Fabricated Gamma-Alumina-Supported Zinc Ferrite Catalyst for Solvent-Free Aerobic Oxidation of Cyclic Ethers to Lactones.

The aim of this work was to fabricate a new heterogeneous catalyst as zinc ferrite (ZF) supported on gamma-alumina (γ-Al2O3) for the conversion of cyclic ethers to the corresponding, more valuable lactones, using a solvent-free method and O2 as an oxidant. Hence, the ZF@γ-Al2O3 catalyst was prepared using a deposition-coprecipitation method, then characterized using TEM, SEM, EDS, TGA, FTIR, XRD, ICP, XPS, and BET surface area, and further applied for aerobic oxidation of cyclic ethers. The structural analysis indicated spherical, uniform ZF particles of 24 nm dispersed on the alumina support. Importantly, the incorporation of ZF into the support influenced its texture, i.e., the surface area and pore size were reduced while the pore diameter was increased. The product identification indicated lactone compound as the major product for saturated cyclic ether oxidation. For THF as a model reaction, it was found that the supported catalyst was 3.2 times more potent towards the oxidation of cyclic ethers than the unsupported one. Furthermore, the low reactivity of the six-membered ethers can be tackled by optimizing the oxidant pressure and the reaction time. In the case of unsaturated ethers, deep oxidation and polymerization reactions were competitive oxidations. Furthermore, it was found that the supported catalyst maintained good stability and catalytic activity, even after four cycles.

New Method Based on the Direct Analysis in Real Time Coupled with Time-of-Flight Mass Spectrometry to Investigate the Thermal Depolymerization of Poly(methyl methacrylate).

In this work, the isothermal decomposition of poly(methyl methacrylate) synthesized in bulk by the radical route of methyl methacrylate in the presence of azobisisobutyronitrile as the initiator was carried out and monitored for the first time with the DART-Tof-MS technique at different temperatures. Nuclear magnetic resonance (NMR) analysis revealed a predominantly atactic microstructure, and size-exclusion chromatography (SEC) analysis indicated a number average molecular weight of 3 × 105 g·mol-1 and a polydispersity index of 2.47 for this polymer. Non-isothermal decomposition of this polymer carried out with thermogravimetry analysis (TGA) showed that the weight loss process occurs in two steps. The first one starts at approximately 224 °C and the second at 320 °C. The isothermal decomposition of this polymer carried out and monitored with the DART-Tof-MS method revealed only one stage of weight loss in this process, which begins at approximately 250 °C, not far from that of the second step observed in the case of the non-isothermal process conducted with the TGA method. The results obtained with the MS part of this technique revealed that the isothermal decomposition of this polymer regenerates a significant part of methyl methacrylate monomer, which increases with temperature. This process involves radical chain reactions leading to homolytic chain scissions and leading to the formation of secondary and tertiary alkyl radicals, mainly regenerating methyl methacrylate monomer through an unzipping rearrangement. Although they are in the minority, other fragments, such as the isomers of 2-methyl carboxyl, 4-methyl, penta-2,4-diene and dimethyl carbate, are also among the products detected. At 200 °C, no trace of monomer was observed, which coincides with the first step of the weight loss observed in the TGA. These compounds are different to those reported by other researchers using TGA coupled with mass spectrometry in which methyl isobutyrate, traces of methyl pyruvate and 2,3-butanonedione were detected.

Activated Carbon/ZnFe2O4 Nanocomposite Adsorbent for Efficient Removal of Crystal Violet Cationic Dye from Aqueous Solutions.

The aim of this study was to investigate the potential advantage of ZnFe2O4-incorporated activated carbon (ZFAC), fabricated via a simple wet homogenization, on the removal of cationic dye crystal violet (CV) from its aqueous solutions. The as-prepared ZFAC nanocomposite was characterized using Fourier transform infrared (FTIR), X-ray diffraction (XRD), nitrogen adsorption, scanning electron microscope (SEM), thermogravimetric analysis (TGA), and ultraviolet-visible (UV-Vis). Batch adsorption operating conditions such as the pH (3-11), CV concentration (25-200 ppm), ZFAC dose (10-50 mg), temperature (23-45 °C), and contact time were evaluated. The results indicate pH-dependent uptake (optimum at pH 7.2) increased with temperature and CV concentration increase and decreased as adsorbent dose increased. Modeling of experimental data revealed better fit to the Langmuir than Freundlich and Temkin isotherms, with maximum monolayer capacities (Qm) of 208.29, 234.03, and 246.19 mg/g at 23, 35, and 45 °C, respectively. Kinetic studies suggest pseudo-second order; however, the intra-particle diffusion model indicates a rate-limiting step controlled by film diffusion mechanism. Based on the thermodynamic parameters, the sorption is spontaneous (-ΔG°), endothermic (+ΔH°), and random process (+ΔS°), and their values support the physical adsorption mechanism. In addition to the ease of preparation, the results confirm the potential of ZFAC as a purifier for dye removal from polluted water.

Adsorption of cationic dyes onto carrageenan and itaconic acid-based superabsorbent hydrogel: Synthesis, characterization and isotherm analysis.

Polysaccharide-based hydrogels offer a great overlook for environmental applications and help in the elimination of various noxious pollutants from the water system. Novel carrageenan and itaconic acid-based superadsorbent hydrogel having appreciable swelling properties and adsorption capacity towards Methylene blue (MB), Crystal violet (CV), and Methyl Red (MR) was synthesized by suspension polymerization technique. The swelling study showed the dependency upon the temperature in which the swelling rate increased with increasing temperature with a maximum swelling rate of 417% at 318 K. For ascertaining the maximum adsorption capacity, various influential parameters such as contact time, adsorbent dose, dye concentration, and temperature were systematically studied. Maximum adsorption capacity as calculated from the Langmuir isotherm was 2439.02, 1111.11, and 666.68 mg/g for MB, CV, and MR, respectively. Thermodynamic studies revealed the spontaneous nature of the undertaken dye adsorption experiment. Overall, the present study reveals that the synthesized superadsorbent hydrogel can be used as an efficient adsorbent for the removal of dyes from an aqueous solution.

Green sporopollenin supported cyanocalixarene based magnetic adsorbent for pesticides removal from water: Kinetic and equilibrium studies.

In this study, magnetic sporopollenin supported cyanocalixarene (MSP-CyCalix) nanocomposite was synthesized and introduced as an adsorbent material for the removal of pesticides from aqueous media. MSP-CyCalix was characterized by different analytical techniques FTIR, SEM, EDX, BET, VSMand TEM. Chlorpyrifos and hexaconazole pesticides were chosen as model analytes solutions for testing the adsorption efficiency of MSP-CyCalix adsorbent. The adsorption results showed that the incorporated cyano functional groups significantly increased the chemical reactivity and adsorption capacity for pesticides. To obtain the highest possible performance, experimental parameters such as pH, salt, dosage and time were optimized. Adsorption kinetics and isotherms models showed that pesticide adsorption process was well fitted with the pseudo-second-order and Langmuir models with a maximum adsorption capacity of 13.88 mg g-1 and 12.34 mg g-1 and a removal efficiency of >90% for both pesticides. Lastly, MSP-CyCalix maintained a removal efficiency of >80% for ten cycles and 60% after the eleventh cycles of usage. The results proved that MSP-CyCalix nanocomposite can be used as an efficient adsorbent for the removal of pesticide residues from water.

Utilization of Ag2O-Al2O3-ZrO2 decorated onto rGO as adsorbent for the removal of Congo red from aqueous solution.

The water resources contamination in an alarming concern for sustainable environment. This has led to development of new technologies and materials for waste water detoxification. In the present study, we have fabricated novel trimetallic based mixed oxides decorated reduced graphene oxide (rGO) composite using facile microwave method and utilized it as an adsorbent for the removal of congo red dye from aqueous solution. The final composite showed highly agglomerated metal oxides present on the rGO surface. The high surface area and activity of the synthesized adsorbent resulted in its high adsorption capacity of 333.32 mg/g for congo red. The Langmuir model better explained the isotherm data indicating the monolayer adsorption of congo red molecules onto Ag2O-Al2O3-ZrO2/rGO surface. The grander adsorption ability of Ag2O-Al2O3-ZrO2/rGO towards organic dye indicate its probable utilization in the removal of other dyes also from wastewater.

Pesticides in Drinking Water-A Review.

The ubiquitous problem of pesticide in aquatic environment are receiving worldwide concern as pesticide tends to accumulate in the body of the aquatic organism and sediment soil, posing health risks to the human. Many pesticide formulations had introduced due to the rapid growth in the global pesticide market result from the wide use of pesticides in agricultural and non-agricultural sectors. The occurrence of pesticides in the water body is derived by the runoff from the agricultural field and industrial wastewater. Soluble pesticides were carried away by water molecules especially during the precipitation event by percolating downward into the soil layers and eventually reach surface waters and groundwater. Consequently, it degrades water quality and reduces the supply of clean water for potable water. Long-time exposure to the low concentration of pesticides had resulted in non-carcinogenic health risks. The conventional method of pesticide treatment processes encompasses coagulation-flocculation, adsorption, filtration and sedimentation, which rely on the phase transfer of pollutants. Those methods are often incurred with a relatively high operational cost and may cause secondary pollution such as sludge formation. Advanced oxidation processes (AOPs) are recognized as clean technologies for the treatment of water containing recalcitrant and bio-refractory pollutants such as pesticides. It has been adopted as recent water purification technology because of the thermodynamic viability and broad spectrum of applicability. This work provides a comprehensive review for occurrence of pesticide in the drinking water and its possible treatment.