Broadband ultraviolet plasmonic enhanced AlGaN/GaN heterojunction photodetectors with close-packed Al nanoparticle arrays.

Plasmonic metallic nanostructures could concentrate optical fields into nanoscale volumes and support efficient light scattering and absorption, which therefore stimulates the continuing development of advanced plasmonic-assisted semiconductor photodetectors. In this work, by fabricating Al nanoparticle (NP) arrays in AlGaN surface using the AAO template transferring method, significant broadband ultraviolet (UV) photoresponse enhancement was demonstrated on AlGaN/GaN heterojunction photodetectors. By deliberately designing the close-packed Al NP arrays, the broadband UV plasmonic resonance with large optical field absorption and strong interface field enhancement are enabled, hence, the highest responsivity exceeding 8.1 A W-1 and maximum external quantum efficiency of 3500% was obtained at the resonance wavelength 292 nm, revealing more than 80 times the excellent enhancement in responsivity. Specifically, owing to coupling among NPs at the Al/AlGaN interface, the smaller size Al NP array exhibits an excellent photoresponse enhancement encompassing the entire UV band compared to the relatively larger size Al NP array. In addition, different photoresponse enhancements depending on the applied bias were observed. The Al NPs detector also demonstrates a fast photoresponse with a rise time of around 60 ms and a relatively long fall time of 1.42 s. This work could be of great significance for gaining a low and efficient approach to achieve plasmonic-empowered heterojunction broadband UV detectors.

Coexistence of Photoelectric Conversion and Storage in van der Waals Heterojunctions.

Van der Waals (vdW) heterojunctions, based on two-dimensional (2D) materials, have great potential for the development of ecofriendly and high-efficiency nanodevices, which shows valuable applications as photovoltaic cells, photodetectors, etc. However, the coexistence of photoelectric conversion and storage in a single device has not been achieved until now. Here, we demonstrate a simple strategy to construct a vdW p-n junction between a WSe_{2} layer and quasi-2D electron gas. After an optical illumination, the device stores the light-generated carriers for up to seven days, and then releases a very large photocurrent of 2.9 mA with bias voltage applied in darkness; this is referred to as chargeable photoconductivity (CPC), which completely differs from any previously observed photoelectric phenomenon. In normal photoconductivity, the recombination of electron-hole pairs occurs at the end of their lifetime; in contrast, infinite-lifetime photocarriers can be generated and stored in CPC devices without recombination. The photoelectric conversion and storage are completely self-excited during the charging process. The ratio between currents in full- and empty-photocarrier states below the critical temperature reaches as high as 10^{9}, with an external quantum efficiency of 93.8% during optical charging. A theoretical model developed to explain the mechanism of this effect is in good agreement with the experimental data. This work paves a path toward the high-efficiency devices for photoelectric conversion and storage.

AlGaN-based Schottky barrier deep ultraviolet photodetector grown on Si substrate.

This letter reports the influence of material quality and device processing on the performance of AlGaN-based Schottky barrier deep ultraviolet photodetectors grown on Si substrates. The thermal annealing can significantly improve Schottky barrier height and wet chemical etching can effectively remove etching damage. Meanwhile, the decrease of threading dislocation density and the pit size, especially the later, can substantially suppress reverse leakage. As a result, the reverse leakage current density of the as-fabricated deep UV photodetector was reduced down to 3×10-8 A/cm2. Furthermore, the responsivity of the deep UV photodetectors was greatly improved by reducing the point defect concentration.

Performance improvement of InGaN-based laser grown on Si by suppressing point defects.

High performance InGaN-based laser diodes (LDs) monolithically grown on Si is fundamentally interesting and highly desirable for photonics integration on Si platform. Suppression of point defects is of crucial importance to improve the device performance of InGaN-based LDs grown on Si. This work presents a detailed study on the impact of point defects, such as carbon (C) impurities and gallium vacancies (VGa), on the device characteristics of InGaN-based LDs grown on Si. By suppressing the VGa-related defect within the waveguide layers, reducing the thermal degradation of InGaN-based quantum wells, and controlling the C impurity concentrations within the thick p-type cladding layers, the as-fabricated InGaN-based LDs grown on Si exhibited a significantly reduced threshold current density of 2.25 kA/cm2 and an operation voltage of 4.7 V.

Plasma Surface Treatment and Application of Polyvinyl Alcohol/Polylactic Acid Electrospun Fibrous Hemostatic Membrane.

In this study, an improved PVA/PLA fibrous hemostatic membrane was prepared by electrospinning technology combined with air plasma modification. The plasma treatment was used to modify PLA to enhance the interlayer bonding between the PVA and PLA fibrous membranes first, then modify the PVA to improve the hemostatic capacity. The surfaces of the PLA and PVA were oxidized after air plasma treatment, the fibrous diameter was reduced, and roughness was increased. Plasma treatment enhanced the interfacial bond strength of PLA/PVA composite fibrous membrane, and PLA acted as a good mechanical support. Plasma-treated PVA/PLA composite membranes showed an increasing liquid-enrichment capacity of 350% and shortened the coagulation time to 258 s. The hemostatic model of the liver showed that the hemostatic ability of plasma-treated PVA/PLA composite membranes was enhanced by 79% compared to untreated PVA membranes, with a slight improvement over commercially available collagen. The results showed that the plasma-treated PVA/PLA fibers were able to achieve more effective hemostasis, which provides a new strategy for improving the hemostatic performance of hemostatic materials.

Manipulation of Temperature-Dependent Luminescence Behaviors of Mn4+-Activated Fluoride Phosphors.

In this paper, the giant tunability of thermal behaviors, i.e., from thermal deterioration to substantial growth, is firmly demonstrated for the vibronic luminescence of Mn4+ ions in fluoride phosphors. Such peculiar behavior is uncovered to be associated with the thermal excitation of a low-frequency phonon bath, and a theoretical model involving the excitation-wavelength-dependent populations of vibronic levels and the temperature-dependent nonradiative recombination processes is successfully constructed. Two main governing parameters, namely, the thermal activation energy Ea and the involved average phonon energy ΔE, are thus determined for the distinct thermal behaviors of Mn4+-ion luminescence. This demonstration may pave the way for manipulating the thermal behaviors of vibronic luminescence in solids to some extent.

Investigation of Localized States in GaAsSb Epilayers Grown by Molecular Beam Epitaxy.

We report the carrier dynamics in GaAsSb ternary alloy grown by molecular beam epitaxy through comprehensive spectroscopic characterization over a wide temperature range. A detailed analysis of the experimental data reveals a complex carrier relaxation process involving both localized and delocalized states. At low temperature, the localized degree shows linear relationship with the increase of Sb component. The existence of localized states is also confirmed by the temperature dependence of peak position and band width of the emission. At temperature higher than 60 K, emissions related to localized states are quenched while the band to band transition dominates the whole spectrum. This study indicates that the localized states are related to the Sb component in the GaAsSb alloy, while it leads to the poor crystal quality of the material, and the application of GaAsSb alloy would be limited by this deterioration.