RESUMO
Background: Rupture of the common calcaneal tendon is the second most frequent tendon rupture in dogs and may lead to severe lameness and pain. Surgical repair consists of re-apposition of the damaged tendon ends using sutures, but this type of repair is not always possible especially if the tendon has retracted. Tendon augmentation with an ultra-high molecular weight polyethylene (UHMWPE) implant is a recent solution to support the sutures and allow the repair of the canine calcaneal tendon. However, its biomechanical fixation strength remains untested for this pathology. Aim: To evaluate the biomechanical fixation strength of a UHMWPE implant for the repair of the canine calcaneal tendon. Methods: Ex-vivo biomechanical study was carried out on eight cadaveric hindlimbs from four adult dogs. Hindlimbs were tested under two independent modalities: proximal tendinous fixation (PTF) and distal calcaneus fixation (DCF), using a testing machine. PTF was achieved by eight simple interrupted polypropylene sutures performed through the UHMWPE implant. The latter was sandwiched inside the gastrocnemius tendon, which had previously been incised over about 5 cm longitudinally, and through the tendon of the superficial digital flexor. DCF was performed using an interference screw, which locked the UHMWPE implant into a calcaneus tunnel drilled perpendicularly. Results: Yield, failure load, and linear stiffness (mean ± SD) for the DCF modality were 920 ± 139 N, 1,007 ± 146 N, and 92 ± 15.21, respectively, which were greater than for the PTF modality (663 ± 92 N, 685 ± 84 N and 25.71 ± 5.74, respectively, p < 0.05). Failure modes were different between fixation modalities: for PTF it was suture breakage (n = 7/8), while for DCF it was implant damage and slippage (n = 8/8). Conclusion: The biomechanical fixation strength of the UHMWPE implant was greater for DCF than that of PTF, and should be suitable for calcaneal tendon repair in dogs. The clinical prediction of rupture of this calcaneal tendon repair will occur at the level of the PTF.
Assuntos
Tendão do Calcâneo , Canidae , Doenças do Cão , Traumatismos dos Tendões , Cães , Animais , Tendão do Calcâneo/cirurgia , Traumatismos dos Tendões/cirurgia , Traumatismos dos Tendões/veterinária , Suturas/veterinária , Parafusos Ósseos/veterináriaRESUMO
Background: As isolated ruptures of the caudal cruciate ligament (CdCL) are rare in dogs, there is no consensus on the indications and the gold-standard surgical technique for treatment. Case Description: A 2-year-old Shepherd dog with an isolated rupture of the CdCL was treated with a new surgical technique for synthetic reconstruction. Three bone tunnels were drilled in the femur and the tibia under arthroscopic guidance to make sure the anatomical insertions of the physiological ligament were respected. An ultra-high molecular weight polyethylene (UHMWPE) implant was fixed with interference screws to reconstruct the CdCL. A synovial inflammation remained present on radiographs for 6 months after the surgery, together with a mild lameness. However, the dog fully recovered clinically and recovered a normal level of activity after 6 months. Liverpool osteoarthritis in dogs questionnaire results at 6 months and 1 year postoperatively were excellent. Conclusion: The use of a UHMWPE implant fixed with interference screws to reconstruct the CdCL allowed a return to full function of the knee without complications, despite a persistent synovial inflammation and mild lameness for a 6-month period after the surgery. The success of this isolated surgical technique could lead to improvements in the surgical management of CdCL rupture, if these initial results are confirmed by a prospective study with a larger number of patients.
Assuntos
Doenças do Cão , Coxeadura Animal , Cães , Animais , Estudos Prospectivos , Ligamentos , Inflamação/veterinária , Doenças do Cão/cirurgiaRESUMO
Traumatic vertebral fracture or luxation often results in spinal instability requiring surgical stabilization. This study describes the long-term outcome of spinal stabilization using a unilateral 5-hole 2-0 UniLock implant in eight dogs and two cats with trauma-induced thoracolumbar vertebral luxation/subluxation and presumed instability, as assessed by a combination of preoperative radiographs and MRI using a 3-compartment method. The UniLock plate was secured with four monocortical locking screws in adjacent vertebral bodies. Additional pins and facet screws were used in several patients. Postoperative radiographs and MRI studies showed restoration of the main spinal axis in all patients and satisfactory implantation of the screws in the vertebral bodies, with no intrusion in the vertebral canal or in the adjacent intervertebral disc spaces. Neurological status improved in nine patients six weeks postoperatively. Partial implant failure was detected in three patients with no long-term consequences. After 12 months, seven patients reached full recovery with no neurological deficit, two patients were euthanized (including one owing to an unrelated condition), and one remained paraparetic. The results of this study demonstrate that using a 2-0 UniLock implant to stabilize the thoracolumbar spine results in satisfactory long-term recovery in most dogs and cats with traumatic spinal luxation/subluxation and presumed instability. Complications may occur but do not require revision surgery and do not affect clinical outcomes.
RESUMO
OBJECTIVES: The aim of our study was to describe a biomechanical testing protocol to reproduce ex vivo craniodorsal hip luxation specific to the feline model, and evaluate the biomechanical properties of an intact hip joint compared with the fixation strength of two different techniques of extra-articular hip stabilisation. METHODS: Eighteen hip joints (femur and hemipelvis) were harvested from nine mature feline cadavers. CT was performed for each hip joint so that a biomechanical base specific to each joint morphotype could be created using computer-aided design. The biomechanical bases were then produced using a three-dimensional printer to secure the hip joints during testing. A total of 34 biomechanical compression tests were performed. Eighteen compression tests were performed in the control group, of which two fractured. The remaining 16 hip joints were then randomly assigned either to group A (hip joints stabilised with an extra-articular ultra-high molecular weight polyethylene (UHMWPE) implant secured by an interference screw [n = 8]) or to group B (hip joints stabilised with a UHMWPE iliofemoral suture [n = 8]). RESULTS: Mean ± SD yield, failure load and linear stiffness in the control group were 616 ± 168 N, 666 ± 158 N and 231 ± 50 N/mm, respectively. The relative fixation strength (% of intact joint) before hip luxation in groups A and B was 43.8% and 34.7%, respectively. No statistical difference was found between groups A and B for yield and failure load. However, the reoccurrence of craniodorsal hip luxation was higher in group B than in group A, in 5/8 and 0/8 tests, respectively. Moreover, in group A, the extra-articular UHMWPE implant induced caudodorsal hip luxation, reported as failure mode in 7/8 cases. CONCLUSIONS AND RELEVANCE: This modified biomechanical protocol for testing craniodorsal hip luxation in a feline model was validated as repeatable and with acceptable variance. The extra-articular UHMWPE implant stabilisation technique proved to be more efficient in avoiding reoccurrence of craniodorsal hip luxation than UHMWPE iliofemoral suture.
Assuntos
Doenças do Gato , Luxações Articulares , Animais , Fenômenos Biomecânicos , Parafusos Ósseos , Cadáver , Gatos , Luxações Articulares/veterinária , Polietilenos , SuturasRESUMO
Background: Tibiotarsal instabilities caused by partial or complete rupture of the medial collateral tarsal ligament (MCTL) are commonly treated by arthrodesis techniques with poor functional results and significant complication rates. Case Description: This study describes a new surgical technique for synthetic reconstruction of the MCTL in an overweight dog (estimated body condition score 8/9) with an avulsion of the long head of the MCTL. Three bone tunnels were drilled in the distal tibia, the talus, and the central tarsal bone, thus respecting the anatomical insertions of the physiological ligament. An Ultra-High Molecular Weight Polyethylene (UHMWPE) implant was fixed with interference screws to reconstruct the long and short heads of the MCTL. Premature weight-bearing was reported at 2 weeks postoperatively following early removal of the flexible restraint (bivalve resin boot), which had initially been prescribed for 6 weeks. At 11 weeks postoperatively, the tibiotarsal joint showed good valgus stability and the dog's gait was subnormal. At 12 and 16 months postoperatively, the dog regained full function of the operated limb although no weight loss was initiated as recommended. Conclusion: The use of a UHMWPE implant fixed with interference screws to reconstruct the MCTL allowed a return to full function of the tibiotarsal joint, without complications despite an early return to weight-bearing without external restraint. The success of this isolated surgical technique could lead to improvements in the surgical management of MCTL rupture if these initial results are confirmed by a prospective study with a larger number of patients.
Assuntos
Ligamentos , Tíbia , Animais , Cães , Estudos ProspectivosRESUMO
Background: Cranial cruciate ligament rupture (CCLr) is the most common cause of hind limb lameness in dogs. Currently, surgical management of CCLr is mostly performed using tibial osteotomy techniques to modify the biomechanical conformation of the affected stifle. These surgical techniques have a significant complication rate, associated with persistent instability of the stifle which may lead to chronic postoperative pain. Over the last decade, studies have been published on various techniques of anatomical caudal cruciate ligament reconstruction in veterinary practice, using physiological autografts or woven synthetic implants. Aim: The aim of this ex vivo biomechanical study is to investigate the ex vivo dynamic biomechanical behavior of a synthetic implant [ultrahigh molecular weight polyethylene (UHMWPE) implant] fixed with interference screws for the treatment of CCLr in dogs, according to a fatigue protocol (48 hours per test). Methods: Seven stifles from four skeletally mature canine cadavers were implanted with the synthetic implant. It was fixed with four interference screws inserted in transversal and oblique tunnels in both the distal femur and the proximal tibia. For each case, 100,000 cycles were performed at 0.58 Hz, with traction loads ranging from 100 to 210 N. Results: Neither screw-bone assembly rupture nor a pull-out issue was observed during the dynamic tests. Linear stiffness of the implants associated with a fixation system with four interference screws increased over time. The final displacement did not exceed 3 mm for five of the seven specimens. Five of the seven synthetic implants yielded to a lengthening in functional range (0-3 mm). Linear stiffness was homogeneous among samples, showing a strong dynamic strength of the interference screw-based fixations of the UHMWPE implant in the femoral and tibial bones. Conclusion: This study completes the existing literature on the biomechanical evaluation of passive stifle stabilization techniques with a testing protocol focused on cyclic loading at a given force level instead of driven by displacement. These biomechanical results should revive interest in intra-articular reconstruction after rupture of the CCLr in dogs.
Assuntos
Lesões do Ligamento Cruzado Anterior , Doenças do Cão , Animais , Ligamento Cruzado Anterior/cirurgia , Lesões do Ligamento Cruzado Anterior/cirurgia , Lesões do Ligamento Cruzado Anterior/veterinária , Fenômenos Biomecânicos , Parafusos Ósseos/veterinária , Cães , Joelho de Quadrúpedes/cirurgiaRESUMO
Patient-specific finite element models (PSFEM) are becoming more and more used. Different methods for assigning their material properties were studied on PSFEMs of 9 tibias along with the minimal required length of the CT acquisition window. Material properties are generally attributed to the PSFEM using relationships linking the grayscale of CT scans to the elasticity moduli. Using cortical-specific and trabecular-specific relationships or a generic one, did not result in significant differences. However, the use of homogeneous elastic moduli in the cortical and trabecular regions led to considerable differences. The result highlight that the PSFEM must comprise at least 40% of the tibia to ensure consistent results in the proximal 20%.
Assuntos
Teste de Materiais , Modelos Biológicos , Adulto , Idoso , Idoso de 80 Anos ou mais , Módulo de Elasticidade , Feminino , Análise de Elementos Finitos , Humanos , Modelos Lineares , Masculino , Pessoa de Meia-Idade , Estresse Mecânico , Tomografia Computadorizada por Raios X , Adulto JovemRESUMO
Surgical management of tendon rupture is challenging. One concern is to provide adequate tensile strength to prevent distraction during weight-bearing and gap formation following repair, associated with an increased risk of repair failure. Additional challenges may arise from the nature or the chronicity of the lesion. In the event of avulsion, when the tendon is torn off at the bone insertion, its reinsertion on the bone is generally difficult and may even be impossible in the presence of an avulsion fracture, especially when the bone fragment is too small or fragmented. Repair management is also complicated in chronic cases, as degeneration of the tendon may lead to excessive scar tissue formation, tendon retraction, and muscle atrophy, resulting in a large gap and inadequate tissue for reconstruction. The authors describe the surgical procedure for implanting a novel implant, illustrated by three characteristic clinical cases: (1) an acute Achilles tendon avulsion; (2) a chronic patellar tendon rupture; and (3) a chronic avulsion fracture of the triceps tendon. In these three cases, complete recovery of the function was observed at the last clinical evaluation (6 or 8 months), and no complication was noted. A splinted dressing (6 to 8 weeks) was used successfully in two cases. A resin cast (8 weeks) was preferred in case 1, a very active dog. In conclusion, this novel implant represents a simple procedure for the effective repair of chronic tendon rupture, as well as an effective tendon reinsertion on the bone and adequate support for bone tendon healing in the treatment of tendon avulsion, even in cases of fragmented bone fracture. The thinness of the implant facilitates its insertion into the native tendon, while the bone-screw-implant interface provides immediate and lasting mechanical support. This may facilitate the healing process and potentially shorten the period of immobilization.