Polythiophenes and polythiophene-based composites in amperometric sensing.

This overview of polythiophene-based materials provides a critical examination of meaningful examples of applications of similar electrode materials in electroanalysis. The advantages arising from the use of polythiophene derivatives in such an applicative context is discussed by considering the organic conductive material as such, and as one of the components of hybrid materials. The rationale at the basis of the combination of two or even more individual components into a hybrid material is discussed with reference to the active electrode processes and the consequent possible improvements of the electroanalytical performance. In this respect, study cases are presented considering different analytes chosen among those that are most frequently reported within the classes of organics and inorganics. The use of a polythiophene matrix to stably fix biological elements at the electrode surface for the development of catalytic biosensors and genosensors is also discussed. Finally, a few possible lines along which the next research in the field could be fruitfully pursued are outlined. Furthermore, the work still to be done to exploit the possibilities offered by novel products of organic synthesis, even along paths already traced in other fields of electrochemistry, is discussed.

[Discrepancy between histopathological diagnosis based on guided biopsy and cone biopsy of the cervix uteri: analysis of 346 cases of laser conization]. / Discrepanza tra diagnosi istopatologica su biopsia mirata e su biopsia conica della cervice uterina: analisi di 346 casi di laser-conizzazione.

The conservative management of cervical intraepithelial neoplasia (CIN) essentially depended on the introduction and improvement of colposcopy. This technique, allowing to locate the lesion, to estimate its extension and to perform multiple punch biopsies, becomes discriminant in therapeutic choice. Whether colposcopy reveals endocervical involvement or abnormal transformation zone (ANTZ) may be only partially explored, excisional conization should be preferred to ablative therapy since the former advantageously can verify histopathologic diagnosis, confirm completely excision of lesion and rule out invasive carcinoma. The literature shows that cases of invasive lesions can be underestimated and therefore inadequately treated by ablative therapy, emphasizing colposcopy and punch biopsy limitations about suspect and diagnosis of microinvasion. We analyzed data concerning preliminary diagnostic investigations and results of 346 CO2 laser excisional conizations performed between 1984 and 1993. Histopathologic diagnosis on punch biopsy, performed in 111 cases of ANTZ1 and in 235 cases of ANTZ2, shows an agreement with cone biopsy in 30.8% of the cases of CIN1, of 40.9% in cases of CIN2 and of 66.3% in cases of CIN3. Whereas the lesion is overestimated in 30.6% of cases, in which it is likely that punch biopsy has removed the epicenter of the lesion or the lesion in toto, we had an underestimation in 15% of cases, particularly in 4 cases of CIN2, in 38 cases of CIN3 and in all microinvasive processes. The rate of invasive lesions previously ignored and detected only by histopathologic diagnosis on cone biopsy is 2.9%. In only one of these cases colposcopy, even if attributing to each of these the higher grading, shows the suspicion of invasion, whereas the detection of invasive processes is missed in every case by punch biopsy.(ABSTRACT TRUNCATED AT 250 WORDS)

Classification of red wines by chemometric analysis of voltammetric signals from PEDOT-modified electrodes.

Nine different types of Italian red wines of four different varieties were analysed, without any sample pre-treatments, by voltammetric techniques using a poly(3,4-ethylenedioxythiophene)-modified electrode. The data matrices consisting of the currents measured at different potentials, by repeated Cyclic Voltammetry or Differential Pulse Voltammetry, are submitted to chemometric analysis. After explorative tests based on Principal Component Analysis, Partial Least Squares-Discriminant Analysis classification models are built both for the training and for the test sets. To this aim, different classification strategies are adopted, considering the responses from the two techniques either separately or joined together to form a data matrix including the whole voltammetric information.

Amperometric sensors based on poly(3,4-ethylenedioxythiophene)-modified electrodes: discrimination of white wines.

The voltammetric responses on selected white wines of different vintages and origins have been systematically collected by three different modified electrodes, in order to check their effectiveness in performing blind analysis of similar matrices. The electrode modifiers consist of a conducting polymer, namely poly(3,4-ethylenedioxythiophene) (PEDOT) and of composite materials of Au and Pt nanoparticles embedded in a PEDOT layer. Wine samples have been tested, without any prior treatments, with differential pulse voltammetry technique. The subsequent chemometric analysis has been carried out both separately on the signals of each sensor, and on the signals of two or even three sensors as a unique set of data, in order to check the possible complementarity of the information brought by the different electrodes. After a preliminary inspection by principal component analysis, classification models have been built and validated by partial least squares-discriminant analysis. The discriminant capability has been evaluated in terms of sensitivity and specificity of classification; in all cases quite good results have been obtained.

Development of an electronic tongue based on a PEDOT-modified voltammetric sensor.

Three different electrodes were tested for use as nonspecific amperometric sensors for blind analysis on real matrices, namely different fruit juices from different fruits or different brands. The first two electrodes were traditional Pt and Au electrodes, while the third one was modified with poly(3,4-ethylenedioxythiophene) conducting polymer. The sensors were tested separately, tested coupled to each other, and also tested together. The responses of the electrode system(s) were first screened via PCA and then their discriminant capabilities were quantified in terms of the sensitivities and specificities of their corresponding PLS-DA multivariate classification models. Particular attention was paid to analyzing the evolution of the response over subsequent potential sweeps. The modified electrode demonstrated the most discriminating ability, and it was the only system capable of satisfactorily performing the most complex task attempted during the analysis: discriminating between juices from the same fruit but from different brands. Moreover, the electrode "cleaning" procedure required between two subsequent potential sweeps was much simpler for the modified electrode than for the others. This electrode system was therefore shown to be a good candidate for use as an informative element in an electronic tongue applied to the analysis of other food matrices.

[Outpatient excision of low grade cervical intraepithelial lesions using loop diathermy]. / Exérèse ambulatoire des lésions intra-épithéliales de bas grade du col utérin à l'anse diathermique.

Twenty five years after the introduction of outpatient treatment for cervical precancers, several cases of invasive cancer after laser, cryotherapy or electrocautery have been described. As a consequence, the diathermy loop excision has recently been proposed for the treatment of cervical intraepithelial neoplasia. The new generators seem to assure a high quality of cut and allow the histological analysis of all the lesional tissue excised as deep as the laser vaporisation usually goes (7 mm). We have tested this treatment on a series of CIN I on an outpatient basis and our results confirm that loop excision can replace destructive treatments for CIN I. As for high grade lesions, we still think that laser conisation under general anesthesia remains the best choice.

Age-dependent reduction of the response of rat cardiac muscle to the phosphodiesterase inhibitor milrinone.

This study aimed to investigate whether milrinone effect on cardiac muscle contractility undergoes to age-related changes. Experiments were carried out on papillary muscles isolated from right ventricle of Brown Norway rats belonging to two different age groups: 2 month old and 18 month old. The effect of milrinone (10-100 microM) on rat cardiac muscle in vitro preparations was characterized by a reduction of peak developed tension and of contraction duration. Furthermore, the recovery of contractility after a contractile cycle, i.e. the mechanical restitution was faster in the presence of milrinone than in control conditions. All these effects were reduced in preparations from 18 month old rats compared to preparations from 2 month old rats. The decrease of milrinone effect on the mechanical restitution was particularly pronounced. The reduction of the milrinone effects is likely connected with the reduction of the maximal effect of adrenergic stimulation, although the molecular basis of this link is not yet clearly understood.

Synthesis and spectroscopic and electrochemical characterisation of a conducting polythiophene bearing a chiral beta-substituent: polymerisation of (+)-4,4 bi.

A regioregular head-to-head/ tail-to-tail poly(beta,beta'-disubstituted bithiophene) P1 was synthesised by chemical and electrochemical polymerisation of 2,2'-bithiophene that bears (S)-2-methylbutylsulfanyl chains in the beta and beta'-positions. The polymer was characterised by GPC, NMR and UV/Vis spectroscopy, CD, AFM and by electrochemical and conductivity measurements. The CD spectra of P1 in solutions in which poor solvents are present show interesting features and allow the presence of different optically active species to be distinguished. Upon varying the casting conditions of P1, different relative amounts of grainy and homogeneous aggregated phases were observed in AFM micrographies of films and corresponding negative or positive first Cotton effects were found in the CD spectra. AFM, CD and UV/Vis characterisations were also performed on an electrogenerated optically active polymer PE1, in order to make a comparison with the chemically synthesised one. The interesting, small band gap of P1 allows for easy p- and n-electrochemical doping.