Effect of ionizing radiation on antioxidant compounds present in cork wastewater.

A preliminary study of the gamma radiation effects on the antioxidant compounds present in cork cooking water was carried out. Radiation studies were performed using radiation between 20 and 50 kGy at 0.4 and 2.4 kGy h(-1). The radiation effects on organic matter content were evaluated by chemical oxygen demand. The antioxidant activity was measured by ferric reducing power assay. The total phenolic content was studied using the Folin-Ciocalteau method. Results show that gamma radiation increases both the amount of phenolic compounds and antioxidant capacity of cork cooking water. These results highlight the potential of this technology for increasing the added value of cork waters.

Molecular mobility of nematic E7 confined to molecular sieves with a low filling degree.

The nematic liquid crystalline mixture E7 was confined with similar filling degrees to molecular sieves with constant composition but different pore diameters (from 2.8 to 6.8 nm). Fourier transform infrared analysis proved that the E7 molecules interact via the cyanogroup with the pore walls of the molecular sieves. The molecular dynamics of the system was investigated by broadband dielectric spectroscopy (10(-2)-10(9) Hz) covering a wide temperature range of approximately 200 K from temperatures well above the isotropic-nematic transition down to the glass transition of bulk E7. A variety of relaxation processes is observed including two modes that are located close to the bulk behavior in its temperature dependence. For all confined samples, two relaxation processes, at frequencies lower than the processes observed for the bulk, were detected. At lower temperatures, their relaxation rates have different temperature dependencies whereas at higher temperatures, they seem to collapse into one chart. The temperature dependence of the slowest process (S-process) obeys the Vogel-Fulcher-Tammann law indicating a glassy dynamics of the E7 molecules anchored to the pore surface. The pore size dependence of both the Vogel temperature and fragility revealed a steplike transition around 4 nm pore size, which indicates a transition from a strong to a fragile behavior. The process with a relaxation rate in between the bulklike and the S-process (I-process) shows no dependence on the pore size. The agreement of the I-process with the behavior of a 5CB surface layer adsorbed on nonporous silica leads to the assignment of E7 molecules anchored at the outer surface of the microcrystals of the molecular sieves.

Adsorption of a reactive dye on chemically modified activated carbons--influence of pH.

The surface chemistry of a commercial activated carbon with a slightly basic nature was modified by appropriate treatments in order to obtain two additional samples, respectively with acidic and basic properties, without changing its textural parameters significantly. Different techniques (N2 adsorption at 77 K, temperature programmed desorption, and determination of acidity, basicity, and pH at the point of zero charge) were used to characterize the adsorbents. Kinetic and equilibrium adsorption data of a selected textile reactive dye (Rifafix Red 3BN, C.I. reactive red 241) on the mentioned materials were obtained at the pH values of 2, 7, and 12. The kinetic curves are fitted using the second-order model. The respective rate constants seem to diminish progressively with the initial concentration for the more diluted solutions tested, reaching a constant value at higher concentrations, which depends on the experimental system under consideration (adsorbent and pH). In general, the Langmuir model provides the best fit for the equilibrium data. The different uptakes obtained are discussed in relation to the surface chemical properties of the adsorbents. It is shown that the adsorption of the reactive (anionic) dye on the basic sample (prepared by thermal treatment under H2 flow at 700 degrees C) is favored. This conclusion is explained on the basis of the dispersive and electrostatic interactions involved. Moreover, it is also shown that the optimal adsorption condition for all the activated carbons tested corresponds to solution pH values not higher than the pH(pzc) of the adsorbents, which may be interpreted by taking into account the electrostatic forces present.

Hydrolysis of sucrose using sulfonated poly(vinyl alcohol) as catalyst.

The hydrolysis of sucrose was carried out over poly(vinyl alcohol) (PVA) with sulfonic acid groups, at 80 degrees C. The products of sucrose hydrolysis were glucose and fructose. A series of PVA with different crosslinking degree were prepared. It was observed that the catalytic activity of PVA matrix increases with the crosslinking degree, due to the increases of the amount of sulfonic acid groups on PVA. Further, the influence of various reaction parameters, such as, catalyst loading, initial concentration of sucrose and temperature, on the hydrolysis of sucrose over PVA_40 was studied. It was found that at 80 degrees C, with 0.511 g of catalyst loading and with an initial concentration of sucrose of 0.6M, a sucrose conversion of about 90%, after 3h, could be obtained. The PVA_40 catalyst was recycled and reused with negligible loss in the activity. A simple kinetic model was developed assuming that the sucrose hydrolysis is an irreversible reaction and the first order with respect to the sucrose concentration. Since the concentration profiles of the reactant and the products do not exhibit any pronounced initial inductive period, the external and internal diffusion of the reactant and products on the catalyst were not considered. It was observed that the kinetic model fits experimental concentration data quite well.