Laminating Structure for Interlayer Corona Discharge Treatment Toward Ion-Based Nanogenerators.

A corona discharge treatment (CDT) is utilized to maximize the performance of triboelectric nanogenerators (TENGs) by injecting extra electrons into the negative tribomaterials. Increased performance of CDT TENGs, however, exhibits rapid degradation due to the electron dissipation by air moisture or thermal emission. To overcome such drawbacks and circumvent such dissipation, the source of charges should be replaced with ionic charges. This study reports a Ag nanowires (NWs)-embedded laminating structure (AeLS) with a unique fabrication procedure for ionic charge injection by CDT. The injection of ions is achieved by interlayer-CDT (i-CDT), in which positive charges are dissipated by Ag NWs, and the opposite negative ions can remain on the outmost surface. The AeLS TENGs with i-CDT exhibit high performance, long-term stability, and durability. It shows voltage, current, and maximum power outputs of 380 V, 15 µA, and 827 mW m-2 , respectively. As a practical demonstration, rotational TENG integrated with a direct discharge system is realized, and its current and voltage reach 7.4 mA and 7800 V, respectively. This work can pave the way for the design of ion-based TENGs with high performance and long-lasting retention of triboelectric charges.

Dominant Role of Young's Modulus for Electric Power Generation in PVDF⁻BaTiO3 Composite-Based Piezoelectric Nanogenerator.

The electric power output of a piezoelectric nanogenerator (PENG) depends on the various physical parameters of the constituent materials, including the piezoelectric coefficient, Young's modulus, and dielectric constant. Herein, we report the mechanical and electrical properties of a poly(vinylidene fluoride)⁻BaTiO3 (PVDF⁻BTO) composite-based PENG. Variation of the BTO nanoparticle (NP) content enabled the systematic tuning of the physical parameters that are related to power generation in the composite. The Young's modulus of the PVDF⁻BTO composite initially increased, and then eventually decreased, with the increasing BTO content, which was probably due to the clustering effect of the high modulus BTO NPs. The dielectric constant of the composite continuously increased as the BaTiO3 content increased. The piezoelectric outputs were greatly enhanced at 10 wt% of BTO, where the Young's modulus was the highest. These results indicate that the Young's modulus plays an important role in the piezoelectric power generation of the composite-based PENGs.