ABSTRACT
We propose an asynchronous acoustic chirp slope keying to map short bit sequences on single or multiple bands without preamble or error correction coding on the physical layer. We introduce a symbol detection scheme in the demodulator that uses the superposed matched filter results of up and down chirp references to estimate the symbol timing, which removes the requirement of a preamble for symbol synchronization. Details of the implementation are disclosed and discussed, and the performance is verified in a pool measurement on laboratory scale, as well as the simulation for a channel containing Rayleigh fading and Additive White Gaussian Noise. For time-bandwidth products (TB) of 50 in single band mode, a raw data rate of 100 bit/s is simulated to achieve bit error rates (BER) below 0.001 for signal-to-noise ratios above -6 dB. In dual-band mode, for TB of 25 and a data rate of 200 bit/s, the same bit error level was achieved for signal-to-noise ratios above 0 dB. The simulated packet error rates (PER) follow the general behavior of the BER, but with a higher error probability, which increases with the length of bits in each packet.
ABSTRACT
We discuss two methods to detect the presence and location of a person in an acoustically small-scale room and compare the performances for a simulated person in distances between 1 and 2 m. The first method is Direct Intersection, which determines a coordinate point based on the intersection of spheroids defined by observed distances of high-intensity reverberations. The second method, Sonogram analysis, overlays all channels' room impulse responses to generate an intensity map for the observed environment. We demonstrate that the former method has lower computational complexity that almost halves the execution time in the best observed case, but about 7 times slower in the worst case compared to the Sonogram method while using 2.4 times less memory. Both approaches yield similar mean absolute localization errors between 0.3 and 0.9 m. The Direct Intersection method performs more precise in the best case, while the Sonogram method performs more robustly.
Subject(s)
Acoustics , Humans , UltrasonographyABSTRACT
Time difference of arrival (TDOA) based indoor ultrasound localization systems are prone to multiple disruptions and demand reliable, and resilient position accuracy during operation. In this challenging context, a missing link to evaluate the performance of such systems is a simulation approach to test their robustness in the presence of disruptions. This approach cannot only replace experiments in early phases of development but could also be used to study susceptibility, robustness, response, and recovery in case of disruptions. The paper presents a simulation framework for a TDOA-based indoor ultrasound localization system and ways to introduce different types of disruptions. This framework can be used to test the performance of TDOA-based localization algorithms in the presence of disruptions. Resilience quantification results are presented for representative disruptions. Based on these quantities, it is found that localization with arc-tangent cost function is approximately 30% more resilient than the linear cost function. The simulation approach is shown to apply to resilience engineering and can be used to increase the efficiency and quality of indoor localization methods.
Subject(s)
Algorithms , Computer Simulation , RotationABSTRACT
An acoustic transmitter can be located by having multiple static microphones. These microphones are synchronized and measure the time differences of arrival (TDoA). Usually, the positions of the microphones are assumed to be known in advance. However, in practice, this means they have to be manually measured, which is a cumbersome job and is prone to errors. In this paper, we present two novel approaches which do not require manual measurement of the receiver positions. The first method uses an inertial measurement unit (IMU), in addition to the acoustic transmitter, to estimate the positions of the receivers. By using an IMU as an additional source of information, the non-convex optimizers are less likely to fall into local minima. Consequently, the success rate is increased and measurements with large errors have less influence on the final estimation. The second method we present in this paper consists of using machine learning to learn the TDoA signatures of certain regions of the localization area. By doing this, the target can be located without knowing where the microphones are and whether the received signals are in line-of-sight or not. We use an artificial neural network and random forest classification for this purpose.