RESUMO
We study the frequency chirp properties of graphene-on-silicon electro-absorption modulators (EAMs). By experimentally measuring the chirp of a 100 µm long single layer graphene EAM, we show that the optoelectronic properties of graphene induce a large positive linear chirp on the optical signal generated by the modulator, giving rise to a maximum shift of the instantaneous frequency up to 1.8 GHz. We exploit this peculiar feature for chromatic-dispersion compensation in fiber optic transmission thanks to the pulse temporal lensing effect. In particular, we show dispersion compensation in a 10Gb/s transmission experiment on standard single mode fiber with temporal focusing distance (0-dB optical-signal-to-noise ratio penalty) of 60 km, and also demonstrate 100 km transmission with a bit error rate largely lower than the conventional Reed-Solomon forward error correction threshold of 10-3.
RESUMO
We report for the first time and characterize experimentally the complex optical conductivity of graphene on silicon photonic waveguides. This permits us to predict accurately the behavior of photonic integrated devices encompassing graphene layers. Exploiting a Si microring add/drop resonator, we show the effect of electrical gating of graphene on the complex effective index of the waveguide by measuring both the wavelength shift of the resonance and the change in the drop peak transmission. Due to electro-refractive effect of graphene a giant (>10-3) change in the effective index is demonstrated for the first time on Si photonics waveguides and this large effect will crucially impact performances and consumption of Si photonics devices. We confirmed the results by two independent experiments involving two different gating schemes: Si gating through the ridge waveguide, and polymer-electrolyte gating. Both the experiments demonstrate a very large phase effect in good agreement with numerical calculations. The reported results validate the Kubo model for the case of graphene-Si photonics interfaces and for propagation in this type of waveguide. This is fundamental for the next design and fabrication of future graphene-silicon photonics devices.
RESUMO
A circuit for the management of any arbitrary polarization state of light is demonstrated on an integrated silicon (Si) photonics platform. This circuit allows us to adapt any polarization into the standard fundamental TE mode of a Si waveguide and, conversely, to control the polarization and set it to any arbitrary polarization state. In addition, the integrated thermal tuning allows kilohertz speed which can be used to perform a polarization scrambler. The circuit was used in a WDM link and successfully used to adapt four channels into a standard Si photonic integrated circuit.
RESUMO
We report on a novel near infrared SiGe phototransistor fabricated by a standard silicon photonics foundry. The device is first investigated by simulations. The fabricated devices are characterized in terms of current-voltage characteristics at different optical power. Typical phototransistors exhibit 1.55µm record responsivity at low optical power exceeding 232A/W and 42A/W at 5V and 1V bias, respectively. A differential detection scheme is also proposed for the dark current cancellation to significantly increase the device sensitivity.
RESUMO
Graphene integrated photonics provides several advantages over conventional Si photonics. Single layer graphene (SLG) enables fast, broadband, and energy-efficient electro-optic modulators, optical switches and photodetectors (GPDs), and is compatible with any optical waveguide. The last major barrier to SLG-based optical receivers lies in the current GPDs' low responsivity when compared to conventional PDs. Here we overcome this by integrating a photo-thermoelectric GPD with a Si microring resonator. Under critical coupling, we achieve >90% light absorption in a ~6 µm SLG channel along a Si waveguide. Cavity-enhanced light-matter interactions cause carriers in SLG to reach ~400 K for an input power ~0.6 mW, resulting in a voltage responsivity ~90 V/W, with a receiver sensitivity enabling our GPDs to operate at a 10-9 bit-error rate, on par with mature semiconductor technology, but with a natural generation of a voltage, rather than a current, thus removing the need for transimpedance amplification, with a reduction of energy-per-bit, cost, and foot-print.
RESUMO
One of the main challenges of next generation optical communication is to increase the available bandwidth while reducing the size, cost and power consumption of photonic integrated circuits. Graphene has been recently proposed to be integrated with silicon photonics to meet these goals because of its high mobility, fast carrier dynamics and ultra-broadband optical properties. We focus on graphene photodetectors for high speed datacom and telecom applications based on the photo-thermo-electric effect, allowing for direct optical power to voltage conversion, zero dark current, and ultra-fast operation. We report on a chemical vapour deposition graphene photodetector based on the photo-thermoelectric effect, integrated on a silicon waveguide, providing frequency response >65 GHz and optimized to be interfaced to a 50 Ω voltage amplifier for direct voltage amplification. We demonstrate a system test leading to direct detection of 105 Gbit s-1 non-return to zero and 120 Gbit s-1 4-level pulse amplitude modulation optical signals.