ABSTRACT
Ionic control of magnetism gives rise to high magnetoelectric coupling efficiencies at low voltages, which is essential for low-power magnetism-based nonconventional computing technologies. However, for on-chip applications, magnetoionic devices typically suffer from slow kinetics, poor cyclability, impractical liquid architectures, or strong ambient effects. As a route to overcoming these problems, we demonstrate a LiPON-based solid-state ionic supercapacitor with a magnetic Pt/Co40Fe40B20/Pt thin-film electrode which enables voltage control of a magnetic skyrmion state. Skyrmion nucleation and annihilation are caused by Li ion accumulation and depletion at the magnetic interface under an applied voltage. The skyrmion density can be controlled through dc applied voltages or through voltage pulses. The skyrmions are nucleated by single 60 µs voltage pulses, and devices are cycled 750000 times without loss of electrical performance. Our results demonstrate a simple and robust approach to ionic control of magnetism in spin-based devices.
ABSTRACT
Long-distance transport and control of spin waves through nanochannels is essential for integrated magnonic technology. Current strategies relying on the patterning of single-layer nano-waveguides suffer from a decline of the spin-wave decay length upon downscaling or require large magnetic bias field. Here, we introduce a new waveguiding structure based on low-damping continuous yttrium iron garnet (YIG) films. Rather than patterning the YIG film, we define nanoscopic spin-wave transporting channels within YIG by dipolar coupling to ferromagnetic metal nanostripes. The hybrid material structure offers long-distance transport of spin waves with a decay length of â¼20 µm in 160 nm wide waveguides over a broad frequency range at small bias field. We further evidence that spin waves can be redirected easily by stray-field-induced bends in continuous YIG films. The combination of low-loss spin-wave guiding and straightforward nanofabrication highlights a new approach toward the implementation of magnonic integrated circuits for spin-wave computing.
ABSTRACT
We studied the influence of a static in-plane magnetic field on the alternating-field-driven emission of nanoscale spin waves from magnetic vortex cores. Time-resolved scanning transmission X-ray microscopy was used to image spin waves in disk structures of synthetic ferrimagnets and single ferromagnetic layers. For both systems, it was found that an increasing magnetic bias field continuously displaces the wave-emitting vortex core from the center of the disk toward its edge without noticeably altering the spin-wave dispersion relation. In the case of the single-layer disk, an anisotropic lateral expansion of the core occurs at higher magnetic fields, which leads to a directional rather than radial-isotropic emission and propagation of waves. Micromagnetic simulations confirm these findings and further show that focusing effects occur in such systems, depending on the shape of the core and controlled by the static magnetic bias field.
ABSTRACT
In this work, we investigate the structural and dynamic magnetic properties of yttrium iron garnet (YIG) films grown onto gadolinium gallium garnet (GGG) substrates with thin platinum, iridium, and gold spacer layers. Separation of the YIG film from the GGG substrate by a metal film strongly affects the crystalline structure of YIG and its magnetic damping. Despite the presence of structural defects, however, the YIG films exhibit a clear ferromagnetic resonance response. The ability to tune the magnetic damping without substantial changes to magnetization offers attractive prospects for the design of complex spin-wave conduits. We show that the insertion of a 1-nm-thick metal layer between YIG and GGG already increases the effective damping parameter enough to efficiently absorb spin waves. This bilayer structure can therefore be utilized for magnonic waveguide termination. Investigating the dispersionless propagation of spin-wave packets, we demonstrate that a damping unit consisting of the YIG/metal bilayers can dissipate incident spin-wave signals with reflection coefficient R < 0.1 at a distance comparable to the spatial width of the wave packet.
ABSTRACT
Active control of propagating spin waves on the nanoscale is essential for beyond-CMOS magnonic computing. Here, we experimentally demonstrate reconfigurable spin-wave transport in a hybrid YIG-based material structure that operates as a Fabry-Pérot nanoresonator. The magnonic resonator is formed by a local frequency downshift of the spin-wave dispersion relation in a continuous YIG film caused by dynamic dipolar coupling to a ferromagnetic metal nanostripe. Drastic downscaling of the spin-wave wavelength within the bilayer region enables programmable control of propagating spin waves on a length scale that is only a fraction of their wavelength. Depending on the stripe width, the device structure offers full nonreciprocity, tunable spin-wave filtering, and nearly zero transmission loss at allowed frequencies. Our results provide a practical route for the implementation of low-loss YIG-based magnonic devices with controllable transport properties.
ABSTRACT
This article deals with the analysis of the relationship between the pull-off force measured by atomic force microscopy and the dimensions of water bridge condensed between a hydrophilic silicon oxide tip and a silicon oxide surface under ambient conditions. Our experiments have shown that the pull-off force increases linearly with the radius of the tip and nonmonotonically with the relative humidity (RH). The latter dependence generally consists of an initial constant part changing to a convex-concave-like increase of the pull-off force and finally followed by a concave-like decrease of this force. The reproducibility tests have demonstrated that the precision limits have to be taken into account for comparing these measurements carried out under atmospheric conditions. The results were fitted by a classical thermodynamic model based on water-bridge envelope calculations using the numerical solution of the Kelvin equation in the form of axisymmetric differential equations and consequent calculation of adhesive forces. To describe the measured data more precisely, a decrease of the water surface tension for low RH was incorporated into the calculation. Such a decrease can be expected as a consequence of the high surface curvature in the nanometer-sized water bridge between the tip and the surface.
ABSTRACT
We report on the development of a high-resolution scanning magnetometer, which fully exploits the vectorial nature of the magneto-optical Kerr effect. The three-dimensional nature of magnetization is at the basis of many micromagnetic phenomena and from these data, we can fully characterize magnetization processes of nanostructures in static and dynamic regimes. Our scanning Kerr magnetometer uses a high numerical aperture microscope objective where the incident light beam can be deterministically deviated from the objective symmetry axis, therefore, both in-plane (via the longitudinal Kerr effect) and out-of-plane (via the polar Kerr effect) components of the magnetization vector may be detected. These components are then separated by exploiting the symmetries of the polar and longitudinal Kerr effects. From four consecutive measurements, we are able to directly obtain the three orthogonal components of the magnetization vector with a resolution of 600 nm. Performance of the apparatus is demonstrated by a measurement of 3D magnetization vector maps showing out-of-plane domains and in-plane domain walls in an yttrium-iron-garnet film and on a study of magnetization reversal in a 4-µm-wide magnetic disk.