Enhanced Low-Density Silicone Foams Blown by Water-Hydroxyl Blends.

Water, alcohols, diols, and glycerol are low-cost blowing agents that can be used to create the desired silicone foam structures. Although their combined use can be beneficial, it remains unclear how it affects the physical properties of the resulting materials. We conducted a comparative study of these hydroxyl-bearing blowing agents in fumed silica- and mica-filled polymer composite systems for simultaneous blowing and crosslinking to obtain a low-density, uniform porosity and superior mechanical properties. The foams were optimized for a uniform open-pore structure with densities ranging from 75 to 150 kg‧m-3. Varying the diol chain length (Cn) from one to seven carbons can alter the foam density and structure, thereby enhancing the foam tensile strength while maintaining a low density. Replacing 10 mol% of water with 1,4-butanediol decreased the density by 26%, while increasing the specific strength by 5%. By combining glycerol and water blowing, the resulting foams exhibited a 30% lower apparent density than their water-blown analogs. The results further showed that Cn > 4 alkane chain diols had an odd-even effect on the apparent density and cell wall thickness. All foamable compositions had viscosities of approximately 7000 cSt and curing times below 2 min, allowing for quick dispensing and sufficient time for the foam to cure in semi-industrial volumes.

Microbial growth and adhesion of Escherichia coli in elastomeric silicone foams with commonly used additives.

Silicone is often used in environments where water repellency is an advantage. Contact with water promotes the adhesion of microorganisms and biofilm formation. Depending on the application, this may increase the possibility of food poisoning and infections, the material's degrading appearance, and the likelihood of manufacturing defects. The prevention of microbial adhesion and biofilm formation is also essential for silicone-based elastomeric foams, which are used in direct contact with human bodies but are often difficult to clean. In this study, the microbial attachment in and the retention from the pores of silicone foams of different compositions is described and compared to those of commonly used polyurethane foams. The growth of the gram-negative Escherichia coli in the pores and their leaching during wash cycles is characterised by bacterial growth/inhibition, adhesion assay, and SEM imaging. The structural and surface properties of the materials are compared. Despite using common antibacterial additives, we have found that non-soluble particles stay isolated in the silicone elastomer layer, thus affecting surface microroughness. Water-soluble tannic acid dissolves into the medium and seems to aid in inhibiting planktonic bacterial growth, with a clear indication of the availability of tannic acid on the surfaces of SIFs.