Ceramics with the signature of wood: a mechanical insight.

In an attempt to mimic the outstanding mechanical properties of wood and bone, a 3D heterogeneous chemistry approach has been used in a biomorphic transformation process (in which sintering is avoided) to fabricate ceramics from rattan wood, preserving its hierarchical fibrous microstructure. The resulting material (called biomorphic apatite â€‹[BA] henceforth) possesses a highly bioactive composition and is characterised by a multiscale hierarchical pore structure, based on nanotwinned hydroxyapatite lamellae, which is shown to display a lacunar fractal nature. The mechanical properties of BA are found to be exceptional (when compared with usual porous hydroxyapatite and other ceramics obtained from wood through sintering) and unique â€‹as they occupy a zone in the Ashby map previously free from ceramics, but not far from wood and bone. Mechanical tests show the following: (i) the strength in tension may exceed that in compression, (ii) failure in compression involves complex exfoliation patterns, thus resulting in high toughness, (iii) unlike in sintered porous hydroxyapatite, fracture does not occur 'instantaneously,' â€‹but its growth may be observed, and it exhibits tortuous patterns that follow the original fibrillar structure of wood, thus yielding outstanding toughness, (iv) the anisotropy of the elastic stiffness and strength show unprecedented values when situations of stresses parallel and orthogonal to the main channels are compared. Despite being a ceramic material, BA displays a mechanical behavior similar on the one hand to the ligneous material from which it was produced (therefore behaving as a 'ceramic with the signature of wood') and on the other hand to the cortical/spongy osseous complex constituting the structure of compact bone.

New hydroxyapatite nanophases with enhanced osteogenic and anti-bacterial activity.

This work describes the synthesis and characterization of new apatite phases co-doped with gallium, magnesium and carbonate, exhibiting osteogenic and antibacterial ability. The apatites are synthesized at low temperature to retain nanocrystallinity and controlled doping with the various bioactive foreign ions, as assessed by physico-chemical and crystallographic analyses, reporting the achievement of single phases with reduced crystal ordering. The analysis of single and multi-doped apatites reports to different mechanisms acting in the incorporation of gallium and magnesium ions in the apatite structure. The release of bioactive ions is correlated to the behavior of human mesenchymal stem cells and of different bacterial strands, selected among the most frequently affecting surgical procedures. Enhanced osteogenic and antibacterial ability is assessed in multi-doped apatites, thus suggesting potential future applications as new smart biomaterials integrating a significant boosting of bone regeneration with adequate protection against bacteria. © 2017 Wiley Periodicals Inc. J Biomed Mater Res Part A: 106A: 521-530, 2018.

Bone regeneration in a rabbit critical femoral defect by means of magnetic hydroxyapatite macroporous scaffolds.

Magnetic scaffolds have recently attracted significant attention in tissue engineering due to the prospect of improving bone tissue formation by conveying soluble factors such as growth factors, hormones, and polypeptides directly to the site of implantation, as well as to the possibility of improving implant fixation and stability. The objective of this study was to compare bone tissue formation in a preclinical rabbit model of critical femoral defect treated either with a hydroxyapatite (HA)/magnetite (90/10 wt %) or pure HA porous scaffolds at 4 and 12 weeks after implantation. The biocompatibility and osteogenic activity of the novel magnetic constructs was assessed with analysis of the amount of newly formed bone tissue and its nanomechanical properties. The osteoconductive properties of the pure HA were confirmed. The HA/magnetite scaffold was able to induce and support bone tissue formation at both experimental time points without adverse tissue reactions. Biomechanically, similar properties were obtained from nanoindentation analysis of bone formed following implantation of magnetic and control scaffolds. The results indicate that the osteoconductive properties of an HA scaffold are maintained following inclusion of a magnetic component. These provide a basis for future studies investigating the potential benefit in tissue engineering of applying magnetic stimuli to enhance bone formation. © 2017 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 106B: 546-554, 2018.

Porosity-graded hydroxyapatite ceramics to replace natural bone.

Porous hydroxyapatite HA bodies were prepared with an aim to simulate bone tissue morphology. By varying the characteristics of starting HA powders and the impregnation strategy of cellulosic sponges with rheologically optimized slurries, a wide range of physico-chemical and mechanical properties of the porous ceramics can be obtained. The samples were characterized microstructurally, by density and porosimetry and by mechanical strength. Cylindrical specimens exhibiting a porosity gradient showed a promising behaviour after implantation in rabbits' femur: newly formed bone grew in tight contact with the ceramic in a very short time, no modified cells are induced and bone tissue fills even the inner pores.