Removal of Poly- and Per-Fluorinated Compounds from Ion Exchange Regenerant Still Bottom Samples in a Plasma Reactor.

"High-concentration" and "low-concentration" bench-scale batch plasma reactors were used to effectively degrade per- and polyfluoroalkyl substances (PFAS) at a high concentration (∼100 mg/L) and a low concentration (<1 µg/L), respectively, in ion exchange (IX) regenerant still bottom (SB) solutions. In the SBs, numerous PFAS were detected with a wide concentration range (∼0.01 to 100 mg/L; total oxidizable precursors (TOP) ∼4000 to 10000 mg/L). In the "high-concentration" plasma reactor, the concentrations of PFAS precursors and long-chain perfluoroalkyl acids (PFAAs) (≥6C for PFSAs and ≥8C for perfluorocarboxylic acids (PFCAs)) were decreased by >99.9% in 2 h, and short-chain PFAAs (<6C for perfluorocarboxylic acids (PFSAs) and <8C PFCAs) were decreased by >99% in 6 h of treatment. Subsequently, a "low concentration" plasma reactor was used to remove additional PFAAs. In this reactor, the addition of CTAB (cetrimonium bromide, a cationic surfactant) caused short-chain PFAAs, other than PFBA, to be removed to below detection limits in 90 min of treatment time. Overall, >99% of the TOP present in SBs was removed during the treatment. Fluorine recovery of 47 to 117% was obtained in six SB samples. Energy requirement (EE/O) for the treatment of PFOA and PFOS from SBs ranged from 380 to 830 kWh/m3.

Successful treatment of an MTBE-impacted aquifer using a bioreactor self-colonized by native aquifer bacteria.

A field-scale fixed bed bioreactor was used to successfully treat an MTBE-contaminated aquifer in North Hollywood, CA without requiring inoculation with introduced bacteria. Native bacteria from the MTBE-impacted aquifer rapidly colonized the bioreactor, entering the bioreactor in the contaminated groundwater pumped from the site, and biodegraded MTBE with greater than 99 % removal efficiency. DNA sequencing of the 16S rRNA gene identified MTBE-degrading bacteria Methylibium petroleiphilum in the bioreactor. Quantitative PCR showed M. petroleiphilum enriched by three orders of magnitude in the bioreactor above densities pre-existing in the groundwater. Because treatment was carried out by indigenous rather than introduced organisms, regulatory approval was obtained for implementation of a full-scale bioreactor to continue treatment of the aquifer. In addition, after confirmation of MTBE removal in the bioreactor to below maximum contaminant limit levels (MCL; MTBE = 5 µg L(-1)), treated water was approved for reinjection back into the aquifer rather than requiring discharge to a water treatment system. This is the first treatment system in California to be approved for reinjection of biologically treated effluent into a drinking water aquifer. This study demonstrated the potential for using native microbial communities already present in the aquifer as an inoculum for ex-situ bioreactors, circumventing the need to establish non-native, non-acclimated and potentially costly inoculants. Understanding and harnessing the metabolic potential of native organisms circumvents some of the issues associated with introducing non-native organisms into drinking water aquifers, and can provide a low-cost and efficient remediation technology that can streamline future bioremediation approval processes.

Free-radical-induced oxidative and reductive degradation of N,N'-diethyl-m-toluamide (DEET): Kinetic studies and degradation pathway.

N,N'-Diethyl-m-toluamide (DEET) is widely used as an insect repellent and has therefore been detected as a contaminant in numerous waste and surface waters. In this study we have determined the absolute reaction rate constants of DEET with the hydroxyl radical and the hydrated electron in aqueous solution as (4.95+/-0.18)x10(9) and (1.34+/-0.04)x10(9) M(-1) s(-1), respectively, using pulse radiation. To provide additional information on the radicals formed upon oxidation, transient spectra were measured from 1 to 150 micros, with transient decay rates determined from the time-dependence of the maximum absorption at 330 nm. These data suggest simple decay of the initially formed radical to stable products. Radical-based destruction mechanisms for destruction of DEET are proposed based on the LC-MS determination of the stable compounds produced by 60Co gamma-irradiation of DEET solutions. These data will be useful in evaluating potential advanced oxidation/reduction processes for the control of DEET and understanding its fate and transport in surface water where analogous radical chemistry is operative.

Radiation chemistry of methyl tert-butyl ether in aqueous solution.

The chemical kinetics of the free-radical-induced degradation of the gasoline oxygenate methyl tert-butyl ether (MTBE) in water have been investigated. Rate constants for the reaction of MTBE with the hydroxyl radical, hydrated electron, and hydrogen atom were determined in aqueous solution at room temperature, using electron pulse radiolysis and absorption spectroscopy (*OH and e- aq) and EPR free induction decay attenuation (*H) measurements. The rate constant for hydroxyl radical reaction of (1.71 +/- 0.02) x 10(9) M(-1) s(-1) showed that the oxidative process was the dominant pathway, relative to MTBE reaction with hydrogen atoms, (3.49 +/- 0.06) x 10(6) M(-1) s(-1), or hydrated electrons, <8.0 x 10(6) M(-1) s(-1). The hydroxyl radical reaction gives a transient carbon-centered radical which subsequently reacts with dissolved oxygen to form peroxyl radicals, the rate constant for this reaction was (2.17 +/- 0.06) x 10(9) M(-1) s(-1). The second-order decay of the MTBE peroxyl radical was 2k = (6.0 +/- 0.3) x 10(8) M(-1) s(-1). These rate constants, along with preliminary MTBE degradation product distribution measurements, were incorporated into a kinetic model that compared the predicted MTBE removal from water against experimental measurements performed under large-scale electron beam treatment conditions.