of the MoS2 layers at the nanoscale induces some specific features in the Raman and photoluminescence spectra compared to exfoliated or microcrystalline MoS2 layers. Moreover, the S-vacancy content in the layers can be tuned during CVD growth by using Ar/H2 mixtures as a carrier gas. Detailed optical microtransmittance and microreflectance spectroscopies, micro-Raman, and X-ray photoelectron spectroscopy measurements with sub-millimeter spatial resolution show that the obtained samples present an excellent homogeneity over areas in the cm2 range. The electrochemical and photoelectrochemical properties of these MoS2 layers were investigated using electrodes with relatively large areas (0.8 cm2). The prepared MoS2 cathodes show outstanding Faradaic efficiencies as well as long-term stability in acidic solutions. In addition, we demonstrate that there is an optimal number of S-vacancies to improve the electrochemical and photoelectrochemical performances of MoS2.
ABSTRACT
Tribochemical decomposition of magnesium hydride (MgH2) induced by deformation at room temperature was studied on a micrometric scale, in situ and in real time. During deformation, a near-full depletion of hydrogen in the micrometric affected zone is observed through an instantaneous (t < 1 s) and huge release of hydrogen (3-50 nmol/s). H release is related to a nonthermal decomposition process. After deformation, the remaining hydride is thermally decomposed at room temperature, exhibiting a much slower rate than during deformation. Confocal-microRaman spectroscopy of the mechanically affected zone was used to characterize the decomposition products. Decomposition was enhanced through the formation of the distorted structure of MgH2 with reduced crystal size by mechanical deformation.
ABSTRACT
Ethane 1,2-diamineborane (EDAB) is an alkyl-containing amine-borane adduct with improved hydrogen desorption properties as compared to ammonia borane. In this work, it is reported the high temperature thermolytic decomposition of EDAB. Thermolysis of EDAB has been investigated by concomitant thermogravimetry-differential thermal analysis-mass spectrometry experiments. EDAB shows up to four H2 desorption events below 1000 °C. Small fractions of CH4, C2H4 and CO/CO2 are also observed at moderate-high temperatures. The solid-state thermolysis product has been characterized by means of different structural and chemical methods, such as X-ray diffraction, Raman spectroscopy, Scanning electron microscopy, Elemental analysis, and X-ray photoelectron spectroscopy (XPS). The obtained results indicate the formation of a ternary borocarbonitride compound with a poorly-crystalline graphitic-like structure. By contrast, XPS measurements show that the surface is rich in carbon and nitrogen oxides, which is quite different to the bulk of the material.
ABSTRACT
Titanium trisulfide (TiS3) has recently attracted the interest of the 2D community because it presents a direct bandgap of â¼1.0 eV, shows remarkable photoresponse, and has a predicted carrier mobility up to 10000 cm(2) V(-1) s(-1). However, a study of the vibrational properties of TiS3, relevant to understanding the electron-phonon interaction that can be the main mechanism limiting the charge carrier mobility, is still lacking. In this work, we take the first steps to study the vibrational properties of TiS3 through temperature-dependent Raman spectroscopy measurements of TiS3 nanoribbons and nanosheets. Our investigation shows that all the Raman modes linearly soften (red shift) as the temperature increases from 88 to 570 K due to anharmonic vibrations of the lattice, which also includes contributions from the lattice thermal expansion. This softening with the temperature of the TiS3 modes is more pronounced than that observed in other 2D semiconductors, such as MoS2, MoSe2, WSe2, and black phosphorus (BP). This marked temperature dependence of the Raman spectra could be exploited to determine the temperature of TiS3 nanodevices by using Raman spectroscopy as a noninvasive and local thermal probe. Interestingly, the TiS3 nanosheets show a stronger temperature dependence of the Raman modes than the nanoribbons, which we attribute to lower interlayer coupling in the nanosheets.