Influence of TiIV substitution on the properties of a Li1.5Al0.5Ge1.5(PO4)3 nanofiber-based solid electrolyte.

We report the influence of the partial substitution of Ge with Ti on the properties of NASICON Li1.5Al0.5Ge1.5(PO4)3 (LAGP) nanofibers prepared by electrospinning. Replacing a small amount of Ge (up to 20%) with Ti is advantageous for enhancing both the purity and morphology of LAGP fibers, as observed by X-ray diffraction, electron microscopy and nuclear magnetic resonance spectroscopy. When Ti-substituted LAGP (LAGTP) fibers are used as filler to develop composite polymer electrolytes, the ionic conductivity at 20 °C improves by a factor of 1.5 compared to the plain polymer electrolyte. Additionally, above 40 °C the LAGTP fiber-based composite electrolytes were more conductive than the equivalent LAGP fiber-based one. We believe that these findings can make a substantial contribution to optimizing current methods and developing novel synthesis approaches for NASICON based electrolytes.

High Capacity and High Efficiency Maple Tree-Biomass-Derived Hard Carbon as an Anode Material for Sodium-Ion Batteries.

Sodium-ion batteries (SIBs) are in the spotlight because of their potential use in large-scale energy storage devices due to the abundance and low cost of sodium-based materials. There are many SIB cathode materials under investigation but only a few candidate materials such as carbon, oxides and alloys were proposed as anodes. Among these anode materials, hard carbon shows promising performances with low operating potential and relatively high specific capacity. Unfortunately, its low initial coulombic efficiency and high cost limit its commercial applications. In this study, low-cost maple tree-biomass-derived hard carbon is tested as the anode for sodium-ion batteries. The capacity of hard carbon prepared at 1400 °C (HC-1400) reaches 337 mAh/g at 0.1 C. The initial coulombic efficiency is up to 88.03% in Sodium trifluoromethanesulfonimide (NaTFSI)/Ethylene carbonate (EC): Diethyl carbonate (DEC) electrolyte. The capacity was maintained at 92.3% after 100 cycles at 0.5 C rates. The in situ X-ray diffraction (XRD) analysis showed that no peak shift occurred during charge/discharge, supporting a finding of no sodium ion intercalates in the nano-graphite layer. Its low cost, high capacity and high coulombic efficiency indicate that hard carbon is a promising anode material for sodium-ion batteries.