Optimized terahertz pulse generation with chirped pump pulses from an echelon-based tilted-pulse-front (TPF) scheme.

We successfully demonstrated the generation of single-cycle terahertz (THz) pulses through tilted-pulse-front (TPF) pumping using a reflective echelon in a lithium niobate crystal. By optimizing the pump pulse duration using a chirp, we achieved a maximum pump-to-THz conversion efficiency of 0.39%. However, we observed that the saturation behavior began at a relatively low pump energy (0.37 mJ), corresponding to a pump intensity of 22 GW/cm2. To elucidate this behavior, we measured the near- and far-field THz beam profiles and found variations in their beam characteristics, such as the beam size, location, and divergence angle in the plane of the tilted pulse direction, with the pump energy (intensity). This nonlinear behavior is attributed to the reduced effective interaction length, which ultimately leads to the saturation of THz generation. The results obtained from our study suggest that it is feasible to develop an effective THz source using echelon-based TPF pumping while also considering the impact of nonlinear saturation effects.

Statistical analysis of hard X-ray radiation at the PAL-XFEL facility performed by Hanbury Brown and Twiss interferometry.

A Hanbury Brown and Twiss interferometry experiment based on second-order correlations was performed at the PAL-XFEL facility. The statistical properties of the X-ray radiation were studied within this experiment. Measurements were performed at the NCI beamline at 10 keV photon energy under various operation conditions: self-amplified spontaneous emission (SASE), SASE with a monochromator, and self-seeding regimes at 120 pC, 180 pC and 200 pC electron bunch charge. Statistical analysis showed short average pulse duration from 6 fs to 9 fs depending on the operational conditions. A high spatial degree of coherence of about 70-80% was determined in the spatial domain for the SASE beams with the monochromator and self-seeding regime of operation. The obtained values describe the statistical properties of the beams generated at the PAL-XFEL facility.

Generation of time-synchronized two-color X-ray free-electron laser pulses using phase shifters.

To optimize the intensity of X-ray free-electron lasers (XFELs), phase shifters, oriented in phase with the phases of the XFEL pulse and electron beam, are typically installed at undulator lines. Although a π-offset between the phases (i.e., an "out-of-phase" configuration) can suppress the XFEL intensity at resonant frequencies, it can also generate a side-band spectrum, which results in a two-color XFEL pulse; the dynamics of such a pulse can be described using the spontaneous radiation or low gain theory. This attributes of this two-color XFEL pulse can be amplified (log-scale amplification) through an undulator line with out-of-phase phase shifters. In this study, the features of two-color XFEL pulses were evaluated through theory, simulations and experiments performed at Pohang Accelerator Laboratory X-ray Free Electron Laser. The XFEL gain slope and energy separation between the two-color spectral peaks were consistent through theoretical expectation, and the results of simulation and experiment. The experimentally determined two-color XFEL pulse energy was 250 µJ at a photon energy of 12.38 keV with a separation of 60 eV.

Effect of Intermetallic Compounds on the Thermal and Mechanical Properties of Al⁻Cu Composite Materials Fabricated by Spark Plasma Sintering.

Aluminium-copper composite materials were successfully fabricated using spark plasma sintering with Al and Cu powders as the raw materials. Al-Cu composite powders were fabricated through a ball milling process, and the effect of the Cu content was investigated. Composite materials composed of Al-20Cu, Al-50Cu, and Al-80Cu (vol.%) were sintered by a spark plasma sintering process, which was carried out at 520 °C and 50 MPa for 5 min. The phase analysis of the composite materials by X-ray diffraction (XRD) and energy-dispersive spectroscopy (EDS) indicated that intermetallic compounds (IC) such as CuAl2 and Cu9Al4 were formed through reactions between Cu and Al during the spark plasma sintering process. The mechanical properties of the composites were analysed using a Vickers hardness tester. The Al-50Cu composite had a hardness of approximately 151 HV, which is higher than that of the other composites. The thermal conductivity of the composite materials was measured by laser flash analysis, and the highest value was obtained for the Al-80Cu composite material. This suggests that the Cu content affects physical properties of the Al-Cu composite material as well as the amount of intermetallic compounds formed in the composite material.

Shock ion acceleration by an ultrashort circularly polarized laser pulse via relativistic transparency in an exploded target.

We investigated ion acceleration by an electrostatic shock in an exploded target irradiated by an ultrashort, circularly polarized laser pulse by means of one- and three-dimensional particle-in-cell simulations. We discovered that the laser field penetrating via relativistic transparency (RT) rapidly heated the upstream electron plasma to enable the formation of a high-speed electrostatic shock. Owing to the RT-based rapid heating and the fast compression of the initial density spike by a circularly polarized pulse, a new regime of the shock ion acceleration driven by an ultrashort (20-40 fs), moderately intense (1-1.4 PW) laser pulse is envisaged. This regime enables more efficient shock ion acceleration under a limited total pulse energy than a linearly polarized pulse with crystal laser systems of λ∼1µm.