Evaluation of Growth Responses of Lettuce and Energy Efficiency of the Substrate and Smart Hydroponics Cropping System.

Smart sensing devices enabled hydroponics, a concept of vertical farming that involves soilless technology that increases green area. Although the cultivation medium is water, hydroponic cultivation uses 13 ± 10 times less water and gives 10 ± 5 times better quality products compared with those obtained through the substrate cultivation medium. The use of smart sensing devices helps in continuous real-time monitoring of the nutrient requirements and the environmental conditions required by the crop selected for cultivation. This, in turn, helps in enhanced year-round agricultural production. In this study, lettuce, a leafy crop, is cultivated with the Nutrient Film Technique (NFT) setup of hydroponics, and the growth results are compared with cultivation in a substrate medium. The leaf growth was analyzed in terms of cultivation cycle, leaf length, leaf perimeter, and leaf count in both cultivation methods, where hydroponics outperformed substrate cultivation. The results of the 'AquaCrop simulator also showed similar results, not only qualitatively and quantitatively, but also in terms of sustainable growth and year-round production. The energy consumption of both the cultivation methods is compared, and it is found that hydroponics consumes 70 ± 11 times more energy compared to substrate cultivation. Finally, it is concluded that smart sensing devices form the backbone of precision agriculture, thereby multiplying crop yield by real-time monitoring of the agronomical variables.

Self-Polymerization Promoting Monomers: In Situ Transformation of Disulfide-Linked Benzoxazines into the Thiazolidine Structure.

Polybenzoxazines obtained especially from green synthons are facing challenges of the requirement of high ring-opening polymerization (ROP) temperature of the monomer, thus affecting their exploration at the industrial front. This demands effective structural changes in the monomer itself, to mediate catalyst-free polymerization at a low energy via one-step synthesis protocol. In this regard, monomers based on disulfide-linked bisbenzoxazine were successfully synthesized using cystamine (biobased) and cardanol (agro-waste)/phenol. Reduction of the disulfide bridge in the monomer using dithiothreitol under mild conditions in situ transformed the oxazine ring in the monomer, via neighboring group participation of the -SH group in a transient intermediate monomer, into a thiazolidine structure, which is otherwise difficult to synthesize. Structural transformation of ring-opening followed by the ring-closing intramolecular reaction led to an interconversion of O-CH2-N containing a six-membered oxazine ring to S-CH2-N containing a five-membered thiazolidine ring and a phenolic-OH. The structure of the monomer with the oxazine ring and its congener with the thiazolidine ring was characterized by spectroscopic methods and X-ray analysis. Kinetics of structural transformation at a molecular level is studied in detail, and it was found that the reaction proceeded via a transient 2-aminoethanethiol-linked benzoxazine intermediate, as supported by nuclear magnetic resonance spectroscopy and density functional theory studies. The thiazolidine-ring-containing monomer promotes ROP at a substantially low temperature than the reported mono-/bisoxazine monomers due to the dual mode of facilitation of the ROP reaction, both by phenolic-OH and by ring strain. Surprisingly, both the monomer structures led to the formation of a similar polymer structure, as supported by thermogravimetric analysis and Fourier transform infrared study. The current work highlights the benefits of inherent functionalities in naturally sourced feedstocks as biosynthons for the new latest generation of benzoxazine monomers.

Benzoxazine-grafted-chitosan biopolymer films with inherent disulfide linkage: Antimicrobial properties.

Synthesis and fabrication of naturally sourced biopolymers, especially chitosan, grafted with renewable small molecules have recently attracted attention as efficient antimicrobial agents and are highly desired for sustainable material development. Advantageous inherent functionalities in biobased benzoxazine extend the possibility of crosslinking with chitosan which holds immense potential. Herein, a low-temperature, greener facile methodology is adopted for the covalent confinement of benzoxazine monomers bearing aldehyde and disulfide linkages within chitosan to form benzoxazine-grafted-chitosan copolymer films. The association of benzoxazine as Schiff base, hydrogen bonding, and ring-opened structures enabled the exfoliation of chitosan galleries, and such host-guest mediated interactions demonstrated outstanding properties like hydrophobicity, good thermal, and solution stability due to the synergistic effects. Furthermore, the structures empowered excellent bactericidal properties against both E. coli and S. aureus as investigated by GSH loss, live/dead fluorescence microscopy, and morphological alteration on the cell surface by SEM. The work provides the benefits of disulfide-linked benzoxazines on chitosan, offering a promising avenue for general and eco-friendly usage in wound-healing and packaging material.

Bioequivalence of intramuscular and subcutaneous peginterferon beta-1a: results of a phase I, open-label crossover study in healthy volunteers.

BACKGROUND: Peginterferon beta-1a administered every 2 weeks via subcutaneous (SC) injection is approved to treat adult patients with relapsing-remitting multiple sclerosis (RRMS) and relapsing forms of multiple sclerosis (RMS). However, associated injection site reactions (ISRs) can lead to treatment discontinuation. Prior studies with interferon beta-1a reported a lower frequency of ISRs with intramuscular (IM) administration than with SC administration. IM administration of peginterferon beta-1a may therefore represent a useful alternative treatment option. METHODS: A phase I, open-label, two-period crossover study randomized healthy volunteers to receive a single dose of peginterferon beta-1a 125 mcg administered IM followed by a single 125 mcg dose administered SC after a 28-day washout or vice versa. Blood samples were collected up to 504 h post dose to determine pharmacokinetic (PK) and pharmacodynamic (PD) profiles. The primary endpoint was assessment of bioequivalence based on maximum serum concentration (Cmax) and area under the curve from time zero extrapolated to infinity (AUCinf). Other PK parameters, as well as PD (serum neopterin) and safety profiles, were also evaluated. RESULTS: The study enrolled 136 participants. Bioequivalence of IM and SC peginterferon beta-1a was established for both Cmax ([least squares (LS)] mean IM/SC ratio: 1.083 [90% confidence interval (CI), 0.975-1.203]) and AUCinf (LS mean IM/SC ratio: 1.089 [90% CI, 1.020-1.162]). Other PK and PD parameters were similar between administration routes, although moderate to high inter-subject variability was observed for IM and SC. Safety profiles were generally balanced between IM and SC administration. ISRs occurred at a lower frequency with IM [14.4% (95% CI, 8.89-21.56%)] than with SC [32.1% (95% CI, 24.29-40.70%)] administration (p = 0.0005). CONCLUSIONS: These results demonstrate bioequivalence between peginterferon beta-1a IM and SC and support the consideration of IM injection of peginterferon beta-1a as a viable treatment option in patients with RRMS and RMS.

Antimicrobial activity, structural evaluation and vibrational (FT-IR and FT-Raman) study of pyrrole containing vinyl derivatives.

In this paper we present structural and vibrational study of three vinylpyrrole derivatives: 2-Cyano-3-(1H-pyrrol-2-yl)-acrylamide (CPA), 1-(1H-Pyrrol-2-yl)-Pent-1-en-3-one (PP) and 1-(1H-Pyrrol-2-yl)-but-1-en-3-one (PB), using ab initio, DFT and experimental approaches. The quantum chemical calculation have been performed on B3LYP method and 6-311+G(d,p) basis set. The experimental FT-IR and Raman wavenumbers were compared with the respective theoretical values obtained from DFT calculations and found to agree well. The experimental FT-IR and Raman study clearly indicate that the compound exist as dimer in solid state. The binding energies of (CPA), (PP) and (PB) dimers are found to be 20.95, 18.75 and 19.18 kcal/mol, respectively. The vibrational analysis shows red shifts in v(N-H) and v(C=O) stretching as result of dimer formation. Stability of the molecule arising from hyperconjugative interactions and charge delocalization has been analyzed using NBO analysis. Topological and energetic parameters reveal the nature of interactions in dimer. The local electronic descriptors analyses were used to predict the reactive sites in the molecule. Calculated first static hyperpolarizability of CPA, PP and PB is found to be 10.41×10(-30), 18.93×10(-30), 18.29×10(-30) esu, respectively, shows that investigated molecules will have non-linear optical response and might be used as non-linear optical (NLO) material. These vinylpyrrole compounds (CPA), (PP) and (PB) showed antifungal and antibacterial activity against Aspergillus niger and gram-positive bacteria Bacillus subtili.

Vibrational spectra, electronic absorption, nonlinear optical properties, evaluation of bonding, chemical reactivity and thermodynamic properties of ethyl 4-(1-(2-(hydrazinecarbonothioyl)hydrazono)ethyl)-3,5-dimethyl-1H-pyrrole-2-carboxylate molecule by ab initio HF and density functional methods.

In this work, detailed vibrational spectral analysis of ethyl 4-(1-(2-(hydrazinecarbonothioyl)hydrazono)ethyl)-3,5-dimethyl-1H-pyrrole-2-carboxylate (EHCHEDPC) molecule has been carried out using FT-IR spectroscopy and potential energy distribution (PED). Theoretical calculations were performed by ab initio RHF and density functional theory (DFT) method, using 6-31G(d,p) and 6-311+G(d,p) basis sets. The other carried outwork cover: structural, thermodynamic properties, electronic transitions, bonding, multiple interaction, chemical reactivity and hyperpolarizability analysis. The results of the calculation were applied to the simulated spectra of (EHCHEDPC), which show excellent agreement with observed spectra. The vibrational analysis shows red shift in both group, the proton donor (pyrrole N-H) and proton acceptor (C=O of ester) indicating the presence of intermolecular hydrogen bonding. Time dependent density functional theory (TD-DFT) has been used to find electronic excitations and their nature. The results of natural bond orbital (NBOs) analysis show the charges transfer and delocalization in various intra- and intermolecular interactions. The binding energy of intermolecular multiple interactions is calculated to be 12.54 kcal mol(-1) using QTAIM calculation. The electronic descriptors analyses reveal the investigated molecule used as precursor for heterocyclic derivatives synthesis. First hyperpolarizability (ß0) has been computed to evaluate non-linear optical (NLO) response.