The impact of ozone treatment on the removal effectiveness of various refractory compounds in wastewater from petroleum refineries.

Large volumes of wastewater are generated during petroleum refining processes. Petroleum refinery wastewater (PRW) can contain highly toxic compounds that can harm the environment. These toxic compounds can be a challenge in biological treatment technologies due to the effects of these compounds on microorganisms. These challenges can be overcome by using ozone (O3) as a standalone or as a pretreatment to the biological treatment. Ozone was used in this study to degrade the organic pollutants in the heavily contaminated PRW from a refinery in Mpumalanga province of South Africa. The objective was achieved by treating the raw PRW using ozone at different ozone treatment times (15, 30, 45, and 60 min) at a fixed ozone concentration of 3.53 mg/dm3. The ozone treatment was carried out in a 2-liter custom-designed plexiglass cylindrical reactor. Ozone was generated from an Eco-Lab-24 corona discharge ozone generator using clean, dry air from the Afrox air cylinder as feed. The chemical oxygen demand, gas chromatograph characterization, and pH analysis were performed on the pretreated and post-treated PRW samples to ascertain the impact of the ozone treatment. The ozone treatment was effective in reducing the benzene, toluene, ethylbenzene, and xylenes (BTEX) compounds in the PRW. The 60-min ozone treatment of different BTEX pollutants in the PRW resulted in the following percentage reduction: benzene 95%, toluene 77%, m + p-xylene 70%, ethylbenzene 69%, and o-xylene 65%. This study has shown the success of using ozone in reducing the toxic BTEX compounds in a heavily contaminated PRW.

Continuous fixed-bed column study and adsorption modeling removal of Ni2+, Cu2+, Zn2+ and Cd2+ ions from synthetic acid mine drainage by nanocomposite cellulose hydrogel.

Heavy metal ions are widely recognized for their harmful effects on human health and the environment. Heavy metal ions removal using nanocomposite hydrogel is a promising method for industrial applications and process development owing to their utilization in both kinematic and dynamic adsorption process. There is a need to develop simple, low-cost water purification techniques that use biodegradable bio-based natural polymers like cellulose nanocrystal that have been modified with nanomaterials. These innovative functional cellulose nanocrystals-based nanomaterials have been shown to successfully remove a variety of contaminants from wastewater to acceptable levels. Due to their capacity to hold water in their porous structures, hydrogels are the most commonly used 3D polymer mesh materials for environmental remediation. The application of potential hydrogel for the absorption of Cu2+, Ni2+, Zn2+ and Cd2+ ions from an aqueous solution in a packed bed adsorption column was studied in this work. The adsorbent was studied using FTIR, SEM, XRD and TGA. The influence of breakthrough factors such as bed height (10, 17 and 25 cm) influent concentration (10, 20 and 50 mg/L) and the feed flow rate (10, 20 and 30 mL/min) was assessed. Bed Depth Service Time, Thomas and Yoon-Nelson models were used to fit the experimental data. With an increase in bed height, breakthrough and exhaustion time, the removal efficiency rose to 99.42 ± 0.12 for Cu2+, 99.23 ± 1.16 for Ni2+, 99.36 ± 0.89 for Cd2+ and 98.94 ± 0.48 for Zn2+, but declined with increased flow rate and influent concentration. Better performance was observed at a bed height of 25 cm, an influent metal ion concentration of 10 mg/L and a flow velocity of 10 mL/min. The BDST and Yoon-Nelson models were both successfully used to predict the breakthrough curves of heavy metal ions removal.