How do different marine engine fuels and wet scrubbing affect gaseous air pollutants and ozone formation potential from ship emissions?

Sulphur Emission Control Areas (SECAs), mandated by the International Maritime Organization (IMO), regulate fuel sulphur content (FSC) to mitigate the environmental and health impact of shipping emissions in coastal areas. Currently, FSC is limited to 0.1% (w/w) within and 0.5% (w/w) outside SECAs, with exceptions for ships employing wet sulphur scrubbers. These scrubbers enable vessels using non-compliant fuels such as high-sulphur heavy fuel oils (HFOs) to enter SECAs. However, while sulphur reduction via scrubbers is effective, their efficiency in capturing other potentially harmful gases remains uncertain. Moreover, emerging compliant fuels like highly aromatic fuels or low-sulphur blends lack characterisation and may pose risks. Over three years, we assessed emissions from an experimental marine engine at 25% and 75% load, representative of manoeuvring and cruising, respectively. First, characterizing emissions from five different compliant and non-compliant fuels (marine gas oil MGO, hydro-treated vegetable oil HVO, high-, low- and ultra-low sulphur HFOs), we calculated emission factors (EF). Then, the wet scrubber gas-phase capture efficiency was measured using compliant and non-compliant HFOs. NOx EF varied among fuels (5200-19700 mg/kWh), with limited scrubber reduction. CO (EF 750-13700 mg/kWh) and hydrocarbons (HC; EF 122-1851 mg/kWh) showed also insufficient abatement. Carcinogenic benzene was notably higher at 25% load and about an order of magnitude higher with HFOs compared to MGO and HVO, with no observed scrubber reduction. In contrast, carbonyls such as carcinogenic formaldehyde and acetaldehyde, acting as ozone precursors, were effectively scrubbed due to their polarity and water solubility. The ozone formation potential (OFP) of all fuels was examined. Significant EF differences between fuels and engine loads were observed, with the wet scrubber providing limited or no reduction of gaseous emissions. We suggest enhanced regulations and emission abatements in the marine sector to mitigate gaseous pollutants harmful to human health and the environment.

Adenine derivatization for LC-MS/MS epigenetic DNA modifications studies on monocytic THP-1 cells exposed to reference particulate matter.

The aim of this study was to explore the impact of three different standard reference particulate matter (ERM-CZ100, SRM-1649, and SRM-2975) on epigenetic DNA modifications including cytosine methylation, cytosine hydroxymethylation, and adenine methylation. For the determination of low levels of adenine methylation, we developed and applied a novel DNA nucleobase chemical derivatization and combined it with liquid chromatography tandem mass spectrometry. The developed method was applied for the analysis of epigenetic modifications in monocytic THP-1 cells exposed to the three different reference particulate matter for 24 h and 48 h. The mass fraction of epigenetic active elements As, Cd, and Cr was analyzed by inductively coupled plasma mass spectrometry. The exposure to fine dust ERM-CZ100 and urban dust SRM-1649 decreased cytosine methylation after 24 h exposure, whereas all 3 p.m. increased cytosine hydoxymethylation following 24 h exposure, and the epigenetic effects induced by SRM-1649 and diesel SRM-2975 were persistent up to 48 h exposure. The road tunnel dust ERM-CZ100 significantly increased adenine methylation following the shorter exposure time. Two-dimensional scatters analysis between different epigenetic DNA modifications were used to depict a significantly negative correlation between cytosine methylation and cytosine hydroxymethylation supporting their possible functional relationship. Metals and polycyclic aromatic hydrocarbons differently shapes epigenetic DNA modifications.

Organic molecular markers and source contributions in a polluted municipality of north-east Italy: Extended PCA-PMF statistical approach.

Exceeding the maximum levels for environmental pollutants creates public and scientific interest for the environmental and human health impact it may have. In Northern Italy, the Po Valley, and in particular the Veneto region, is still a hotspot for air quality improvement. Several monitoring campaigns were carried out in this area to acquire information about sources of pollutants which are considered critical. For the first time, a deep study of the aerosol organic fraction was performed in the town Sernaglia della Battaglia, nearby Treviso. During three seasons of 2017, PM1 and PM2.5 samples were collected simultaneously. Organic molecular markers have been analyzed by in-situ derivatization thermal desorption gas chromatography time-of-flight mass spectrometry (IDTD-GC-TOFMS). Alkanes, polycyclic aromatic hydrocarbons, oxi-polycyclic aromatic hydrocarbons, anhydrous sugars, resins acids, triterpenoids, and acids were considered. The organic chemical composition has been analyzed based on seasonal variation and source contributions. Principal Component Analysis (PCA) and Positive Matrix Factorization (PMF) have been combined to deeply investigate the main sources of particulate organic matter. On the one hand, PCA evaluates the correlations between the organic markers and their seasonal distribution. On the other hand, the source contributions to aerosol composition are estimated by PMF. Four main emission sources were found by PMF: solid fuel combustion (coal, wood), combustion of petroleum distillates (gas and fuel oil) and exhaust gases of vehicles, industrial combustion processes, home heating, and forest fires are evaluated as the most important sources for the air quality and pollution in this municipality of Northern Italy.

A comparative study of persistent DNA oxidation and chromosomal instability induced in vitro by oxidizers and reference airborne particles.

Adverse health effects driven by airborne particulate matter (PM) are mainly associated with reactive oxygen species formation, pro-inflammatory effects, and genome instability. Therefore, a better understanding of the underlying mechanisms is needed to evaluate health risks caused by exposure to PM. The aim of this study was to compare the genotoxic effects of two oxidizing agents (menadione and 3-chloro-1,2-propanediol) with three different reference PM (fine dust ERM-CZ100, urban dust SRM1649, and diesel PM SRM2975) on monocytic THP-1 and alveolar epithelial A549 cells. We assessed DNA oxidation by measuring the oxidized derivative 8-hydroxy-2'-deoxyguanosine (8-OHdG) following short and long exposure times to evaluate the persistency of oxidative DNA damage. Cytokinesis-block micronucleus cytome assay was performed to assess chromosomal instability, cytostasis, and cytotoxicity. Particles were characterized by inductively coupled plasma mass spectrometry in terms of selected elemental content, the release of ions in cell medium and the cellular uptake of metals. PM deposition and cellular dose were investigated by a spectrophotometric method on adherent A549 cells. The level of lipid peroxidation was evaluated via malondialdehyde concentration measurement. Despite differences in the tested concentrations, deposition efficiency, and lipid peroxidation levels, all reference PM samples caused oxidative DNA damage to a similar extent as the two oxidizers in terms of magnitude but with different oxidative DNA damage persistence. Diesel SRM2975 were more effective in inducing chromosomal instability with respect to fine and urban dust highlighting the role of polycyclic aromatic hydrocarbons derivatives on chromosomal instability. The persistence of 8-OHdG lesions strongly correlated with different types of chromosomal damage and revealed distinguishing sensitivity of cell types as well as specific features of particles versus oxidizing agent effects. In conclusion, this study revealed that an interplay between DNA oxidation persistence and chromosomal damage is driving particulate matter-induced genome instability.

Characterization of the water soluble fraction in ultrafine, fine, and coarse atmospheric aerosol.

Water soluble organic carbon significantly contributes to aerosol's carbon mass and its chemical composition is poorly characterized due to the huge number of species. In this study, we determined 94 water-soluble compounds: inorganic ions (Cl-, Br-, I-, NO3-, SO42-,K+, Mg+, Na+, NH4+, Ca2+), organic acids (methanesulfonic acid and C2-C7 carboxylic acids), monosaccharides, alcohol-sugars, levoglucosan and its isomers, sucrose, phenolic compounds, free l- and d-amino acids and photo-oxidation products of α-pinene (cis-pinonic acid and pinic acid). The sampling was conducted using a micro-orifice uniform deposit impactor (MOUDI) at the urban area of Mestre-Venice from March to May 2016. The main aim of this work is to identify the source of each detected compound, evaluating its particle size distribution. Clear differences in size distributions were observed for each class of analyzed compounds. The positive matrix factorization (PMF) model was used to identify six factors related to different sources: a) primary biogenic aerosol particles with particle size > 10 µm; b) secondary sulfate contribution; c) biomass burning; d) primary biogenic aerosol particles distributed between 10 and 1 µm; e) an aged sea salt input and f) SOA pinene. Each factor was also characterized by different composition in waters soluble compounds and different particles size distribution.

Aerosol and snow transfer processes: An investigation on the behavior of water-soluble organic compounds and ionic species.

The concentrations of water-soluble compounds (ions, carboxylic acids, amino acids, sugars, phenolic compounds) in aerosol and snow have been determined at the coastal Italian base "Mario Zucchelli" (Antarctica) during the 2014-2015 austral summer. The main aim of this research was to investigate the air-snow transfer processes of a number of classes of chemical compounds and investigate their potential as tracers for specific sources. The composition and particle size distribution of Antarctic aerosol was measured, and water-soluble compounds accounted for 66% of the PM10 total mass concentration. The major ions Na+, Mg2+, Cl- and SO42- made up 99% of the total water soluble compound concentration indicating that sea spray input was the main source of aerosol. These ionic species were found mainly in the coarse fraction of the aerosol resulting in enhanced deposition, as reflected by the snow composition. Biogenic sources were identified using chemical markers such as carboxylic acids, amino acids, sugars and phenolic compounds. This study describes the first characterization of amino acids and sugar concentrations in surface snow. High concentrations of amino acids were found after a snowfall event, their presence is probably due to the degradation of biological material scavenged during the snow event. Alcohol sugars increased in concentration after the snow event, suggesting a deposition of primary biological particles, such as airborne fungal spores.

Particle size distribution of inorganic and organic ions in coastal and inland Antarctic aerosol.

The concentration and particle-size distribution of ionic species in Antarctic aerosol samples were determined to investigate their potential sources, chemical evolution, and transport. We analyzed aerosol samples collected at two different Antarctic sites: a coastal site near Victoria Land close to the Italian Research Base "Mario Zucchelli", and another site located on the Antarctic plateau, close to Italian-French Concordia Research Station. We investigated anionic compounds using ion-chromatography coupled to mass spectrometry, and cationic species through capillary ion chromatography with conductometry. Aerosol collected close to the coast was mainly characterized by sea salt species such as Na+, Mg2+, and SO42-. These species represented a percentage of 88% of the total sum of all detected ionic species in the aerosol samples from the coastal site. These species were mainly distributed in the coarse fraction, confirming the presence of primary aerosol near the ocean source. Aerosol collected over the Antarctic plateau was characterized by high acidity, with nss-SO42-, NO3-, and methanesulfonic acid as the most abundant species. These species were mainly distributed in the <0.49 µm fraction, and they had a behavior of a typical secondary aerosol, where several chemical and physical processes occurred.