Isolation, Identification, and Carbonate Mineralization Characteristics of a Newly Carbonic Anhydrase-Producing Strain.

Carbonic anhydrase-producing microorganisms can rely on their metabolism for carbon sequestration and carbonate precipitation, which is a relatively effective mode among the known microbially induced carbonate precipitation (MICP) methods. A newly carbonic anhydrase-producing strain was isolated from soil samples. 16S rDNA gene sequencing showed this strain had 99.18% sequence identity to Chryseobacterium gambrini. Various culture parameters (temperature, pH, rotational speed, inoculum size, and metal ions) were optimized for optimal microbial growth and CA activities. Optimal culture conditions were as follows: temperature of 30 °C, pH 6-7, rotational speed 150 rpm, and inoculum size 1%. It was observed that Co2+ and Mn2+ can improve CA activity with optimal concentrations of 0.02 mM and 0.01 mM, respectively. Furthermore, the introduction of CO2 for 15 min daily leads to a 36% increase in the final production of biotic CaCO3, reaching 2.884 g/L. Characterization of the mineralization precipitates was conducted to reveal the mechanism of the carbonic anhydrase-producing bacterium. Lastly, an analysis of the crystalline species and content of the biogenic CaCO3 was performed to lay the groundwork for future crystalline adjustments and to offer technical support for the application of the calcium method.

Development of an Efficient and Seamless Genetic Manipulation Method for Xenorhabdus and Its Application for Enhancing the Production of Fabclavines.

Xenorhabdus can produce numerous natural products, but their development has been hampered by the lack of a seamless genetic manipulation method. In this study, we compared several lethal genes and determined the sacB gene as the most effective counter-selection marker and then established a dual selection/counter-selection system by integrating neo and sacB genes into one cassette. This provides an efficient and seamless genetic manipulation method for Xenorhabdus. Using this method, DNA fragments ranging from 205 to 47,788 bp in length were seamlessly knocked out or replaced with impressively high positive rates of 80 to 100% in Xenorhabdus budapestensis XBD8. In addition, the method was successfully applied with good efficiency (45-100%) in Xenorhabdus nematophila CB6. To further validate the method, different constitutive promoters were used to replace the native fclC promoter in a batch experiment. The positivity rate remained consistently high, at 46.3%. In comparison to WT XBD8, the recombinant strain MX14 demonstrated a significant increase in the production of fabclavine 7 and fabclavine 8 by 4.97-fold and 3.22-fold, respectively, while the overall production of fabclavines was enhanced by 3.52-fold.

FeCu bimetallic metal organic frameworks photo-Fenton synergy efficiently degrades organic pollutants: Structure, properties, and mechanism insight.

The high ion leaching, low photogenerated charge separation efficiency, and slow metal valence cycling of Fe-based metal organic frameworks (MOFs) have limited their application in the deep treatment of organic pollutants. Herein, FeCu bimetallic MOFs (FeCuBDC) were synthesized using a modified solvothermal method, and a coupled photo-Fenton degradation system was successfully constructed. Degradation performance tests showed that FeCuBDC could efficiently degrade 99.3% ± 0.1% of 50 mg/L phenol within 40 min. The reaction rate constants of the photo-Fenton system were 11.0 and 64.7 times higher than those of the single Fenton reaction and photocatalysis, respectively. FeCuBDC also exhibits good cycling stability, degradation generalization, and excellent photoelectric catalytic properties. Such a considerable enhancement in the overall performance pertains to the following. First, the introduction of Cu into Fe-MOFs not only improves the crystallinity and stability, but also reduces the band gap value, increases the absorption capacity of visible light, and promotes the generation of photogenerated carriers. Second, the FeCu in MOFs are all mixed valence. Initially, the high-valence FeCu captures photogenerated electrons and promotes photogenerated charge separation and transfer. Then, the low-valence FeCu adsorbs and decomposes H2O2, accelerating the valence cycling of the bimetallic sites. The core of the reaction mechanism is that FeCuBDC effectively promotes the photo-Fenton synergy.

V-Doped CoSe2 Nanowire Catalysts in a 3D-Structured Electrode for Durable Li-S Pouch Cells.

Lithium-sulfur (Li-S) batteries have high theoretical energy density and are regarded as a promising candidate for next-generation energy storage systems. However, their practical applications are hindered by the slow kinetics of sulfur conversion and polysulfide shuttling. In particular, large-scale pouch cells show much poor cyclability. Here, we develop a high-efficiency catalyst of V-doped CoSe2 by studying the binary CoSe2-VSe2 system and confirming its effectiveness in accelerating polysulfide conversion. The coin cell tests reveal an initial capacity of 1414 mAh g-1 at 0.1 C and 1049 mAh g-1 at 1 C and demonstrate 1000 times cyclability with a decaying rate of 0.05% per cycle. Furthermore, the assembly and construction of pouch cells were optimized with monolithic three-dimensional (3D) electrodes and a multistacking strategy. Specifically, a 3D metallic scaffold (3MS) was developed to host V-doped CoSe2 nanowires and sulfur. In addition, Janus microspheres of C@TiO2 were synthesized to capture polar polysulfides with their polar part of TiO2 and adsorb nonpolar sulfur with their nonpolar part of carbon. By integrating with 3MS, C@TiO2 microspheres can block all ion channels of 3MS and only allow Li ions in and out. These integral designs and monolithic structures enable multistacking pouch cells with high cyclability. A high-loading pouch cell was demonstrated with a total capacity of 700 mAh. The cell can be cycled for 70 times with a capacity retention of 65.7%. In brief, this work provides an integral strategy of catalyst design and overall 3D assembly for practical Li-S batteries in a large pouch cell format.

IRE1α regulates macrophage polarization in type 2 diabetic periodontitis through promoting endoplasmic reticulum stress.

OBJECTIVES: The aim of this study was to investigate the effect of 4µ8c, an inhibitor targeting the endoplasmic reticulum stress-associated factor IRE1α, on macrophage polarization in an experimental model of diabetic periodontitis through ex vivo experiments. MATERIALS AND METHODS: Local alveolar bone parameters were evaluated using Micro-CT following intraperitoneal administration of 4µ8c in mice with experimental diabetic periodontitis. Surface markers indicating macrophage polarization were identified using immunofluorescence. In vitro experiments were performed employing bone marrow-derived macrophages and gingival fibroblasts. Macrophage polarization was determined using flow cytometry. Principal impacted signaling pathways were identified through Western blot analysis. RESULTS: Results from both in vitro and in vivo experiments demonstrated that 4µ8c mitigated alveolar bone resorption and inflammation in mice with diabetic periodontitis. Furthermore, it modulated macrophage polarization towards the M2 phenotype and augmented M2 macrophage polarization through the MAPK signaling pathway. CONCLUSIONS: These findings suggest that inhibiting IRE1α can modulate macrophage polarization and alleviate ligature-induced diabetic periodontitis via the MAPK signaling pathway. This unveils a novel mechanism, offering a scientific foundation for the treatment of experimental diabetic periodontitis.

G-quadruplexes promote the motility in MAZ phase-separated condensates to activate CCND1 expression and contribute to hepatocarcinogenesis.

G-quadruplexes (G4s) can recruit transcription factors to activate gene expression, but detailed mechanisms remain enigmatic. Here, we demonstrate that G4s in the CCND1 promoter propel the motility in MAZ phase-separated condensates and subsequently activate CCND1 transcription. Zinc finger (ZF) 2 of MAZ is a responsible for G4 binding, while ZF3-5, but not a highly disordered region, is critical for MAZ condensation. MAZ nuclear puncta overlaps with signals of G4s and various coactivators including BRD4, MED1, CDK9 and active RNA polymerase II, as well as gene activation histone markers. MAZ mutants lacking either G4 binding or phase separation ability did not form nuclear puncta, and showed deficiencies in promoting hepatocellular carcinoma cell proliferation and xenograft tumor formation. Overall, we unveiled that G4s recruit MAZ to the CCND1 promoter and facilitate the motility in MAZ condensates that compartmentalize coactivators to activate CCND1 expression and subsequently exacerbate hepatocarcinogenesis.

Boron-Doped Dinickel Phosphide to Enhance Polysulfide Conversion and Suppress Shuttling in Lithium-Sulfur Batteries.

Lithium-sulfur (Li-S) batteries are promising for next-generation high-energy energy storage systems. However, the slow reaction kinetics render mobile polysulfides hardly controlled, yielding shuttling effects and eventually damaging Li metal anodes. To improve the cyclability of Li-S batteries, high-efficiency catalysts are desired to accelerate polysulfide conversion and suppress the shuttling effect. Herein, we studied a doping system with Ni2P and Ni2B as the end members and found a B-doped Ni2P catalyst that demonstrates high activity for Li-S batteries. As anionic dopants, B demonstrates an interesting reverse electron transfer to P and tunes the electronic structure of Ni2P dramatically. The resultant B-doped Ni2P exhibits short Ni-B bonds and strong Ni-S interaction, and the electron donation of B to P further enhances the adsorption of polysulfide on catalysts. The S-S bonds of polysulfides were activated appropriately, therefore decreasing a low energy barrier for conversion reactions.