Increased hydrophilicity of lignin-derivable vs. bisphenol-based polysulfones for potential water filtration applications.

The functionality inherent in lignin-derivable aromatics (e.g., polar methoxy groups) can provide a potential opportunity to improve the hydrophilicity of polysulfones (PSfs) without the need for the additional processing steps and harsh reagents/conditions that are typically used in conventional PSf modifications. As determined herein, lignin-derivable PSfs without any post-polymerization modification exhibited higher hydrophilicity than comparable petroleum-based PSfs (commercial/laboratory-synthesized) and also demonstrated similar hydrophilicity to functionalized BPA-PSfs reported in the literature. Importantly, the lignin-derivable PSfs displayed improved thermal properties relative to functionalized BPA-PSfs in the literature, and the thermal properties of these bio-derivable PSfs were close to those of common non-functionalized PSfs. In particular, the glass transition temperature (T g) and degradation temperature of 5% weight loss (T d5%) of lignin-derivable PSfs (T g ∼165-170 °C, T d5% ∼400-425 °C) were significantly higher than those of typical functionalized BPA-PSfs in the literature (T g ∼110-160 °C, T d5% ∼240-260 °C) and close to those of unmodified, commercial/laboratory-synthesized BPA-/bisphenol F-PSfs (T g ∼180-185 °C, T d5% ∼420-510 °C).

Zwitterionic Copolymers for Anti-Scaling Applications in Simulated Spaceflight Wastewater Scenarios.

Water reclamation in spaceflight applications, such as those encountered on the International Space Station (ISS), requires complex engineering solutions to ensure maximum water recovery. Current vapor compression distillation (VCD) technologies are effective but produce highly concentrated brines and often cause scaling within a separation system. This work evaluates initial steps toward integrating pervaporation, a membrane separation process, as a brine management strategy for ISS wastewaters. Pervaporation performs separations driven by a chemical potential difference across the membrane created by either a sweep gas or a vacuum pull. Pervaporation membranes, as with most membrane processes, can be subject to scaling. Therefore, this work studies the anti-scaling properties of zwitterions (polymeric molecules with covalently tethered positive and negative ions) coated onto sulfonated pentablock terpolymer block polymer (Nexar) pervaporation membrane surfaces. We report a method for applying zwitterions to the surface of pervaporation membranes and the effect on performance parameters such as flux and scaling resistance. Membranes with zwitterions had up to 53% reduction in permeance but reduced scaling. The highest amount of scaling occurred in the samples exposed to calcium chloride, and uncoated membranes had weight percent increases as high as 1617 ± 241%, whereas zwitterion-coated membranes experienced only about 317 ± 87% weight increase in the presence of the same scalant.