RESUMEN
We investigated the sensitivity of distal bone density, structure, and strength measurements by high-resolution peripheral quantitative computed tomography (HR-pQCT) to variability in limb length. Our results demonstrate that HR-pQCT should be performed at a standard %-of-total-limb-length to avoid substantial measurement bias in population study comparisons and the evaluation of individual skeletal status in a clinical context. INTRODUCTION: High-resolution peripheral quantitative computed tomography (HR-pQCT) measures of bone do not account for anatomic variability in bone length: a 1-cm volume is acquired at a fixed offset from an anatomic landmark. Our goal was to evaluate HR-pQCT measurement variability introduced by imaging fixed vs. proportional volumes and to propose a standard protocol for relative anatomic positioning. METHODS: Double-length (2-cm) scans were acquired in 30 adults. We compared measurements from 1-cm sub-volumes located at the default fixed offset, and the average %-of-length offset. The average position corresponded to 4.0% ± 1.1 mm for radius, and 7.2% ± 2.2 mm for tibia. We calculated the RMS difference in bone parameters and T-scores to determine the measurement variability related to differences in limb length. We used anthropometric ratios to estimate the mean limb length for published HR-pQCT reference data, and then calculated mean %-of-length offsets. RESULTS: Variability between fixed vs. relative scan positions was highest in the radius, and for cortical bone in general (RMS difference Ct.Th = 19.5%), while individuals had T-score differentials as high as +3.0 SD (radius Ct.BMD). We estimated that average scan position for published HR-pQCT reference data corresponded to 4.0% at the radius, and 7.3% at tibia. CONCLUSION: Variability in limb length introduces significant bias to HR-pQCT measures, confounding cross-sectional analyses and limiting the clinical application for individual assessment of skeletal status. We propose to standardize scan positioning using 4.0 and 7.3% of total bone length for the distal radius and tibia, respectively.
Asunto(s)
Densidad Ósea/fisiología , Radio (Anatomía)/diagnóstico por imagen , Tibia/diagnóstico por imagen , Tomografía Computarizada por Rayos X/métodos , Anciano , Anciano de 80 o más Años , Puntos Anatómicos de Referencia , Antropometría/métodos , Femenino , Análisis de Elementos Finitos , Antebrazo/anatomía & histología , Humanos , Pierna/anatomía & histología , Masculino , Radio (Anatomía)/fisiología , Reproducibilidad de los Resultados , Tibia/fisiología , Tomografía Computarizada por Rayos X/normasRESUMEN
In this study, we determined that operator positioning precision contributes significant measurement error in high-resolution peripheral quantitative computed tomography (HR-pQCT). Moreover, we developed software to quantify intra- and inter-operator variability and demonstrated that standard positioning training (now available as a web-based application) can significantly reduce inter-operator variability. INTRODUCTION: HR-pQCT is increasingly used to assess bone quality, fracture risk, and anti-fracture interventions. The contribution of the operator has not been adequately accounted in measurement precision. Operators acquire a 2D projection ("scout view image") and define the region to be scanned by positioning a "reference line" on a standard anatomical landmark. In this study, we (i) evaluated the contribution of positioning variability to in vivo measurement precision, (ii) measured intra- and inter-operator positioning variability, and (iii) tested if custom training software led to superior reproducibility in new operators compared to experienced operators. METHODS: To evaluate the operator in vivo measurement precision, we compared precision errors calculated in 64 co-registered and non-co-registered scan-rescan images. To quantify operator variability, we developed software that simulates the positioning process of the scanner's software. Eight experienced operators positioned reference lines on scout view images designed to test intra- and inter-operator reproducibility. Finally, we developed modules for training and evaluation of reference line positioning. We enrolled six new operators to participate in a common training, followed by the same reproducibility experiments performed by the experienced group. RESULTS: In vivo precision errors were up to threefold greater (Tt.BMD and Ct.Th) when variability in scan positioning was included. The inter-operator precision errors were significantly greater than the short-term intra-operator precision (p < 0.001). New trained operators achieved comparable intra-operator reproducibility to experienced operators and lower inter-operator reproducibility (p < 0.001). Precision errors were significantly greater for the radius than for the tibia. CONCLUSION: Operator reference line positioning contributes significantly to in vivo measurement precision and is significantly greater for multi-operator datasets. Inter-operator variability can be significantly reduced using a systematic training platform, now available online ( http://webapps.radiology.ucsf.edu/refline/ ).
Asunto(s)
Competencia Clínica , Osteoporosis/diagnóstico por imagen , Tomografía Computarizada por Rayos X/normas , Anciano , Anciano de 80 o más Años , Puntos Anatómicos de Referencia , Femenino , Humanos , Capacitación en Servicio/métodos , Masculino , Radio (Anatomía)/diagnóstico por imagen , Reproducibilidad de los Resultados , Diseño de Software , Tibia/diagnóstico por imagen , Tomografía Computarizada por Rayos X/métodosRESUMEN
Quantitative computed tomography (QCT) is increasingly used in osteoporosis studies to assess volumetric bone mineral density (vBMD), bone quality and strength. However, QCT is confronted by technical issues in the clinical research setting, such as potentially confounding effects of body size on vBMD measurements and lack of standard approaches to scanner cross-calibration, which affects measurements of vBMD in multicenter settings. In this study, we addressed systematic inter-scanner differences and subject-dependent body size errors using a novel anthropomorphic hip phantom, containing a calibration hip to estimate correction equations, and a contralateral test hip to assess the quality of the correction. We scanned this phantom on four different scanners and we applied phantom-derived corrections to in vivo images of 16 postmenopausal women scanned on two scanners. From the phantom study, we found that vBMD decreased with increasing phantom size in three of four scanners and that inter-scanner variations increased with increasing phantom size. In the in vivo study, we observed that inter-scanner corrections reduced systematic inter-scanner mean vBMD differences but that the inter-scanner precision error was still larger than expected from known intra-scanner precision measurements. In conclusion, inter-scanner corrections and body size influence should be considered when measuring vBMD from QCT images.
Asunto(s)
Densidad Ósea , Huesos/diagnóstico por imagen , Cuello Femoral/diagnóstico por imagen , Osteoporosis/diagnóstico por imagen , Fantasmas de Imagen/normas , Tomografía Computarizada por Rayos X/instrumentación , Anciano , Tamaño Corporal , Calibración , Femenino , Cadera/diagnóstico por imagen , Humanos , Persona de Mediana Edad , Pelvis/diagnóstico por imagenRESUMEN
Azoaldolase is obtained from rabbit muscle aldolase by adding an azo chromophore to a cysteine side chain in each of the four enzyme subunits. The enzyme becomes photosensitive whereas both its catalytic activity and the michaelian kinetics are retained. Chromophore excitation causes E to Z isomerization of the azo bond, and mutually influences the protein-substrate equilibria. The various isomerization and substrate binding equilibria have been investigated under the hypothesis of a cyclic process described by four linked equilibrium constants. The mechanism of the light effect is a continuous adaptation of the specific parameters of the active protein, that is substrate recognition and rate of the catalyzed process. Absorbed light allows the rapid modification of the concentrations of various related molecules, depending on the used frequencies. At present such a mechanism has not been described in photobiology; so azoaldolase can be taken as a model for a possible new mechanism of light regulation of a biological system, based on changes in the molecular recognition by an active protein against its substrate.
Asunto(s)
Fructosa-Bifosfato Aldolasa/metabolismo , Luz , Animales , Compuestos Azo/química , Fructosa-Bifosfato Aldolasa/química , Músculos/enzimología , Fotoquímica , ConejosRESUMEN
Irritant effects and cytotoxicity of three different products based on collagen were investigated: a sponge formulation and a thin film composed by Type I collagen from bovine Achille's tendon, and a membrane prepared from bovine derma. The test system was a three-dimensional human skin model, developed by Advanced Tissue Science, La Jolla, CA, USA. Squares of dermal tissue (11 x 11 mm) were cultured in suitable media and exposed to the products under study. Dimethyl sulphoxide was used as the chemical control of tissue responsiveness to irritating substances. After 24 and 48 h the prostaglandin E2 (PGE2) concentration and the lactate dehydrogenase (LDH) activity in the culture medium were measured, as indexes of early inflammatory response and cell membrane breakdown, respectively. In addition, cell morphology was examined by light microscopy. The highest PGE2 concentrations were observed after cell exposure to the collagen sponges. The intensity of the inflammatory response changed accordingly to the collagen dose in use. However, it was never followed by an increased rate of cell death, as revealed by LDH activity measurement and microscopy. These findings suggest that hydrolysis of exogenous collagen starts shortly after it is kept in contact with tissues and evokes a local inflammatory response whose intensity depends on the pharmaceutical formulation in use.
Asunto(s)
Colágeno/toxicidad , Inflamación/inducido químicamente , Irritantes/toxicidad , Piel/efectos de los fármacos , Tendón Calcáneo/química , Administración Tópica , Animales , Antiinflamatorios/farmacología , Bovinos , Membrana Celular/efectos de los fármacos , Membrana Celular/patología , Química Farmacéutica , Medios de Cultivo/análisis , Técnicas de Cultivo , Dimetilsulfóxido/farmacología , Dinoprostona/análisis , Relación Dosis-Respuesta a Droga , Humanos , Inflamación/metabolismo , L-Lactato Deshidrogenasa/análisis , Piel/química , Piel/patologíaRESUMEN
The aim of the present study was to evaluate the sensitivity and specificity of the ultrasonography, in comparison with other methods of investigation (scintigraphy, sialography, and biopsy), in scanning morphostructural changes in the parotid gland in patient with Sjögren's syndrome. During the period June-October 1994, 34 patients (5 males and 29 females, age ranged between 20 and 88 years) with "sicca syndrome" underwent to echography, scintigraphy, sialography and biopsy. The diagnosis was confirmed or excluded using the European Community Epidemiologic Committee criteria for Sjögren's syndrome. Twenty-two patients out of 34 were affected by Sjögren's syndrome, while the others resulted as control subjects. The ultrasonographic investigation has shown 76.19% of sensitivity and 30.43% of specificity. Even if echography is a non-invasive method, which could be used as preliminary approach for studying the diffused involvement of the parotid gland, at the status of the art, it is not completely reliable for the global evaluation of the morphostructural changes in patients with Sjögren's syndrome, in comparison with the other techniques. Because of the double nature of the gland injury, it appears to be essential the diagnostic integration between echography and sialography.