The use of autogenous tooth bone graft is an efficient method of alveolar ridge preservation - meta-analysis and systematic review.

BACKGROUND: Ridge resorption following tooth extraction may be reduced by alveolar ridge preservation (ARP). Previous randomized clinical trials and systematic reviews have suggested that autogenous tooth bone graft (ATB) can be an effective alternative material for ARP. However, the results are heterogeneous. Therefore, our research aimed to evaluate the efficacy of ATB in ARP. METHODS: A systematic search was conducted in Cochrane Library, Embase, MEDLINE and Scopus for studies published from inception to 31 November 2021. We searched searched for randomized, non-randomized controlled trials and case series reporting on ATB use for ARP. The primary outcome was the ridge width difference pre- and post-surgery, measured in millimetres (mm) measured on CBCT (cone beam computed tomography). The secondary outcomes were the histological results. We followed the PRISMA2020 recommendations for reporting our systematic review and meta-analysis. RESULTS: The analysis included eight studies for the primary and six for the secondary outcomes. The meta-analysis revealed a positive ridge preservation effect with a pooled mean difference ridge width change of -0.72 mm. The pooled mean residual graft proportion was 11.61%, and the newly formed bone proportion was 40.23%. The pooled mean of newly formed bone proportion was higher in the group where ATB originated from both the root and crown of the tooth. CONCLUSIONS: ATB is an effective particulate graft material in ARP. Complete demineralization of the ATB tends to decrease the proportion of newly formed bone. ATB can be an attractive option for ARP. TRIAL REGISTRATION: The study protocol was registered on PROSPERO (CRD42021287890).

Clinical, radiographical and histological evaluation of alveolar ridge preservation with an autogenous tooth derived particulate graft in EDS class 3-4 defects.

BACKGROUND: The shrinkage of alveolar bone dimensions after tooth extraction is a well-known issue. This clinical phenomenon poses a challenge for clinicians aiming at implant-prosthetic treatment. BonMaker® ATB is a novel autogenous bone grafting material, produced by the mechanical and chemical processing of natural teeth. This pilot case report aims at providing a clinical, radiographical, and histological evaluation of the safety and efficacy of Bonmaker ATB powder in the treatment of EDS class 3-4 postextraction sockets with alveolar ridge preservation. METHODS: A total of 9 teeth were extracted from 5 patients. The extracted teeth were prepared immediately with the Bonmaker® device. The extraction sockets were filled up with ATB powder. Six months after extraction, standardized intraoral x-rays and CBCT scans were performed. Re-entry was performed under local anaesthesia. Core biopsies were harvested for histological analysis and implants were placed. RESULTS: Horizontal alveolar dimension loss occurred, even though ARP was performed, but the horizontal shrinkage was moderate. Vertical dimensions did not show loss of volume, but increased defect fill. Core biopsies showed ATB particles surrounded by newly formed bone and connective tissue. According to histomorphometric analysis, the harvested samples contained 56% of newly formed bone on average, and only a mean of 7% of non-remodelled ATB material was observed. CONCLUSION: The preliminary clinical, radiographical, and histological results of Bonmaker® autogenous tooth graft therapy indicate that ATB may be safely and successfully used as a grafting material for ARP. Optimal graft incorporation and histologically proven effective remodelling, as well as uneventful wound healing support the clinical application of ATB to minimize post-extraction hard tissue loss. Further research is needed to exploit the full potential of ATB and to evaluate the long-term peri-implant hard and soft tissue stability of ATB-treated post-extraction sites.

Alveolar cleft reconstruction utilizing a particulate autogenous tooth graft and a novel split-thickness papilla curtain flap - A retrospective study.

During secondary alveolar cleft grafting, the use of autogenous cancellous bone harvested from the iliac crest is still considered the gold standard. Due to the risk of donor-site morbidity and excessive graft resorption, alternative grafting materials (e.g. intraoral bone, xenografts) have been tested. Autogenous tooth bone graft (ATB) is a novel material derived from extracted teeth. ATB has successfully been used in pre-prosthetic and periodontal surgery for hard-tissue reconstruction. Seven patients with unilateral cleft lip and palate were treated with ATB, using their own deciduous teeth for grafting. Defects were accessed utilizing a novel split-thickness papilla curtain flap. Cone-beam computed tomography scans were taken prior to and 3 months following cleft surgery to assess graft integration, graft stability, and the volume of the newly formed hard tissues. Hard-tissue gain, as measured at the 3-month follow-up, averaged 0.65 cm3 ± 0.26 cm3. Results showed acceptable graft integration and stability at the 3-month follow-up, with no adverse effects or excessive resorption of the graft. The use of ATB might be a feasible alternative for alveolar cleft grafting. However, long-term studies using a large sample size are required to derive further conclusions.