RESUMEN
Extensive research efforts have been dedicated to developing electrode materials with high capacity to address the increasing complexities arising from the energy crisis. Herein, a new nanocomposite was synthesized via the sol-gel method by immobilizing K6ZnW12O40 within the surface of NiZn2O4. ZnW12O40@NiZn2O4 was characterized by FT-IR, UV-Vis, XRD, SEM, EDX, BET, and TGA-DTG methods. The electrochemical characteristics of the materials were examined using cyclic voltammogram (CV) and charge-discharge chronopotentiometry (CHP) techniques. Multiple factors affecting the hydrogen storage capacity, including current density (j), surface area of the copper foam, and the consequences of repeated cycles of hydrogen adsorption-desorption were evaluated. The initial cycle led to an impressive hydrogen discharge capability of 340 mAh/g, which subsequently increased to 900 mAh/g after 20 cycles with a current density of 2 mA in 6.0 M KOH medium. The surface area and the electrocatalytic characteristics of the nanoparticles contribute to facilitate the formation of electrons and provide good diffusion channels for the movement of electrolyte ions throughout the charge-discharge procedure.
RESUMEN
In this research, a new and eco-friendly heterogeneous catalyst (ND@Tannicacid-Cu) was synthesized based on nanodiamond and copper tannic acid via esterification process. The as-prepared catalyst was characterized by Fourier transforms infrared spectroscopy (FT-IR), energy dispersive X-ray spectroscopy (EDX), scanning electron microscopy (SEM), and X-ray diffraction (XRD) methods. The catalytic efficacy of the intended catalyst was examined by one-step three-component reaction of 1,4-benzodiazepine derivatives from a mixture of ortho-phenylenediamine, aromatic aldehydes, and dimedone under mild conditions. In all instances, corresponding 2,4-benzodiazepines derivatives were synthesized with high efficiency, short reaction time, straightforward work up procedure, no requirement for column-chromatography, and cost-effective catalyst. The heterogeneous catalyst was easily recycled using fillers, and it can be reused for eight cycles without significantly diminishing its performance.
RESUMEN
In this study, a biodegradable and eco-friendly biocatalyst (eggshell/Fe3O4) was synthesized utilizing eggshell impregnated with Fe3O4 nanoparticles. The characterization of prepared catalyst was carried out by Fourier transform infrared radiation (FT-IR), scanning electron microscopy (SEM), X-ray Diffraction (XRD), energy-dispersive X-ray (EDX), thermal gravimetric analysis-differential thermogravimetry (TGA-DTG), vibrating sample magnometer (VSM), and atomic force microscopy (AFM). The eggshell/Fe3O4 biocatalyst was served in multi-component reactions (MCRs) for the synthesis of 2-amino thiophene derivatives from variety aromatic aldehydes, malononitrile, ethyl acetoacetate, and sulfur (S8). To achieve optimal reaction conditions, a thorough examination was conducted on key factors, such as the solvent type, reaction time and temperature, and the ratio of eggshell to Fe3O4. The findings suggest that high yield product can be obtained at microwave temperature (MW) in EtOH solvent within 10 min. Additionally, the eggshell/Fe3O4 biocatalyst exhibited high catalytic activity, which was sustained over the five cycles, without any significant decline in its performance.
RESUMEN
In this study, a new and recyclable biocatalyst (MgAl CO3-LDH@Asn) was synthesized by immobilizing l-asparagine amino acid (Asn) on the surface of 3-(chloropropyl)-trimethoxysilane modified MgAl CO3-layered double hydroxide (LDH). The physicochemical properties of the samples were identified by Fourier transform infrared (FT-IR), X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray (EDX), and thermogravimetric analysis (TGA) techniques. The MgAl CO3-LDH@Asn was employed in the multi-component assembly process for the synthesis of tri-substituted derivatives of 2,4,5-(H1)-imidazoles from benzyl, various benzaldehyde derivatives, and ammonium acetate. For optimizing the reaction, the main factors, including the amount of MgAl CO3-LDH@Asn, type of solvent, reaction time, and temperature were evaluated. The optimum conditions of the model reaction were achieved using 20 mg of MgAl CO3-LDH@Asn biocatalyst in ethanol solvent after 20 min at reflux temperature. According to the findings above, the results indicated that high-yield products are achieved within a short time frame. Moreover, the high catalytic activity of the MgAl CO3-LDH@Asn was maintained for four cycles without significantly diminishing its performance.
RESUMEN
Sulfur compounds are among the most unfavorable constituents of petroleum derivatives, so stringent regulations have been established to curb their atmospheric emissions. In this regard, a new nanocomposite ((n-C4H9)4N)4H[PW11FeO39]@NiO) was synthesized composed of quaternary ammonium bromide salt of ironIII-substituted Keggin-type polyoxometalate immobilized on nickel(II) oxide nanoceramics via sol-gel method. The assembled (n-C4H9)4N)4H[PW11FeO39]@NiO nanocomposite was identified by FT-IR, UV-Vis, XRD, SEM, EDX, and TGA-DTG methods. The characterization results exhibited that ((n-C4H9)4N)4H[PW11FeO39] dispersed uniformly over the surface of the NiO nanoceramics. The ((n-C4H9)4N)4H[PW11FeO39]@NiO nanocomposite was employed as a heterogeneous nanocatalyst in the extractive coupled oxidation desulfurization (ECOD) of real gas oil and dibenzothiophene (DBT) as a model compound. Under relatively moderate conditions, the catalytic performance of the ((n-C4H9)4N)4H[PW11FeO39]@NiO in the ECOD procedure was studied by incorporating acetic acid/hydrogen peroxide as an oxidant system at a volume ratio of 1:2. According to the ECOD results, the ((n-C4H9)4N)4H[PW11FeO39]@NiO demonstrated the effectiveness of up to 95% with 0.1 g at 60 °C under optimal operating conditions. Moreover, the ((n-C4H9)4N)4H[PW11FeO39]@NiO nanocatalyst could be separated and reused for five runs without a noticeable decrease in the ECOD process. This study provides a promising way to meet the target of ultra-low sulfur as an essential process in oil refineries.
RESUMEN
The widespread use of hydrogen as a vehicle fuel has prompted us to develop a new nanocomposite by immobilizing of tin ferrite nanoparticles (SnFe2O4) on the surface of multi-walled carbon nanotubes (abbreviated as MWCNTS) for the first time. The prepared nanocomposite powder (SnFe2O4@MWCNTS) was investigated utilizing various microscopy and spectroscopy methods, such as FT-IR, XRD, SEM, EDX, and BET techniques. Moreover, the electrochemical property of SnFe2O4@MWCNTS nanocomposite was investigated by cyclic voltammogram (CV) and charge-discharge chronopotentiometry (CHP) techniques. A variety of factors on the hydrogen storage capacity, such as current density, surface area of the copper foam, and the influence of repeated hydrogen adsorption-desorption cycles were assessed. The electrochemical results indicated that the SnFe2O4@MWCNTS has high capability and excellent reversibility compared to SnFe2O4 nanoparticles (NPs) for hydrogen storage. The highest hydrogen discharge capability of SnFe2O4@MWCNTs was achieved â¼ 365 mAh/g during the 1st cycle, and the storage capacity enhanced to â¼ 2350 mAh/g at the end of 20 cycles using a current of 2 mA. Consequently, the SnFe2O4@MWCNTS illustrated great capacity as a prospective active material for hydrogen storage systems.
RESUMEN
This study aimed to investigate the effect of substitution of siris foliage with alfalfa forage in the diet of fattening lambs on digestibility, fermentation, and growth performance of fattening lambs. In the present experiment, 27 8-month-old Arabi lambs (31.3 ± 6) with an initial weight of 28.8 ± 1.99 kg were used in a completely randomized design. The effect of experimental diets on dry matter intake was not significant; however, the diets had a significant effect on the intake of neutral detergent fiber (NDF), acid detergent fiber (ADF), and crude protein (P < 0.05). The effect of experimental diets on the apparent digestibility of dry matter, organic matter, NDF, ADF, and crude protein was not significant (P < 0.05). Ammonia nitrogen concentration, pH, and a total population of ruminal fluid protozoa and blood parameters were not affected by experimental diets. Parameters of fattening performance such as feed intake, live weight changes, feed conversion ratio, some carcass traits such as mean weight and size of carcass parts, and colorimetric indices of muscle tissue in the order of fattening lambs were not affected by experimental diets. The use of foliage of siris in the diet of fattening lambs as a substitute with part of alfalfa had no adverse effect on the characteristics studied in the present experiment. Therefore, siris be recommended as part of the diet of fattening lambs.