RESUMO
Poly(1,4-phenylene-ethynylene)-alt-poly(1,4-phenylene-vinylene) (PPE-PPV) copolymers have attracted quite a lot of attention in the last few years for electronic device applications owing to their enhanced fluorescence. In this work, we focus on one particular PPE-PPV copolymer with dissymmetrically substituted 1,4-phenylene-ethynylene and symmetrically substituted 1,4-phenylene-vinylene building units. Six successively performed cyclic voltammograms are presented, measured during the oxidation reactions. As the oxidation onset of the electrochemical reaction shifts to lower potentials in each cycle, this behavior is elucidated by using spectroscopic techniques ranging from UV/Vis/near-IR to mid-IR including spin-resonance techniques. Hence, these findings help to explain some of the copolymer's most advantageous properties in terms of possible oxidation products.
RESUMO
In this work, we focus on the formation of different kinds of charge carriers such as polarons and bipolarons upon p-type doping (oxidation) of the organic semiconductor poly(3- hexylthiophene-2,5-diyl) (P3HT). We elucidate the cyclic voltammogram during oxidation of this polymer and present spectroscopic changes upon doping in the UV/Vis/near-IR range as well as in the mid-IR range. In the low-oxidation regime, two absorption bands related to sub-gap transitions appear, one in the UV/Vis range and another one in the mid-IR range. The UV/Vis absorption gradually decreases upon further doping while the mid-IR absorption shifts to lower energy. Additionally, electron paramagnetic resonance (EPR) measurements are performed, showing an increase of the EPR signal up to a certain doping level, which significantly decreases upon further doping. Furthermore, the absorption spectra in the UV/Vis range are analyzed in relation to the morphology (crystalline vs. amorphous) by using theoretical models. Finally, the calculated charge carriers from cyclic voltammogram are linked together with optical transitions as well as with the EPR signals upon p-type doping. We stress that our results indicate the formation of polarons at low doping levels and the existence of bipolarons at high doping levels. The presented spectroscopic data are an experimental evidence of the formation of bipolarons in P3HT.
RESUMO
Spectroscopic measurements in the infrared range combined with electrochemistry are a powerful technique for investigation of organic semiconductors to track changes during oxidation and reduction (p- and n-doping) processes. For these measurements it is important that the studied material, mostly deposited as a thin film on an internal reflection element, does not dissolve during this characterization. In this study we introduce a technique that allows infrared spectroelectrochemical characterization of films of these materials for the first time. In many cases so far this has been impossible, due to solubility in the oxidized and/or reduced form. This novel technique is shown on thin films of quinacridone by adding a protection layer of poly(vinyl alcohol) (PVA).
RESUMO
The synthesis and characterization of a set of conjugated polymers, poly(1,4-phenylene-ethynylene)-alt-poly(1,4-phenylene-vinylene)s (PPE-PPVs), with a dissymmetrical configuration (partial or total) of alkoxy side chains is reported. Five new polymers bearing octyloxy and/or octadecyloxy side chains at the phenylene-ethynylene and phenylene-vinylene segments, respectively, were obtained. Two symmetrical substituted polymers were used for comparison. Polymers with weight-average molecular weight, Mw, up to 430â¯000 g/mol and degree of polymerization between 17 and 322 were obtained by a Horner-Wadsworth-Emmons olefination polycondensation reaction of the respective luminophoric dialdehydes and bisphosphonates. As expected, identical conjugated backbones in all polymers results in very similar photophysical response in dilute solution, with high fluorescence quantum yields between 50% and 80%. In contrast, the thin film properties are dependent on the combinatorial effects of side chain configuration, molecular weight, and film thickness parameters, which are the basis of the resulting comparison and discussion.
RESUMO
Lead sulfide quantum dots represent an emerging photovoltaic absorber material. While their associated optical qualities are true for the colloidal solution phase, they change upon processing into thin-films. A detailed view to the optical key-parameters during solid-film development is presented and the limits and outlooks for this versatile and promising absorber are discussed.