ABSTRACT
About 3 billion new tires are produced each year and about 800 million tires become waste annually. Global dependence upon tires produced from natural rubber and petroleum-based compounds represents a persistent and complex environmental problem with only partial and often-times, ineffective solutions. Tire emissions may be in the form of whole tires, tire particles, and chemical compounds, each of which is transported through various atmospheric, terrestrial, and aquatic routes in the natural and built environments. Production and use of tires generates multiple heavy metals, plastics, PAH's, and other compounds that can be toxic alone or as chemical cocktails. Used tires require storage space, are energy intensive to recycle, and generally have few post-wear uses that are not also potential sources of pollutants (e.g., crumb rubber, pavements, burning). Tire particles emitted during use are a major component of microplastics in urban runoff and a source of unique and highly potent toxic substances. Thus, tires represent a ubiquitous and complex pollutant that requires a comprehensive examination to develop effective management and remediation. We approach the issue of tire pollution holistically by examining the life cycle of tires across production, emissions, recycling, and disposal. In this paper, we synthesize recent research and data about the environmental and human health risks associated with the production, use, and disposal of tires and discuss gaps in our knowledge about fate and transport, as well as the toxicology of tire particles and chemical leachates. We examine potential management and remediation approaches for addressing exposure risks across the life cycle of tires. We consider tires as pollutants across three levels: tires in their whole state, as particulates, and as a mixture of chemical cocktails. Finally, we discuss information gaps in our understanding of tires as a pollutant and outline key questions to improve our knowledge and ability to manage and remediate tire pollution.
ABSTRACT
We experimentally acidified three low alkalinity first-order streams in forested catchments in Maine, USA. We evaluated water samples from a reference site above the point of hydrochloric acid addition and from two or three sites located 16 to 94 m downstream. Neutralization included protonation of weak acids, adsorption of sulfate, and ion exchange of base cations and aluminum (Al) for protons (H(+)). Protonation of bicarbonate was significant in the relatively high pH Hadlock Brook. Protonation of weak organic acids dominated in the high dissolved organic carbon (DOC) Mud Pond Inlet. The response in low DOC, low pH East Bear Brook was dominated by stream substrate release of cations. East Bear Brook had the strongest acid neutralization response per unit catchment area. In all streams, exchangeable calcium (Ca) and magnesium (Mg) were mobilized, with Ca>Mg. Al was also mobilized. During initial stages of acidification, Ca desorbed preferentially, whereas Al mobilization dominated later. Early in the recovery, adsorption of Ca to the streambed sediments was kinetically favored over adsorption of Al. Though pH increased downstream of acid addition, the streams remained undersaturated with respect to amorphous Al(OH)(3), so Al did not precipitate. In East Bear Brook, however, Al left solution further downstream through adsorption. This process was likely kinetically controlled, because it occurred in East Bear Brook (3-4 L/s) but did not occur in Hadlock Brook (ca. 40 L/s) or Mud Pond Inlet (ca. 60 L/s). During experimental acidification, the initial Al:Ca ratio of a stream's response may indicate the acidification status of the catchment. Short-term stream acidification experiments illuminate processes characteristic of episodic stream acidification and of long-term catchment acidification. East Bear Brook and Hadlock Brook catchments are in early to intermediate stages of acidification. The Mud Pond Inlet catchment (high Al:Ca ratio) is in a later stage of acidification.