Transparent Carbon Ultramicroelectrode Arrays for the Electrochemical Detection of a Bacterial Warfare Toxin, Pyocyanin.

Pyocyanin is a virulence factor produced as a secondary metabolite by the opportunistic human pathogen, Pseudomonas aeruginosa. Fast and direct detection of pyocyanin is of importance as it could provide important insights regarding P. aeruginosa's virulence mechanisms. Here, we present an electrochemical sensing platform of redox-active pyocyanin using transparent carbon ultramicroelectrode arrays (T-CUAs), which were made using a previously reported simple fabrication process ( Duay et al. Anal. Chem. 2015 , 87 , 10109 ). Square-wave voltammetry was used to quantify pyocyanin concentrations on T-CUAs with and without chitosan gold nanoparticles (CS/GNP) and planar transparent macroelectrodes (T-Macro). The response time (RT), limit of detection (LOD), and linear dynamic range (LDR) differ for each electrode type due to subtle influences in how the detectable signal varies in relation to the charging time and resistive and capacitive noise. In general lower LODs can be achieved at the consequence of smaller LDRs. The LOD for T-Macro was 0.75 ± 0.09 µM with a LDR of 0.75-25 µM, and the LOD for the CS/GNP 1.54 T-CUA was determined to be 1.6 ± 0.2 µM with a LDR of 1-100 µM, respectively. The LOD for the 1.54T-CUA with a larger LDR of 1-250 µM was 1.0 ± 0.3 µM. These LODs and LDRs fall within the range of PYO concentrations for a variety of in vitro and in vivo cellular environments and offer promise of the application of T-CUAs for the quantitative study of biotoxins, quorum sensing, and pathogenesis. Finally, we demonstrate the successful use of T-CUAs for the electrochemical detection of pyocyanin secreted from P. aeruginosa strains while optically imaging the cells. The secreted pyocyanin levels from two bacterial strains, PA11 and PA14, were measured to have concentrations of 45 ± 5 and 3 ± 2 µM, respectively.

Gold Nanoparticle Modified Transparent Carbon Ultramicroelectrode Arrays for the Selective and Sensitive Electroanalytical Detection of Nitric Oxide.

Transparent carbon ultramicroelectrode arrays (T-CUAs) were made using a previously reported facile fabrication method (Duay et al. Anal. Chem. 2015, 87, 10109). Two modifications introduced to the T-CUAs were examined for their analytical response to nitric oxide (NO•). The first modification was the application of a cellulose acetate (CA) gas permeable membrane. Its selectivity to NO• was extensively characterized via chronoamperometry, electrochemical impedance spectroscopy (EIS), and atomic force microscopy (AFM). The thickness of the CA membrane was determined to be 100 nm and 88 ± 15 nm using AFM and EIS, respectively. Furthermore, the partition and diffusion coefficients of NO• within the CA membrane were determined to be 0.0500 and 2.44 × 10-13 m2/s using EIS measurements. The second modification to the 1.54T-CUA was the introduction of chitosan and gold nanoparticles (CS/GNPs) to enhance its catalytic activity, sensitivity, and limit of detection (LOD) to NO•. Square wave voltammetry was used to quantify the NO• concentration at the CA membrane covered 1.54T-CUA with and without CS/GNPs; the LODs were determined to be 0.2 ± 0.1 and 0.44 ± 0.02 µM (S/N = 3), with sensitivities of 9 ± 9 and 1.2 ± 0.4 nA/µM, respectively. Our results indicate that this modification to the arrays results in a significant catalytic enhancement to the electrochemical oxidation of NO•. Hence, these electrodes allow for the in situ mechanistic and kinetic characterization of electrochemical reactions with high electroanalytical sensitivity.

Transparent carbon ultramicroelectrode arrays: figures of merit for quantitative spectroelectrochemistry for biogenic analysis of reactive oxygen species.

Opaque and transparent carbon ultramicro- to nanoelectrode arrays were made using a previously reported facile versatile fabrication method (Duay et al. Anal. Chem. 2014, 86, 11528). First, opaque carbon ultramicroelectrode arrays (CUAs) were characterized for their analytical response to hydrogen peroxide (H2O2) oxidation using cyclic voltammetry. The alumina blocking layer was found to contribute to the noise and thus had undesirable effects on the array's limit of detection (LOD) for H2O2 at fast scan rates. Nonetheless, at slower scan rates (ν ≤ 250 mV s(-1)), the LODs for H2O2 for both opaque (O-CUAs) and transparent arrays (T-CUAs) were found to be lower than previously reported levels for array-based UMEs. LODs as low as 35 nM H2O2 are obtained for T-CUA at a 2.5 mV s(-1) scan rate. Furthermore, the transparent arrays were analyzed for their spectroelectrochemical response during the oxidation/reduction of ferrocenemethanol. Results showed very good correlation between the optical and electrochemical response for ferrocenemethanol at a UV wavelength of 254 nm. Thus, these electrodes allow for the in situ mechanistic and kinetic characterization of heterogeneous electrochemical and intermediate homogeneous chemical reactions with high electroanalytical sensitivity, low detection limits, and wide dynamic range.