Water Vapor Induced Superionic Conductivity in ZnPS3.

Next-generation batteries based on sustainable multivalent working ions, such as Mg2+, Ca2+, or Zn2+, have the potential to improve the performance, safety, and capacity of current battery systems. Development of such multivalent ion batteries is hindered by a lack of understanding of multivalent ionics in solids, which is crucial for many aspects of battery operation. For instance, multivalent ionic transport was assumed to be correlated with electronic transport; however, we have previously shown that Zn2+ can conduct in electronically insulating ZnPS3 with a low activation energy of 350 meV, albeit with low ionic conductivity. Here, we show that exposure of ZnPS3 to environments with water vapor at different relative humidities results in room-temperature conductivity increases of several orders of magnitude, reaching as high as 1.44 mS cm-1 without decomposition or structural changes. We utilize impedance spectroscopy with ion selective electrodes, ionic transference number measurements, and deposition and stripping of Zn metal, to confirm that both Zn2+ and H+ act as mobile ions. The contribution from Zn2+ to the ionic conductivity in water vapor exposed ZnPS3 is high, representing superionic Zn2+ conduction. The present study demonstrates that it is possible to enhance multivalent ion conduction of electronically insulating solids as a result of water adsorption and highlights the importance of ensuring that increased conductivity in water vapor exposed multivalent ion systems is in fact due to mobile multivalent ions and not solely H+.

Mixed X-Site Formate-Hypophosphite Hybrid Perovskites.

Following the recent discovery of a new family of hybrid ABX3 perovskites where X=(H2 POO)- (hypophosphite), this work reports a facile synthesis for mixed X-site formate perovskites of composition [GUA]Mn(HCOO)3-x (H2 POO)x , with two crystallographically distinct, partially ordered intermediate phases with x=0.84 and 1.53, corresponding to ca. 30 and 50 mol % hypophosphite, respectively. These phases are characterised by single-crystal XRD and solid-state NMR spectroscopy, and their magnetic properties are reported.

[Am]Mn(H2POO)3: A New Family of Hybrid Perovskites Based on the Hypophosphite Ligand.

A family of five hybrid ABX3 perovskites has been synthesized using hypophosphite (H2POO)- as the X-site ion. These compounds adopt the general formula [Am]Mn(H2POO)3, where Am = guanidinium (GUA), formamidinium (FA), imidazolium, triazolium, and dabconium. We explore the diverse structural and phase transition behavior of these materials through single-crystal diffraction measurements and demonstrate contrasting magnetism in two of the phases, Am = GUA and FA, that arises from structural distortions. The results show that hypophosphite perovskites offer a promising platform for generating new functional materials.

Thermal Stabilization of Metal-Organic Framework-Derived Single-Site Catalytic Clusters through Nanocasting.

Metal-organic frameworks (MOFs) provide convenient systems for organizing high concentrations of single catalytic sites derived from metallic or oxo-metallic nodes. However, high-temperature processes cause agglomeration of these nodes, so that the single-site character and catalytic activity are lost. In this work, we present a simple nanocasting approach to provide a thermally stable secondary scaffold for MOF-based catalytic single sites, preventing their aggregation even after exposure to air at 600 °C. We describe the nanocasting of NU-1000, a MOF with 3 nm channels and Lewis-acidic oxozirconium clusters, with silica. By condensing tetramethylorthosilicate within the NU-1000 pores via a vapor-phase HCl treatment, a silica layer is created on the inner walls of NU-1000. This silica layer provides anchoring sites for the oxozirconium clusters in NU-1000 after the organic linkers are removed at high temperatures. Differential pair distribution functions obtained from synchrotron X-ray scattering confirmed that isolated oxozirconium clusters are maintained in the heated nanocast materials. Pyridine adsorption experiments and a glucose isomerization reaction demonstrate that the clusters remain accessible to reagents and maintain their acidic character and catalytic activity even after the nanocast materials have been heated to 500-600 °C in air. Density functional theory calculations show a correlation between the Lewis acidity of the oxozirconium clusters and their catalytic activity. The ability to produce MOF-derived materials that retain their catalytic properties after exposure to high temperatures makes nanocasting a useful technique for obtaining single-site catalysts suitable for high-temperature reactions.

Generalized approach to the microstructure direction in metal oxide ceramics via polymerization-induced phase separation.

When three-dimensionally ordered macroporous (3DOM) materials are synthesized in polymeric colloidal crystal templates using a Pechini-type approach, polymerization-induced phase separation (PIPS) can occur. Depending on the reaction conditions, the porous products have a variety of morphologies, including an extended inverse opal structure, bicontinuous networks of 3DOM materials interrupted by extended voids, uniform 3DOM microspheres, sheet structures of templated macroporous oxides, and hollow particles obtained by structural disassembly. In this study, the mechanism underpinning morphology control of 3DOM metal oxides through PIPS is elucidated for Ce(0.5)Mg(0.5)O(1.5) and CeO(2) systems. The mechanistic information is then applied to synthesize target morphologies for Mn(3)O(4) and Fe(2)O(3)/Fe(3)O(4) systems, demonstrating the more general nature of the synthetic approach for aqueous metal precursors that can be complexed with citric acid. The effects of reactant balance, complexation behavior, processing temperature, and template sphere size are related directly to the microstructures obtained. The predominant controlling factor of microstructural evolution in PIPS Pechini precursors is found to be the degree of polymerization of the polyester, which can be controlled through tailoring the reagent imbalance. 3DOM microspheres produced by the method are between 0.5 and 3 µm in size, with polydispersities below 25%.

Knots are not for naught: Design, properties, and topology of hierarchical intertwined microarchitected materials.

Lightweight and tough engineered materials are often designed with three-dimensional hierarchy and interconnected structural members whose junctions are detrimental to their performance because they serve as stress concentrations for damage accumulation and lower mechanical resilience. We introduce a previously unexplored class of architected materials, whose components are interwoven and contain no junctions, and incorporate micro-knots as building blocks within these hierarchical networks. Tensile experiments, which show close quantitative agreements with an analytical model for overhand knots, reveal that knot topology allows a new regime of deformation capable of shape retention, leading to a ~92% increase in absorbed energy and an up to ~107% increase in failure strain compared to woven structures, along with an up to ~11% increase in specific energy density compared to topologically similar monolithic lattices. Our exploration unlocks knotting and frictional contact to create highly extensible low-density materials with tunable shape reconfiguration and energy absorption capabilities.

Hypophosphite hybrid perovskites: a platform for unconventional tilts and shifts.

Following the recent discovery of the [A]Mn(H2POO)3 (H2POO- = hypophosphite) perovskite family, we report the A = [NH2(CH3)2]+ (dimethylammonium, DMA) member. This phase shows an unusually large unit cell due to the position of the A-site cation within the perovskite cage windows rather than the centre, as is the norm. We discuss the tendency of the hypophosphite perovskite skeleton to accommodate differently shaped A-site cations through the generation of unconventional tilts and columnar shifts, then enumerate these tilts and shifts for all known [A]Mn(H2POO)3 phases.

Mean-field equations for neuronal networks with arbitrary degree distributions.

The emergent dynamics in networks of recurrently coupled spiking neurons depends on the interplay between single-cell dynamics and network topology. Most theoretical studies on network dynamics have assumed simple topologies, such as connections that are made randomly and independently with a fixed probability (Erdös-Rényi network) (ER) or all-to-all connected networks. However, recent findings from slice experiments suggest that the actual patterns of connectivity between cortical neurons are more structured than in the ER random network. Here we explore how introducing additional higher-order statistical structure into the connectivity can affect the dynamics in neuronal networks. Specifically, we consider networks in which the number of presynaptic and postsynaptic contacts for each neuron, the degrees, are drawn from a joint degree distribution. We derive mean-field equations for a single population of homogeneous neurons and for a network of excitatory and inhibitory neurons, where the neurons can have arbitrary degree distributions. Through analysis of the mean-field equations and simulation of networks of integrate-and-fire neurons, we show that such networks have potentially much richer dynamics than an equivalent ER network. Finally, we relate the degree distributions to so-called cortical motifs.