RESUMO
Hydrothermal processes modify the chemical and mineralogical composition of rock. We studied and quantified the effects of hydrothermal processes on the composition of volcanic rocks by a novel application of the Shannon entropy, which is a measure of uncertainty and commonly applied in information theory. We show here that the Shannon entropies calculated on major elemental chemical composition data and short-wave infrared (SWIR) reflectance spectra of hydrothermally altered rocks are lower than unaltered rocks with a comparable primary composition. The lowering of the Shannon entropy indicates chemical and spectral sorting during hydrothermal alteration of rocks. The hydrothermal processes described in this study present a natural mechanism for transforming energy from heat to increased order in rock. The increased order is manifest as the increased sorting of chemical elements and SWIR absorption features of the rock, and can be measured and quantified by the Shannon entropy. The results are useful for the study of hydrothermal mineral deposits, early life environments and the effects of hydrothermal processes on rocks.
RESUMO
In this article we describe a new instrumental setup at the University of Twente Faculty ITC with an optimized processing chain to measure absolute directional-hemispherical reflectance values of typical earth science samples in the 2.5 to 16 µm range. A Bruker Vertex 70 FTIR spectrometer was chosen as the base instrument. It was modified with an external integrating sphere with a 30 mm sampling port to allow measuring large, inhomogeneous samples and quantitatively compare the laboratory results to airborne and spaceborne remote sensing data. During the processing to directional-hemispherical reflectance values, a background radiation subtraction is performed, removing the effect of radiance not reflected from the sample itself on the detector. This provides more accurate reflectance values for low-reflecting samples. Repeat measurements taken over a 20 month period on a quartz sand standard show that the repeatability of the system is very high, with a standard deviation ranging between 0.001 and 0.006 reflectance units depending on wavelength. This high level of repeatability is achieved even after replacing optical components, re-aligning mirrors and placement of sample port reducers. Absolute reflectance values of measurements taken by the instrument here presented compare very favorably to measurements of other leading laboratories taken on identical sample standards.