Determination of ginsenoside content in Panax ginseng C.A. Meyer and Panax quinquefolius L. root materials and finished products by high-performance liquid chromatography with ultraviolet absorbance detection: interlaboratory study.

An interlaboratory study was conducted on an HPLC method with UV absorbance detection, previously validated using AOAC single-laboratory validation guidelines, for the determination of the six major ginsenosides (Rg1, Re, Rb1, Rc, Rb2, and Rd) in Panax ginseng C.A. Meyer and Panax quinquefolius L. root materials, extracts, and finished products. Fourteen participating laboratories analyzed five test materials (P. ginseng whole root, P. ginseng powdered extract, P. quinquefolius whole root, P. quinquefolius powdered extract, and P. ginseng powdered extract spiked in a matrix blank) as blind duplicates, and two test materials (P. ginseng powdered whole root tablet and P. quinquefolius powdered extract hard-filled capsule) as single samples. Due to the variability of the ginsenosides (low level concentration of Rb2 in P. quinquefolius raw materials and in P. ginseng spiked matrix blanks, and the possibility of incomplete hydrolysis of the finished products during processing), it was deemed more applicable to analyze total ginsenosides rather than individual ones. Outliers were evaluated and omitted using the Cochran's test and single and double Grubbs' tests. The reproducibility RSD (RSD(R)) for the blind duplicate samples ranged from 4.38 to 5.39%, with reproducibility Horwitz Ratio (HorRat(R)) values ranging from 1.5 to 1.9. For the single replicate samples, the data sets were evaluated solely by their repeatability HorRat (HorRat(r)), which were 2.9 and 3.5 for the capsule and tablet samples, respectively. Based on these results, the method is recommended for AOAC Official First Action for the determination of total ginsenosides in P. ginseng and P. quinquefolius root materials and powdered extracts.

Determination of Aloin A and Aloin B in Aloe vera Raw Materials and Finished Products by High-Performance Liquid Chromatography: Single-Laboratory Validation.

A single-laboratory validation (SLV) was conducted on an HPLC method for the detection and quantification of aloin A and aloin B in Aloe vera raw materials and finished products. An extraction procedure using sonication with an acidified solvent was used for solid test materials while liquid test materials only required dilution, if necessary, prior to filtration and analysis. Separation was achieved using a fused core C18 column in 18 min under isocratic elution conditions allowing for a single analyte (aloin A) calibration curve to quantify both aloins. Adequate chromatographic resolution (Rs ≥ 1) was achieved for aloin A and aloin B. The calibration curves for aloin A exhibited coefficients of determination (r(2)) of ≥ 99.9% over the linear range of 0.3-50 µg/mL. The LOD values were 0.092 and 0.087 µg/mL, and LOQ 0.23 and 0.21 µg/mL for aloin A and aloin B, respectively. Repeatability studies were performed on nine test materials on each of 3 separate days, with five of the test materials determined to be above the LOQ having repeatability RSD (RSDr) values ranging from 0.61 to 6.30%. Method accuracy was determined through a spike recovery study on both liquid and solid matrixes at three different levels: low, medium, and high. For both aloins, the recovery in the liquid matrix ranged from 92.7 to 106.3% with an RSDr of 0.15 to 4.30%, while for the solid matrix, the recovery ranged from 84.4 to 108.9% with an RSDr of 0.23 to 3.84%. Based on the results of the SLV study, it is recommended that this method be evaluated for reproducibility through a collaborative study.