O- and H-induced surface core level shifts on Ru(0001): prevalence of the additivity rule.

In previous work on adsorbate-induced surface core level shifts (SCLSs), the effects caused by O atom adsorption on Rh(111) and Ru(0001) were found to be additive: the measured shifts for first-layer Ru atoms depended linearly on the number of directly coordinated O atoms. Density-functional theory calculations quantitatively reproduced this effect, allowed separation of initial- and final-state contributions, and provided an explanation in terms of a roughly constant charge transfer per O atom. We have now conducted similar measurements and calculations for three well-defined adsorbate and coadsorbate layers containing O and H atoms: (1 × 1)-H, (2 × 2)-(O+H) and (2 × 2)-(O+3H) on Ru(0001). As H is stabilized in fcc sites in the prior two structures and in hcp sites in the latter, this enables us to not only study coverage and coadsorption effects on the adsorbate-induced SCLSs, but also the sensitivity to similar adsorption sites. Remarkably good agreement is obtained between experiment and calculations for the energies and geometries of the layers, as well as for all aspects of the SCLS values. The additivity of the next-neighbor adsorbate-induced SCLSs is found to prevail even for the coadsorbate structures. While this confirms the suggested use of SCLSs as fingerprints of the adsorbate configuration, their sensitivity is further demonstrated by the slightly different shifts unambiguously determined for H adsorption in either fcc or hcp hollow sites.

High-resolution phonon study of the Ag(100) surface.

Using high-resolution electron energy loss spectroscopy the phonon dispersion of Ag(100) has been studied at two different sample temperatures of 86 and 300 K. The dominant feature in the spectra corresponds to the Rayleigh wave. Its full dispersion is determined along the ΓX high symmetry direction in the first and second Brillouin zones. The Rayleigh phonon maximum at the X point shows a redshift with increasing temperature. This is explained based on a surface anharmonicity with an anharmonicity constant of 0.014, comparable to the value reported for Cu(100). In the vicinity of the Γ point two additional phonon features have been discovered at about 110 and 160 cm(-1), which are tentatively assigned to high density of states features from the bulk phonon bands. However, the observed steep dispersion is in contrast to theoretical calculations. Along ΓX two surface resonance branches have been observed with maximum frequencies in the range of 90-110 cm(-1) near to the zone boundary. These branches agree with helium atom scattering data where available, but are not predicted by theory.

Two bonding configurations of acetylene on Si(001)-(2 x 1): a combined high-resolution electron energy loss spectroscopy and density functional theory study.

Two coexisting adsorption states of molecularly adsorbed acetylene on the Si(001)-(2 x 1) surface have been identified by a combined study based on the high-resolution electron energy loss spectroscopy and density functional computations. Seven possible adsorbate-substrate structures are considered theoretically including their full vibrational analysis. Based on a significantly enhanced experimental resolution, the assignment of 15 C2H2- and C2D2-derived vibrational modes identifies a dominant di-sigma bonded molecule adsorbed on top of a single Si-Si dimer. Additionally there is clear evidence for a second minority species which is di-sigma bonded between two Si-Si dimers within the same dimer row (end-bridge geometry). The possible symmetries of the adsorbate complexes are discussed based on the specular and off-specular vibrational measurements. They suggest lower than ideal C(2v) and C(s) symmetries for on-top and end-bridge species, respectively. At low coverages the symmetry reductions might be lifted.