Elemental Imaging of Long-term Gadolinium Retention in Rodent Femur.

Background The use of gadolinium-based contrast agents (GBCAs) is linked to gadolinium retention in the skeleton of healthy individuals. The mechanism of gadolinium incorporation into bone tissue is not fully understood and requires spatially resolved analysis to locate the gadolinium. Purpose To compare the quantitative distribution of gadolinium retained over time in rodent femur following the administration of gadodiamide and gadobutrol at three different time points. Materials and Methods In this animal study conducted between May 2018 and April 2020, 108 9-week-old healthy rats were repeatedly injected with either gadodiamide, gadobutrol, or saline solution and were killed 1, 3, or 12 months after the last injection. The femurs of six female and six male rats per each group and time point were collected. Quantitative elemental imaging of gadolinium in longitudinal thin sections was performed on one sample per sex with use of laser ablation inductively coupled plasma mass spectrometry (ICP-MS). Gadolinium concentration was determined with use of ICP-MS on the samples of all animals (six per group). Mann-Whitney U tests were applied on pairwise comparisons to determine potential sex effect and GBCA effect on gadolinium concentrations. Results The highest gadolinium retention was observed in the gadodiamide group (concentration, 97-200 nmol · g-1), exceeding the mean concentration in the gadobutrol group (6.5-17 nmol · g-1). However, the gadolinium distribution pattern was similar for both contrast agents, showing prominent gadolinium retention at endosteal surfaces, in the bone marrow, and in small tissue pores. Gadolinium distribution in cortical bone changed over time, initially showing a thin rim of higher concentration close to the periosteum, which appeared to grow wider and move toward the interior of the femur over 1 year. Conclusion For both gadolinium-based contrast agents, gadolinium retention in rat bone was initially located close to the periosteum and bone cavities and changed with bone remodeling processes. The relevance to long-term storage of gadolinium in humans remains to be determined. © RSNA, 2022 Online supplemental material is available for this article.

Heme Oxygenase Protects against Placental Vascular Inflammation and Abortion by the Alarmin Heme in Mice.

Both infectious as non-infectious inflammation can cause placental dysfunction and pregnancy complications. During the first trimester of human gestation, when palatogenesis takes place, intrauterine hematoma and hemorrhage are common phenomena, causing the release of large amounts of heme, a well-known alarmin. We postulated that exposure of pregnant mice to heme during palatogenesis would initiate oxidative and inflammatory stress, leading to pathological pregnancy, increasing the incidence of palatal clefting and abortion. Both heme oxygenase isoforms (HO-1 and HO-2) break down heme, thereby generating anti-oxidative and -inflammatory products. HO may thus counteract these heme-induced injurious stresses. To test this hypothesis, we administered heme to pregnant CD1 outbred mice at Day E12 by intraperitoneal injection in increasing doses: 30, 75 or 150 µmol/kg body weight (30H, 75H or 150H) in the presence or absence of HO-activity inhibitor SnMP from Day E11. Exposure to heme resulted in a dose-dependent increase in abortion. At 75H half of the fetuses where resorbed, while at 150H all fetuses were aborted. HO-activity protected against heme-induced abortion since inhibition of HO-activity aggravated heme-induced detrimental effects. The fetuses surviving heme administration demonstrated normal palatal fusion. Immunostainings at Day E16 demonstrated higher numbers of ICAM-1 positive blood vessels, macrophages and HO-1 positive cells in placenta after administration of 75H or SnMP + 30H. Summarizing, heme acts as an endogenous "alarmin" during pregnancy in a dose-dependent fashion, while HO-activity protects against heme-induced placental vascular inflammation and abortion.

Repair of complex ovine segmental mandibulectomy utilizing customized tissue engineered bony flaps.

Craniofacial defects require a treatment approach that provides both robust tissues to withstand the forces of mastication and high geometric fidelity that allows restoration of facial architecture. When the surrounding soft tissue is compromised either through lack of quantity (insufficient soft tissue to enclose a graft) or quality (insufficient vascularity or inducible cells), a vascularized construct is needed for reconstruction. Tissue engineering using customized 3D printed bioreactors enables the generation of mechanically robust, vascularized bony tissues of the desired geometry. While this approach has been shown to be effective when utilized for reconstruction of non-load bearing ovine angular defects and partial segmental defects, the two-stage approach to mandibular reconstruction requires testing in a large, load-bearing defect. In this study, 5 sheep underwent bioreactor implantation and the creation of a load-bearing mandibular defect. Two bioreactor geometries were tested: a larger complex bioreactor with a central groove, and a smaller rectangular bioreactor that were filled with a mix of xenograft and autograft (initial bone volume/total volume BV/TV of 31.8 ± 1.6%). At transfer, the tissues generated within large and small bioreactors were composed of a mix of lamellar and woven bone and had BV/TV of 55.3 ± 2.6% and 59.2 ± 6.3%, respectively. After transfer of the large bioreactors to the mandibular defect, the bioreactor tissues continued to remodel, reaching a final BV/TV of 64.5 ± 6.2%. Despite recalcitrant infections, viable osteoblasts were seen within the transferred tissues to the mandibular site at the end of the study, suggesting that a vascularized customized bony flap is a potentially effective reconstructive strategy when combined with an optimal stabilization strategy and local antibiotic delivery prior to development of a deep-seated infection.

Osteogenesis around CaP-coated titanium implants visualized using 3D histology and micro-computed tomography.

Calcium phosphate (CaP) coatings can enhance the performance of bone implants in compromised conditions, such as osteoporosis. Therefore, this study compared non-coated vs. CaP-coated (n = 8) titanium implants in osteoporotic ovariectomized (OVX) rats. Bone volume (BV) was assessed using micro-computer tomography (micro-CT) and three-dimensional (3D) histology, in three zones from the implant surface. Bone remodeling was assessed using fluorochrome labels and osteoclast staining. Micro-CT and 3D histology showed a BV reduction in OVX animals, of respectively 22.4 and 10.5%. BV was significantly increased inside all zones around CaP coatings, especially in the inner zone of the OVX animals. Fluorochrome labels were predominantly seen when the coating was applied. Osteoclasts were mainly found in the area remote from the surface of non-coated implants in control animals. For the coated implants, osteoclasts were distributed evenly, and present in direct vicinity of the surface. In conclusion, 3D histology is a suitable technique to obtain data and insight into bone architecture around implants at relatively high resolution. Bone formation was significantly reduced in osteoporotic animals. CaP coatings resulted in a higher BV directly around implants installed in osteoporotic animals, enhanced turnover, and a shift of remodeling activity toward the implant surface.

Bone formation analysis: effect of quantification procedures on the study outcome.

Quantification of the amount of newly formed bone is an essential part of bone regeneration studies. Histomorphometry, based on histological sections of plastic-embedded specimens, is the most frequently applied technique in this assessment. Before performing image analysis, a specific region of interest (ROI) has to be determined. Based on the histological procedure, different areas within the ROI can be discriminated and assigned to relevant tissue structures. However, in literature not much attention is paid to the effect of the histological procedures on the final outcome of the histomorphometrical measurements on bone regeneration. In this study, the histomorphometrical bone formation of the intramedullary cavity of the guinea pig tibia, filled with calcium phosphate cement, was quantified in plastic-embedded and paraffin-embedded specimens and in specimens analyzed with scanning electron microscopy in the backscattering mode (SEM-BS). The data showed that the histological procedure significantly affected the measured bone amount. Therefore, it is recommended that scaffold characteristics are carefully considered in selecting a proper technique for the analysis of bone formation in bone tissue engineering studies. The results of this study identified high-resolution SEM-BS and elastic van Gieson staining of decalcified histological sections as recommendable techniques for evaluating bone formation.