ABSTRACT
Solar-driven photothermal catalytic H2 production from lignocellulosic biomass was achieved by using 1T-2H MoS2 with tunable Lewis acidic sites as catalysts in an alkaline aqueous solution, in which the number of Lewis acidic sites derived from the exposed Mo edges of MoS2 was successfully regulated by both the formation of an edge-terminated 1T-2H phase structure and tunable layer number. Owing to the abundant Lewis acidic sites for the oxygenolysis of lignocellulosic biomass, the 1T-2H MoS2 catalyst shows high photothermal catalytic lignocellulosic biomass-to-H2 transformation performance in polar wood chips, bamboo, rice straw corncobs, and rice hull aqueous solutions, and the highest H2 generation rate and solar-to-H2 (STH) efficiency respectively achieves 3661 µmol·h-1·g-1 and 0.18% in the polar wood chip system under 300 W Xe lamp illumination. This study provides a sustainable and cost-effective method for the direct transformation of renewable lignocellulosic biomass to H2 fuel driven by solar energy.
ABSTRACT
The development of stable, Earth-abundant, and high-activity molecular water oxidation catalysts under acidic and neutral conditions remains a great challenge. Here, the use of N-heterocyclic carbene (NHC)-based iron(III) complex 1 {[phenyl(tris(3-methylimidazol-1-ylidene))borate]2Fe(III)}+ as a catalyst for water oxidation under acidic and neutral conditions was investigated. Two iron(II) carbene complexes, 2 {[2,6-bis(3-methylimidazolium-1-yl)pyridine]2Fe}2+ and 3 {[2,6-bis(3-methylimidazolium-1-yl)pyridine-4-carboxylic acid]2Fe}2+, were also used for comparison. A series of experiments demonstrate that complex 1 has excellent performance in terms of both catalytic activity and stability. In addition, the faradaic efficiency and turnover frequency (TOF) reach 95.0% and 2.8 s-1, respectively. An overpotential of ca. 490 mV is obtained at pH 1.5. Density functional theory (DFT) calculations indicate that dehydrogenation is the potential-determining step (PDS) in water oxidation. Complex 1 has a lower free energy barrier in this process than 2 and 3. High-valent Fe species are further proven in 1 by spectroelectrochemical measurements, which are crucial in promoting water oxidation. This study is expected to contribute to the development of homogeneous water oxidation catalysis under acidic and neutral conditions.
ABSTRACT
As an alternative strategy for H2 production under ambient conditions, solar-driven lignocellulose-to-H2 conversion provides a very attractive approach to store and utilize solar energy sustainably. Exploiting efficient photocatalyst for photocatalytic lignocellulose-to-H2 conversion is of huge significance and remains the key challenge for development of solar H2 generation from lignocellulose. Herein, 2D-2D MoS2 /TiO2 photocatalysts with large 2D nanojunction were constructed for photocatalytic lignocellulose-to-H2 conversion. In this smart structure, the 2D nanojunctions acted as efficient channel for charge transfer from TiO2 to MoS2 to improve charge separation efficiency and thus enhance photocatalytic lignocellulose-to-H2 conversion activity. The 2 % MoS2 /TiO2 photocatalyst showed the highest photocatalytic lignocellulose-to-H2 conversion performance with the maximal H2 generation rate of 201 and 21.4â µmol h-1 g-1 in α-cellulose and poplar wood chip aqueous solution, respectively. The apparent quantum yield at 380â nm reached 1.45 % for 2 % 2D-2D TiO2 /MoS2 photocatalyst in α-cellulose aqueous solution. This work highlights the importance of optimizing the interface structures of photocatalyst for solar-driven lignocellulose-to-H2 conversion.
ABSTRACT
Exploiting an appropriate strategy to prepare fine crystal quality black phosphorus nanosheet (BPNS) catalyst is a major challenge for its practical application in catalysis. Herein, we address this challenge by developing a rapid electrochemical expansion strategy for scale preparation of fine crystal quality BPNSs from bulk black phosphorus, which was demonstrated to be an active cocatalyst for photocatalytic nitrogen fixation in the presence of CdS as a photocatalyst. The transient photocurrent and charge density studies show that the BPNSs can efficiently accelerate charge separation of CdS, leading to the enhanced photocatalytic activities of BPNS/CdS nanocomposites for nitrogen fixation. The 1.5% BPNS/CdS photocatalyst exhibits the highest photocatalytic activity for nitrogen fixation with an NH3 evolution rate of 57.64 µmol·L-1·h-1. This study not only affords a rapid and simple strategy for scale synthesis of fine crystal quality BPNSs but also provides new insights into the design and development of black phosphorus-based materials as low-cost metal-free cocatalysts for photocatalytic nitrogen fixation.