RESUMO
This investigation is centered on the effectiveness of methylene blue (MB), a cationic dye, adsorbed from an aqueous media by H3PO4 activated papaya skin/peels (PSPAC), with initial pH (2-10), contact time (30-180 min), MB dye concentration (varying from 10 to 50 mg/L), and MB dose (0.1-0.5 gm). The findings show that the best optimal conditions for MB dye removal occur at a 6 pH, 0.3 gm dose of PSPAC adsorbent for 10 mg/L MB dye concentration, with 90 min of contact time. To optimize and validate the extraction efficiency of MB dye, a response surface methodology (RSM) study was conducted using a central composite design (CCD) with a regression model showing R2 = 0.9940. FT-IR spectroscopy shows, CO, and O-H stretching functional groups while FE-SEM is assessed to supervise morphological features of the PSPAC adsorbent. The peak adsorption capacity with 46.95 mg/g for the Langmuir isotherm model conveniently satisfies the adsorption process with R2 = 0.9984 while with R2 = 0.999, a kinetic model, pseudo-second-order, confirms MB dye adsorption by PSPAC adsorbent. Moreover, thermodynamic parameters including ΔGáµ, ΔH°, and ΔS° were computed and found to be spontaneous and exothermic. Furthermore, regeneration studies employed with NaOH (0.1 M) and HCl (0.1 M) solution media show an acceptable MB removal efficiency consecutive up to three cycles. The study highlights that H3PO4 papaya skin/peel (PSPAC) is an effectual, sustainable, reasonably available biosorbent to remove industrial cationic dyes disposal.
Assuntos
Carica , Poluentes Químicos da Água , Azul de Metileno/química , Corantes/química , Cinética , Espectroscopia de Infravermelho com Transformada de Fourier , Concentração de Íons de Hidrogênio , Termodinâmica , Água , AdsorçãoRESUMO
Mushroom waste substrates are highly resistant lignocellulosic wastes that are commercially produced by industries after harvesting. These wastes produce large environmental challenges regarding disposal and, thus, require treatment facilities. In the present article, the effect of Eisenia-fetida-based vermicomposting and an effective microorganism solution on the mushroom waste substrate were investigated using four different composting mixtures: mushroom waste [MW] substrate composting with effective microorganisms [MW+EM], raw mushroom waste [RWM] substrate composting with effective microorganisms [RMW+EM], mushroom waste substrate composting with vermicomposting and effective microorganisms [MW+V+EM], and raw mushroom waste substrate composting with vermicomposting and effective microorganisms [RWM+V+EM]. This article discusses the structural and physiochemical changes at four samples for 45 days (almost six weeks) of composting. The physical and chemical parameters were monitored during composting and provided information on the duration of the process. The results indicated pH (7.2~8), NPK value (0.9~1.8), and C:N ratio <14, and heavy metals exhibited a decreasing trend in later stages for all sets of compost materials and showed the maturity level. FTIR spectra revealed that all four samples included peaks for the -OH (hydroxy group) ranging from 3780 to 3500 cm−1 and a ridge indicating the C=C (alkenyl bond) ranging from 1650 to 1620 cm−1 in compost. The X-ray diffraction spectrum clearly shows how earthworms and microbes break down molecules into cellulose compounds, and the average crystallinity size using Scherrer's equation was found to be between 69.82 and 93.13 nm. Based on the experimental analysis, [RWM+V+EM] accelerated the breakdown of organic matter and showed improvement compared with other composts in compostable materials, thus, emphasizing the critical nature of long-term mushroom waste management and treatment.