Ultrafast electron radiography of magnetic fields in high-intensity laser-solid interactions.

Using electron bunches generated by laser wakefield acceleration as a probe, the temporal evolution of magnetic fields generated by a 4 × 10(19) W/cm(2) ultrashort (30 fs) laser pulse focused on solid density targets is studied experimentally. Magnetic field strengths of order B(0) ~ 10(4) T are observed expanding at close to the speed of light from the interaction point of a high-contrast laser pulse with a 10-µm-thick aluminum foil to a maximum diameter of ~1 mm. The field dynamics are shown to agree with particle-in-cell simulations.

Predictive capability of material screening by fast neutron activation analysis using laser-driven neutron sources.

Bright, short-pulsed neutron beams from laser-driven neutron sources (LANSs) provide a new perspective on material screening via fast neutron activation analysis (FNAA). FNAA is a nondestructive technique for determining material elemental composition based on nuclear excitation by fast neutron bombardment and subsequent spectral analysis of prompt γ-rays emitted by the active nuclei. Our recent experiments and simulations have shown that activation analysis can be used in practice with modest neutron fluences on the order of 105 n/cm2, which is available with current laser technology. In addition, time-resolved γ-ray measurements combined with picosecond neutron probes from LANSs are effective in mitigating the issue of spectral interference between elements, enabling highly accurate screening of complex samples containing many elements. This paper describes the predictive capability of LANS-based activation analysis based on experimental demonstrations and spectral calculations with Monte Carlo simulations.

Luminous, relativistic, directional electron bunches from an intense laser driven grating plasma.

Bright, energetic, and directional electron bunches are generated through efficient energy transfer of relativistic intense (~ 1019 W/cm2), 30 femtosecond, 800 nm high contrast laser pulses to grating targets (500 lines/mm and 1000 lines/mm), under surface plasmon resonance (SPR) conditions. Bi-directional relativistic electron bunches (at 40° and 150°) are observed exiting from the 500 lines/mm grating target at the SPR conditions. The surface plasmon excited grating target enhances the electron flux and temperature by factor of 6.0 and 3.6, respectively, compared to that of the plane substrate. Particle-in-Cell simulations indicate that fast electrons are emitted in different directions at different stages of the laser interaction, which are related to the resultant surface magnetic field evolution. This study suggests that the SPR mechanism can be used to generate multiple, bright, ultrafast relativistic electron bunches for a variety of applications.

Robustness of large-area suspended graphene under interaction with intense laser.

Graphene is known as an atomically thin, transparent, highly electrically and thermally conductive, light-weight, and the strongest 2D material. We investigate disruptive application of graphene as a target of laser-driven ion acceleration. We develop large-area suspended graphene (LSG) and by transferring graphene layer by layer we control the thickness with precision down to a single atomic layer. Direct irradiations of the LSG targets generate MeV protons and carbons from sub-relativistic to relativistic laser intensities from low contrast to high contrast conditions without plasma mirror, evidently showing the durability of graphene.

Energetic α-particle sources produced through proton-boron reactions by high-energy high-intensity laser beams.

In an experiment performed with a high-intensity and high-energy laser system, α-particle production in proton-boron reaction by using a laser-driven proton beam was measured. α particles were observed from the front and also from the rear side, even after a 2-mm-thick boron target. The data obtained in this experiment have been analyzed using a sequence of numerical simulations. The simulations clarify the mechanisms of α-particle production and transport through the boron targets. α-particle energies observed in the experiment and in the simulation reach 10-20 MeV through energy transfer from 20-30 MeV energy incident protons. Despite the lower cross sections for protons with energy above the sub-MeV resonances in the proton-boron reactions, 10^{8}-10^{9}α particles per steradian have been detected.

A ten-inch manipulator (TIM) based fast-electron spectrometer with multiple viewing angles (OU-ESM).

The measurement of angularly resolved energy distributions of mega-electron-volt electrons is important for gaining a better understanding of the interaction of ultra-intense laser pulses with plasma, especially for fast-ignition laser-fusion research. It is also crucial when evaluating the production of suprathermal (several 10-keV) electrons through laser-plasma instabilities in conventional hot-spot-ignition and shock-ignition research. For these purposes, we developed a 10-in. manipulator-based multichannel electron spectrometer-the Osaka University electron spectrometer (OU-ESM)-that combines angular resolution with high-energy resolution. The OU-ESM consists of five small electron spectrometers set at every 5°, with an energy range from ∼40 keV to ∼40 MeV. A low-magnetic-field option provides a higher spectral resolution for an energy range of up to ∼5 MeV. We successfully obtained angularly resolved electron spectra for various experiments on the OMEGA and OMEGA EP laser systems.

Direct observation of imploded core heating via fast electrons with super-penetration scheme.

Fast ignition (FI) is a promising approach for high-energy-gain inertial confinement fusion in the laboratory. To achieve ignition, the energy of a short-pulse laser is required to be delivered efficiently to the pre-compressed fuel core via a high-energy electron beam. Therefore, understanding the transport and energy deposition of this electron beam inside the pre-compressed core is the key for FI. Here we report on the direct observation of the electron beam transport and deposition in a compressed core through the stimulated Cu Kα emission in the super-penetration scheme. Simulations reproducing the experimental measurements indicate that, at the time of peak compression, about 1% of the short-pulse energy is coupled to a relatively low-density core with a radius of 70 µm. Analysis with the support of 2D particle-in-cell simulations uncovers the key factors improving this coupling efficiency. Our findings are of critical importance for optimizing FI experiments in a super-penetration scheme.

Channel optimization of high-intensity laser beams in millimeter-scale plasmas.

Channeling experiments were performed at the OMEGA EP facility using relativistic intensity (>10^{18}W/cm^{2}) kilojoule laser pulses through large density scale length (∼390-570 µm) laser-produced plasmas, demonstrating the effects of the pulse's focal location and intensity as well as the plasma's temperature on the resulting channel formation. The results show deeper channeling when focused into hot plasmas and at lower densities, as expected. However, contrary to previous large-scale particle-in-cell studies, the results also indicate deeper penetration by short (10 ps), intense pulses compared to their longer-duration equivalents. This new observation has many implications for future laser-plasma research in the relativistic regime.

Relativistic laser channeling in plasmas for fast ignition.

We report an experimental observation suggesting plasma channel formation by focusing a relativistic laser pulse into a long-scale-length preformed plasma. The channel direction coincides with the laser axis. Laser light transmittance measurement indicates laser channeling into the high-density plasma with relativistic self-focusing. A three-dimensional particle-in-cell simulation reproduces the plasma channel and reveals that the collimated hot-electron beam is generated along the laser axis in the laser channeling. These findings hold the promising possibility of fast heating a dense fuel plasma with a relativistic laser pulse.

Density and temperature characterization of long-scale length, near-critical density controlled plasma produced from ultra-low density plastic foam.

The ability to produce long-scale length (i.e. millimeter scale-length), homogeneous plasmas is of interest in studying a wide range of fundamental plasma processes. We present here a validated experimental platform to create and diagnose uniform plasmas with a density close or above the critical density. The target consists of a polyimide tube filled with an ultra low-density plastic foam where it was heated by x-rays, produced by a long pulse laser irradiating a copper foil placed at one end of the tube. The density and temperature of the ionized foam was retrieved by using x-ray radiography and proton radiography was used to verify the uniformity of the plasma. Plasma temperatures of 5-10 eV and densities around 10(21) cm(-3) are measured. This well-characterized platform of uniform density and temperature plasma is of interest for experiments using large-scale laser platforms conducting High Energy Density Physics investigations.

Slowdown mechanisms of ultraintense laser propagation in critical density plasma.

We use one- and two-dimensional particle-in-cell simulations to demonstrate that the propagation of an ultraintense laser (I=10(19)W/cm(2)) in critical density plasma can be interfered with by a high density plasma wall region generated at the propagation front. When the electron flow speed of the wall region exceeds a certain relativistic threshold, the region behaves as an overdense plasma due to a decrease of the effective critical density. The region forms then very small overdense plasma islands. The islands impede the propagation intermittently and slow down the propagation speed significantly.

Channeling of multikilojoule high-intensity laser beams in an inhomogeneous plasma.

Channeling experiments were performed that demonstrate the transport of high-intensity (>10(18)W/cm(2)), multikilojoule laser light through a millimeter-sized, inhomogeneous (∼300-µm density scale length) laser-produced plasma up to overcritical density, which is an important step forward for the fast-ignition concept. The background plasma density and the density depression inside the channel were characterized with a novel optical probe system. The channel progression velocity was measured, which agrees well with theoretical predictions based on large scale particle-in-cell simulations, confirming scaling laws for the required channeling laser energy and laser pulse duration, which are important parameters for future integrated fast-ignition channeling experiments.

Fast ion acceleration in ultraintense laser interactions with an overdense plasma.

In order to study the ion acceleration processes in ultraintense laser-plasma interactions with solid targets, neutron spectra from deuteron-deuteron (D-D) nuclear reactions were measured. Spectra were obtained when (50-100 TW, 0.5-1 ps) laser light irradiated obliquely incident deuterated plastic targets as a function of laser polarization, intensity, and density scale length of the preformed plasma. The experimental data are compared with three-dimensional Monte Carlo simulations. The results indicate that the ion momentum distribution is collimated and directed into the bulk of the target to the target normal direction with an energy that is linearly proportional to the laser intensity. The distribution of the accelerated ions was observed to change from isotropic to anisotropic with laser prepulse intensity. All the results indicate that the ion acceleration is dominated by an electrostatic field generated from a charge displacement of the hot electrons at the target surface.

Observation of neutron spectrum produced by fast deuterons via ultraintense laser plasma interactions.

We report the first precise spectral measurement of fast neutrons produced in a deuterated plastic target irradiated by an ultraintense sub-picosecond laser pulse. The 500-fs, 50-J, 1054-nm laser pulse was focused on the deuterated polystyrene target with an intensity of 2 x 10(19) W/cm(2). The neutron spectra were observed at 55 degrees and 90 degrees to the rear target normal. The neutron emission was 7 x 10(4) per steradian for each detector. The observed neutron spectra prove the acceleration of deuterons and neutron production by d(d,n)3He reactions in the target. The neutron spectra were compared with Monte Carlo simulation results and the deuteron's directional anisotropy and energy spectrum were studied. We conclude that 2% of the laser energy was converted to deuterons, which has an energy range of 30 keV up to 3 MeV.

Ion acceleration from the shock front induced by hole boring in ultraintense laser-plasma interactions.

Ion-acceleration processes have been studied in ultraintense laser plasma interactions for normal incidence irradiation of solid deuterated targets via neutron spectroscopy. The experimental neutron spectra strongly suggest that the ions are preferentially accelerated radially, rather than into the bulk of the material from three-dimensional Monte Carlo fitting of the neutron spectra. Although the laser system has a 10(-7) contrast ratio, a two-dimensional magnetic hydrodynamics simulation shows that the laser pedestal generates a 10 mum scale length in the coronal plasma with a 3 mum scale-length plasma near the critical density. Two-dimensional particle-in-cell simulations, incorporating this realistic density profile, indicate that the acceleration of the ions is caused by a collisionless shock formation. This has implications for modeling energy transport in solid density plasmas as well as cone-focused fast ignition using the next generation PW lasers currently under construction.

Measuring the strong electrostatic and magnetic fields with proton radiography for ultra-high intensity laser channeling on fast ignition.

In order to investigate the intense laser propagation and channel formation in dense plasma, we conducted an experiment with proton deflectometry on the OMEGA EP Laser facility. The proton image was analyzed by tracing the trajectory of mono-energetic protons, which provides understanding the electric and magnetic fields that were generated around the channel. The estimated field strengths (E ∼ 10(11) V/m and B ∼ 10(8) G) agree with the predictions from 2D-Particle-in-cell (PIC) simulations, indicating the feasibility of the proton deflectometry technique for over-critical density plasma.

Time-resolved compression of a capsule with a cone to high density for fast-ignition laser fusion.

The advent of high-intensity lasers enables us to recreate and study the behaviour of matter under the extreme densities and pressures that exist in many astrophysical objects. It may also enable us to develop a power source based on laser-driven nuclear fusion. Achieving such conditions usually requires a target that is highly uniform and spherically symmetric. Here we show that it is possible to generate high densities in a so-called fast-ignition target that consists of a thin shell whose spherical symmetry is interrupted by the inclusion of a metal cone. Using picosecond-time-resolved X-ray radiography, we show that we can achieve areal densities in excess of 300 mg cm(-2) with a nanosecond-duration compression pulse--the highest areal density ever reported for a cone-in-shell target. Such densities are high enough to stop MeV electrons, which is necessary for igniting the fuel with a subsequent picosecond pulse focused into the resulting plasma.

Development of multi-channel electron spectrometer.

In order to obtain the angular dependent electron energy distributions, we developed a multichannel electron spectrometer (MCESM) with high energy and angular resolutions. The MCESM consists of seven small electron spectrometers set in every 5° on the basement, each of which detection range is up to 25 MeV. In the experiment, we successfully obtained electron spectra from imploded cone-shell target as well as gold plane target irradiated by ultraintense (300 J/5 ps) laser beam.

Effect of reentrant cone geometry on energy transport in intense laser-plasma interactions.

The energy transport in cone-guided low- Z targets has been studied for laser intensities on target of 2.5x10(20) W cm(-2). Extreme ultraviolet (XUV) imaging and transverse optical shadowgraphy of the rear surfaces of slab and cone-slab targets show that the cone geometry strongly influences the observed transport patterns. The XUV intensity showed an average spot size of 65+/-10 microm for slab targets. The cone slabs showed a reduced spot size of 44+/-10 microm. The shadowgraphy for the aforementioned shots demonstrate the same behavior. The transverse size of the expansion pattern was 357+/-32 microm for the slabs and reduced to 210+/-30 microm. A transport model was constructed which showed that the change in transport pattern is due to suppression of refluxing electrons in the material surrounding the cone.