ABSTRACT
Requirements on the double-cladding Yb-doped fiber (DCYF) for power scaling of diffraction-limited fiber amplifiers are studied in this paper. By considering the limitations of thermal lens and transverse mode instability separately, it is found that the power scaling limit can be enlarged to more-than 100â kW and 80â kW, respectively, with the proper selection of pump and signal wavelengths. It is also found that the requirements on DCYF strongly depend on the wavelength and brightness of pump light. It is predicted that smaller-than 20-µm core diameter is required to achieve the 20-kW output power, as long as the 976-nm pump brightness can be high enough. The requirements on the inner-cladding diameter and cladding-to-core ratio of DCYF are also investigated.
ABSTRACT
In this paper, a hundred-watt-level near-diffraction-limited step-index Yb-doped fiber (YDF) laser near 980 nm is demonstrated firstly, to the best of our knowledge. By using the 11.7-W 979-nm single-mode seed light, the in-band amplified spontaneous emission (ASE) is well suppressed and the maximum output power of 101.5 W with the beam quality (M2 factor) of 1.285 was obtained. This work does not only propose an effective method for the suppression of in-band ASE, but also provides a cost-effective solution of hundred-Watt-level near-diffraction-limited fiber lasers near 980 nm.
ABSTRACT
In this Letter, to the best of our knowledge, the first kilowatt monolithic Yb-doped fiber laser operating near 980 nm is demonstrated. The fiber laser is achieved with the help of an all-fiber amplifier fabricated with a 105/250-µm core/cladding-diameter double-cladding Yb-doped fiber. With 11-W seed light, about 1.11-kW output power was obtained with 65.3% slope efficiency. The center wavelength was around 978 nm with a 10-dB bandwidth of about 0.6 nm. About 34-dB suppression of 1030-nm amplified spontaneous emission was realized, and the output beam quality (M2 factor) was about 16.2 at maximum output power. Better beam quality can be expected by optimizing the seed light and active fiber. This work can provide significant guidance for the study and designation of high-power fiber lasers operating near 980 nm and other three-level fiber sources.