Characteristics of sawdust, wood shavings and their mixture from different pine species as bedding materials for Hanwoo cattle.

OBJECTIVE: This study was conducted to evaluate the physicochemical properties and changes in moisture concentrations of bedding materials under the conditions of rearing Korean Hanwoo cows. METHODS: Two experiments were conducted to investigate the physicochemical characteristics (Exp. I) and usefulness as beddings for rearing cattle (Exp. II) by the type of beddings such as sawdust (SD), wood shavings (WS) and sawdust+wood shavings (S+W; 1:1 in volume), and the species of pine trees from different countries of origins (China, Pinus armandii, AR; Vietnam, Pinus kesiya, KE; USA, Pinus rigida, RI). RESULTS: In Exp. I, SD-AR showed the largest proportion (78.3%) of fine particles (250 µm+ below 250 µm) and the highest bulk density (208 kg/m3) among treatments (p<0.05). The water absorption capacity at 24 h of both S+W-RI (713%) and -KE (701%) was the highest among treatments (p<0.05) and higher than those of SD or WS alone within each species of pine tree (p<0.05). Moisture evaporation rates (%) at 12 h were ranged from 52.3 to 60.8 for SD, 69.9 to 74.4 for WS, and 72.3 to 73.5 for S+W. Total amounts (mg/m2) of ammonia emissions were the lowest (p<0.05) in KE species among the pine species within each type of bedding material, having higher ability of ammonia absorption. In Exp II, KE species in both side A and B had lower moisture concentrations (%) than other species. Regardless of types of beddings except SD-AR, moisture concentrations of beddings within a pen were higher (p<0.01) at side A than B. CONCLUSION: The KE species has better physical characteristics than other beddings and more useful for rearing Hanwoo cattle than other beddings, probably caused by the differences in the method and degree of wood processing rather than the species.

Tribological and Electrical Properties of Chromium-Doped Carbon Films Fabricated by Unbalanced Magnetron Sputtering for Medical Stents.

Chromium-doped carbon (Cr:C) films were fabricated by using unbalanced magnetron sputtering with chromium (Cr) and graphite (C) targets. We investigated the structural, tribological, and electrical properties of the Cr:C films fabricated with various target power densities. The surface of all the Cr:C films was smooth and uniform, and the cross section showed a more compact and clear columnar structure as the target power density increased. The root mean square surface roughness increased and the contact angle on the film surface increased with the increase in target power density. Furthermore, the hardness and elastic modulus of the Cr:C films showed improvements, while the resistivity decreased with the increase in target power density. These results are associated with the ion bombardment and resputtering owing to the effects of the applied target power density.

Characteristics of Sawdust and Cocopeat Beddings, and Their Usefulness According to the Fan and Pen Location for Rearing Hanwoo Cattle.

This study was designed to examine the characteristics of sawdust and cocopeat bedding materials, including physicochemical properties (Exp. I) and on-farm trial (Exp. II). In Exp. I, the proportion of particle size was in the order of sawdust> cocopeat India>cocopeat Vietnam (p<0.05), and cocopeat contained higher proportion of small particles (250 µm+below 250 µm) than sawdust, causing a dust production problem. Bulk density was cocopeat India>cocopeat Vietnam>sawdust (p<0.05), thus cocopeat treatments showed 4.4 times higher bedding cost than sawdust. The water absorption rates were 702.0% in cocopeat India, 678.3% in cocopeat Vietnam, and 444.0% in sawdust, showing cocopeat had approximately 1.5 times higher water absorption rate than sawdust. Moisture evaporation rates after 12 h of air blowing (2.00 m/s) were higher (p<0.05) in cocopeat Vietnam (80.4%) than sawdust (71.2%) and cocopeat India (72.8%). In vitro ammonia emissions were higher (p<0.05) in sawdust (2.71 mg/m(2)/h) than cocopeat India (1.59 mg/m(2)/h) and Vietnam (1.22 mg/m(2)/h), and total ammonia emissions were higher (p<0.05) in sawdust (37.02 mg/m(2)) than cocopeat India (22.51 mg/m(2)) and Vietnam (13.60 mg/m(2)). In Exp. II, an on-farm trial was conducted with 48 Hanwoo cattle in 16 pens using the same bedding materials as in Exp. I, with fan (blowing 2.00 m/s) and no fan treatments, and feed bunk side (FB) and water supply side (WS) within a pen (4.5 m, width×9.0 m, length). Beddings were replaced with fresh bedding materials when moisture concentrations were over 65%. No interactions among treatments were detected for moisture concentration and increment rates, and ammonia concentrations, but a significant effect was observed (p<0.01) for each of the treatments. Both concentrations and increment rate of moisture were higher (p<0.01) in the beddings without fan than with fan. Moisture concentrations and increment rate within a pen were also higher (p<0.01) in FB than WS. Thus, the whole no-fan-FB and sawdust-fan-FB were replaced with fresh bedding material between 4 to 5 experimental weeks. The ammonia concentrations and pH of beddings were not significantly different among treatments. Therefore, using cocopeat bedding with a blowing fan can extend twice the bedding utilization period, and WS within a pen showed twice the bedding-life compared to FB. Despite the outstanding characteristics of cocopeat compared with sawdust, using cocopeat as an alternative for sawdust bedding is not recommended for cattle management, considering it has 4.4 times higher bedding cost and a dust production problem.

Tributyrin and anise mixture supplementation improves growth performance, nutrient digestibility, jejunal villus height, and fecal microbiota in weaned pigs.

Introduction: The objective of this study was to investigate the effects of dietary supplementation of tributyrin and anise mixture (TA) on growth performance, apparent nutrient digestibility, fecal noxious gas emission, fecal score, jejunal villus height, hematology parameters, and fecal microbiota of weaned pigs. Methods: A total of 150 21-day-old crossbred weaned pigs [(Landrace × Yorkshire) × Duroc] were used in a randomized complete block design experiment. All pigs were randomly assigned to 3 groups based on the initial body weight (6.19 ± 0.29 kg). Each group had 10 replicate pens with 5 pigs (three barrows and two gilts) per pen. The experimental period was 42 days and consisted of 3 phases (phase 1, days 1-7; phase 2, days 8-21; phase 3, days 22-42). Dietary treatments were based on a corn-soybean meal-basal diet and supplemented with 0.000, 0.075, or 0.150% TA. Results and discussion: We found that dietary supplementation of graded levels of TA linearly improved body weight, body weight gain, average daily feed intake, and feed efficiency (P < 0.05). TA supplementation also had positive effects on apparent dry matter, crude protein, and energy digestibility (P < 0.05) and jejunal villus height (P < 0.05). The emission of ammonia from feces decreased linearly with the dose of TA increased (P < 0.05). Moreover, TA supplementation was capable to regulate the fecal microbiota diversity, manifesting in a linearly increased Chao1 index and observed species and a linearly decreased Pielou's index (P < 0.05). The abundance of Lactobacillus reuteri, Lactobacillus amylovorus, Clostridium butyricum were increased, while the abundance of Prevotella copri was decreased, by treatment (P < 0.05). Therefore, we speculated that TA supplementation would improve growth performance and reduce fecal ammonia emission through improving nutrient digestibility, which was attributed to the increase of jejunal villus height and the regulation of fecal microbiota.