Excess Conductivity Analysis of an YBCO Foam Strut and Its Microstructure.

Struts of a superconducting YBa2Cu3Oy (YBCO) foam prepared by the infiltration growth method on the base of commercial polyurethane foams were extracted from the bulk, and thoroughly characterized concerning the microstructure and the magnetoresistance, measured by the four-point technique. Optical microscopy, electron microscopy, electron backscatter diffraction and atomic force microscopy observations indicate a unique microstructure of the foam struts which shows a large amount of tiny Y2BaCuO5 (Y-211) particles (with diameters between 50 and 100 nm) being enclosed in channel-like grain boundaries between the YBCO grains and a one-of-a-kind surface of the struts covered with Ba3Cu5Oy-particles. The resistance data obtained at temperatures in the range 4.2 K ≤T≤ 150 K (applied magnetic fields ranging from 0 to 7 T) were analyzed in the framework of the fluctuation-induced conductivity (FIC) approach using the models of Aslamazov-Larkin (AL) and Lawrence-Doniach (LD). The resulting FIC curves reveal the presence of five distinct fluctuation regimes, namely, the short-wave (SWF), one-dimensional (1D), two-dimensional (2D), three-dimensional (3D), and critical (CR) fluctuation domains. The analysis of the FIC data enable the coherence length in the direction of the c-axis at zero-temperature (ξc(0)), the irreversibility field (Birr), the upper critical magnetic field (Bc2), the critical current density at T= 0 K (Jc(0)) and several other parameters describing the the material's superconducting properties to be determined. The present data reveal that the minuscule Y-211 particles found along the YBCO grain boundaries alter the excess conductivity and the fluctuation behavior as compared to conventional YBCO samples, leading to a quite high value for Jc(0) for a sample with a non-optimized pinning landscape.

Evaluation of the Radiation-Protective Properties of Bi (Pb)-Sr-Ca-Cu-O Ceramic Prepared at Different Temperatures with Silver Inclusion.

The influences of the sintering process and AgNO3 addition on the phase formation and radiation shielding characteristics of Bi1.6Pb0.4Sr2Ca2Cu3O10 were studied. Three ceramics (code: C0, C1, and C2) were prepared as follows: C0 was obtained after calcination and only one sintering step, C1 was obtained after calcination and two sintering cycles, and C2 was prepared after the addition of AgNO3 at the beginning of the final sintering stage. C2 displayed the maximum volume fraction of the Bi-2223 phase (76.4 vol%), the greatest crystallite size, and high density. The linear mass attenuation coefficient (µ) has been simulated using the Monte Carlo simulation. The µ values are high at 15 keV (257.2 cm-1 for C0, 417.57 cm-1 for C1, and 421.16 cm-1 for C2), and these values dropped and became 72.58, 117.83 and 133.19 cm-1 at 30 keV. The µ value for the ceramics after sintering is much higher than the ceramic before sintering. In addition, the µ value for C2 is higher than that of C1, suggesting that the AgNO3 improves the radiation attenuation performance for the fabricated ceramics. It was demonstrated that the sintering and AgNO3 addition have a considerable influence on the ceramic thickness required to attenuate the radiation.

In Vitro Antimicrobial and Anticancer Peculiarities of Ytterbium and Cerium Co-Doped Zinc Oxide Nanoparticles.

Zinc oxide nanoparticles (ZnO NPs) are a promising platform for their use in biomedical research, especially given their anticancer and antimicrobial activities. This work presents the synthesis of ZnO NPs doped with different amounts of rare-earth ions of ytterbium (Yb) and cerium (Ce) and the assessment of their anticancer and antimicrobial activities. The structural investigations indicated a hexagonal wurtzite structure for all prepared NPs. The particle size was reduced by raising the amount of Ce and Yb in ZnO. The anticancer capabilities of the samples were examined by the cell viability MTT assay. Post 48-h treatment showed a reduction in the cancer cell viability, which was x = 0.00 (68%), x = 0.01 (58.70%), x = 0.03 (80.94%) and x = 0.05 (64.91%), respectively. We found that samples doped with x = 0.01 and x = 0.05 of Yb and Ce showed a better inhibitory effect on HCT-116 cancer cells than unadded ZnO (x = 0.00). The IC50 for HCT-116 cells of Ce and Yb co-doped ZnO nanoparticles was calculated and the IC50 values were x = 0.01 (3.50 µg/mL), x = 0.05 (8.25 µg/mL), x = 0.00 (11.75 µg/mL), and x = 0.03 (21.50 µg/mL). The treatment-doped ZnO NPs caused apoptotic cell death in the HCT-116 cells. The nanoparticles showed inhibitory action on both C. albicans and E. coli. It can be concluded that doping ZnO NPs with Yb and Ce improves their apoptotic effects on cancer and microbial cells.

YBa2Cu3Oy Superconducting Ceramics Incorporated with Different Types of Oxide Materials as Promising Radiation Shielding Materials: Investigation of The Structure, Morphology, and Ionizing Radiations Shielding Performances.

New series of YBCO ceramics samples doping with different oxides such as SiO2, WO3, Al2O3, and TiO2 were fabricated to study the ionizing radiation shielding properties. The structure and morphology were explored by X-ray diffraction (XRD) and scanning electron microscope (SEM). The shielding properties were investigated experimentally and theoretically to check the validity of the results. The investigated radiation shielding properties include the proton, neutron, and gamma-ray. The XRD results show the orthorhombic structure for all ceramics without any additional peaks related to WO3, SiO2, TiO2, and Al2O3. At the same time, the SEM results appear to have a significant differentiation in the granular behavior of all ceramics surfaces. The incorporation of WO3 to YBCO enhanced the ceramic density, whereas the addition of different oxides reduced the density for ceramic samples. This variation in density changed the radiation shielding results. The sample containing WO3 (YBCO-W) gives us better results in radiation shielding properties for gamma and neutron; the sample having Al2O3 (YBCO-Al) is superior in shielding results for charged particles. Finally, the possibility to use YBCO with various oxides in different ionizing radiation shielding fields can be concluded.

Excess Conductivity Analysis of Polycrystalline FeSe Samples with the Addition of Ag.

Bulk FeSe superconductors of the iron-based (IBS) "11" family containing various additions of silver were thoroughly investigated concerning the microstructure using optical microscopy and electron microscopy (TEM and SEM). The measurements of electrical resistivity were performed through the four-point technique in the temperature interval T= 2-150 K. The Aslamazov-Larkin model was employed to analyze the fluctuation-induced conductivity (FIC) in all acquired measurements. In all studied products, we found that the FIC curves consist of five different regimes of fluctuation, viz. critical region (CR), three-dimensional (3D), two-dimensional (2D), one-dimensional (1D), and shortwave fluctuation (SWF) regimes. The critical current density (Jc), the lower and upper critical magnetic fields (Bc1 and Bc2), the coherence length along the c-axis at zero-temperature (ξc(0)), and further parameters were assessed with regards to the silver amount within the products. The analyses discloses a diminution in the resistivity and a great reduction in ξc(0) with Ag addition. The optimal silver doping amount is achieved for 7 wt.%, which yields the best superconducting transition and the greatest Jc value.