Occurrence, Concentration, and Distribution of 35 PFASs and Their Precursors Retained in 20 Stormwater Biofilters.

Current knowledge about the fate and transport behaviors of per- and polyfluoroalkyl substances (PFASs) in urban stormwater biofilter facilities is very limited. C5-14,16 perfluoroalkyl carboxylic acids [perfluorinated carboxylic acids (PFCAs)], C4,8,10 perfluoroalkanesulfonic acids (PFSAs), methyl-perfluorooctane sulfonamide acetic acid (MeFOSAA, a PFSA precursor), and unknown C6-8 PFCA and perfluorooctanesulfonic acid precursors were frequently found in bioretention media and forebay sediments at Σ35PFAS concentrations of <0.03-19 and 0.064-16 µg/kg-DW, respectively. Unknown C6-8 PFCA precursor concentrations were up to ten times higher than the corresponding PFCAs, especially at forebays and biofilters' top layer. No significant trend could be attributed to PFAS and precursor concentrations versus depth of filter media, though PFAS concentrations were 2-3 times higher in the upper layers on average (significant difference between the upper (0-5 cm) and deepest (35-50 cm) layer). PFASs had a similar spatial concentration distribution in each filter media (no clear difference between short- and long-chain PFASs). Commercial land use and organic matter were important factors explaining the concentration variations among the biofilters and between the sampling depths, respectively. Given the comparable PFAS accumulations in deeper and superficial layers and possible increased mobility after precursor biotransformation, designing shallow-depth, nonamended sand biofilters or maintaining only the top layer may be insufficient for stormwater PFAS management.

Holistic evaluation of inlet protection devices for sediment control on construction sites.

To address the deleterious impacts of excess soil erosion from the construction sites, the United States Clean Water Act requires that erosion and sediment control measures (ESCs) be implemented on construction projects disturbing more than 0.4 ha. Inlet protection devices (IPDs) are a common ESC utilized on construction projects to reduce the amount of sediment entering storm sewers. In Ohio, regulatory agencies use approved, non-proprietary IPDs made from commonly available materials (e.g., silt fence, geotextile, lumber, and aggregate) to mitigate sediment on construction projects; however, these IPDs often rely on extended ponding to remove sediment and require frequent maintenance making these unsuitable for road construction projects. Commercially manufactured (i.e., proprietary) IPDs which rely on filtration to quickly dewater following rainfall may prove more practical for road construction projects. However, little research which quantitatively compares the holistic performance of these two types of IPDs in field settings has been performed to date. To address this knowledge gap, the performance of 24 proprietary IPDs was evaluated at field-scale using simulated construction site runoff and compared to three non-proprietary IPDs currently approved for use in Ohio. Bypass flows, which typically occurred due to poor IPD fit to standard drainage inlets used in Ohio transportation settings, significantly increased effluent total suspended solids (TSS) and turbidity compared to tests of IPDs where bypass did not occur. Overflow, or intentional bypass around primary IPD flow pathways during high flows, did not significantly impact effluent water quality. Despite differences in treatment mechanisms (i.e., sedimentation versus filtration), the water quality performance of non-proprietary and proprietary IPDs were not statistically different, indicating comparable sediment removal was provided by both categories. Findings from this research can provide design engineers and state regulatory agencies the necessary tools to evaluate IPD performance in road construction settings and, ultimately, alleviate the impact of excess sediment discharged from construction sites.

The potential to manage releases of Bacillus anthracis using bioretention and a high flow media filter: Results of simulated runoff testing with tracer spores Bacillus globigii.

The threat of bioterrorism has spurred research on the decontamination and containment of different agents. Anthrax [causative agent Bacillus anthracis (Ba)] is a disease that can lead to severe infections within human and animals, particularly when inhaled. This research investigated the use of spore-contaminated simulated runoff events into stormwater control measures (SCMs), which are designed to retain and improve the quality of runoff and may have the potential to filter and contain the spores. In this study, the effectiveness of a bioretention cell (BRC) and high flow media filter (HFMF) in Huron, Ohio, were evaluated for removal of Bacillus globigii (Bg) spores (a harmless cognate of Ba). Three 4-8 mm simulated runoff events were created for each SCM using a fire hydrant and Bg spores were injected into the runoff upstream of the SCM inlets. The BRC significantly (p < 0.001) outperformed the HFMF in reducing Bg concentrations and loads, with an average load reduction of 1.9 log (∼99% reduction) compared to 0.4 (∼60% reduction), respectively. A probable critical design factor leading to these differences was the infiltration rate of the media and subsequent retention time within the filters, which was supported by similar disparities in suspended solids reductions. Differences in spore removal may also have been due to particle size distribution of the HFMF, which was more gravelly than the bioretention cell. At 3 and 6 months after the-simulated runoff tests, soil samples taken from both SCMs, yielding detectable Bg spores within the top 15 cm of media, with increased spore concentrations where ponding occurred for longer durations during the tests. This suggests that forebays and areas near inlets may be hotspots for spore cleanup in a real-world bioterrorism incident.

Monitoring the impacts of rainfall characteristics on sediment loss from road construction sites.

Exposed soils associated with active construction sites provide opportunities for erosion and sediment transport during storm events, introducing risks associated with excess sediment to downstream infrastructure and aquatic biota. A better understanding of the drivers of sediment transport in construction site runoff is needed to improve the design and performance of erosion and sediment control measures (ESCMs). Eleven monitoring locations on 3 active road construction sites in central Ohio were established to characterize runoff quality from points of concentrated flow during storm events. Grab samples were analyzed for total suspended solids (TSS), turbidity, and particle size distribution (PSD). Median TSS concentrations and turbidity levels across all samples were 626 mg/L (range 25-28,600 mg/L) and 759 NTU (range 22-33,000 NTU), respectively. The median PSD corresponded to a silty clay loam, mirroring the soil texture of much of Ohio's subsoils. TSS concentrations and turbidity were significantly positively correlated with the rainfall intensity 10 min prior to sample collection, suggesting that higher flow rates created greater shear stress on bare soil which resulted in more erosion. Conversely, rainfall duration was negatively correlated with particle size, indicating that prolonged moisture from rainfall promoted the dispersion of soil aggregates which mobilized smaller particles. Multivariable linear regression models revealed that higher rainfall intensities corresponded to higher turbidity values, while higher TSS concentrations were associated with higher rainfall intensities, depths, and durations. Results from this study highlight the importance of reducing raindrop impact and subsequent shear stress applied by concentrated flows through the use of ESCMs to limit sediment export from construction sites.

Mosquito abundance and diversity in central Ohio, USA vary among stormwater wetlands, retention ponds, and detention ponds and their associated environmental parameters.

Mosquitoes (Diptera: Culicidae) are one of the most impactful pests to human society, both as a nuisance and a potential vector of human and animal pathogens. Mosquito larvae develop in still aquatic environments. Eliminating these habitats near high human density or managing them to reduce the suitability for mosquitoes will reduce mosquito populations in these human environments and decrease the overall negative impact of mosquitoes on humans. One common source of standing water in urban and suburban environments is the water that pools in stormwater control measures. Previous studies have shown that some stormwater control measures generate large numbers of mosquitoes while others harbor none, and the reason for this difference remains unclear. Our study focuses on elucidating the factors that cause a stormwater control measure to be more or less suitable for mosquitoes. During the summers of 2021 and 2022, we collected and identified mosquito larvae from thirty stormwater control measures across central Ohio to assess variation in mosquito abundance and diversity among sites. Our goal was to determine if specific types of stormwater control measures (retention ponds, detention ponds, or constructed wetlands) harbored different abundances of mosquitoes or different community structures. We also assessed environmental parameters of these sites to elucidate their effects on mosquito abundance and diversity. Overall, we recorded the highest number of mosquito larvae and species in constructed wetlands. However, these sites were dominated by the innocuous species, Culex territans. Conversely, detention ponds held fewer mosquitoes but a higher proportion of known vector species, including Culex pipiens and Aedes vexans. The total number of mosquitoes across all sites was correlated with higher vegetation, more shade, lower water temperatures, and lower pH, suggesting stormwater control measures with these features may also be hotspots for mosquito proliferation.