Properties of Active Levan-Bitter Vetch Protein Films for Potential Use in Food Packaging Applications.

ζ-potential and Z-average were determined on film-forming solutions of bitter vetch-levan-based films prepared at different ratios in the absence and presence of glycerol as a plasticizer. The casting method was used to obtain manageable films. The results revealed that levan increases the elongation at break of bitter vetch protein films and reduces the tensile strength. The optimal result was obtained through the film that was prepared with the ratio of 50% bitter vetch proteins and 50% levan, in terms of mechanical properties. The surfaces of the prepared films appeared to be more compact and smooth. On increasing the glycerol concentration in the bitter vetch protein-levan films, the oxygen and water vapor permeability increased compared to the control (P < 0.05). Based on the overall results, the reinforcement of bitter vetch proteins with levan at a ratio of 1:1 represents optimal film properties in the presence of a low concentration of glycerol. The proposed film is suggested as an innovative packaging system for beef meat to preserve its quality over time.

Isolation and characterization of two glycolipopeptids biosurfactants produced by a Lactiplantibacillus plantarum OL5 strain isolated from green olive curing water.

Microbial surfactants are natural amphiphilic compounds with high surface activities and emulsifying properties. Due to their structural diversity, low toxicity, biodegradability, and chemical stability in different conditions, these molecules are potential substitutes for chemical surfactants; their interest has grown significantly over the last decade. The current study focuses on the isolation, identification, and characterization of a lactic acid bacteria that produce two forms of biosurfactants. The OL5 strain was isolated from green olive fermentation and identified using MALDI/TOF and DNAr16S amplification. Emulsification activity and surface tension measurements were used to estimate biosurfactant production. The two biosurfactants derived from Lactiplantibacillus plantarum OL5 presented good emulsification powers in the presence of various oils. They were also shown to have the potential to reduce water surface tension from 69 mN/m to 34 mN/m and 37 mN/m within a critical micelle concentration (CMC) of 7 mg/ml and 1.8 mg/ml, respectively, for cell bound and extracellular biosurfactants. Thin layer chromatography (TLC) and FT-IR were used to analyze the composition of the two biosurfactants produced. the obtained data revealed that the two biomolecules consist of a mixture of carbohydrates, lipids and proteins. We demonstrated that they are two anionic biosurfactants with glycolipopeptide nature which are stable in extreme conditions of temperature, pH and salinity.

Mitigation of Hepatic Impairment with Polysaccharides from Red Alga Albidum corallinum Supplementation through Promoting the Lipid Profile and Liver Homeostasis in Tebuconazole-Exposed Rats.

Sulfated polysaccharides from seaweed are highly active natural substances with valuable applications. In the present paper, attempts have been made to discuss the physicochemical and structural features of polysaccharides isolated from red marine alga Alsidium corallinum (ACPs) and their protective effect in hepatic impairments induced by tebuconazole (TEB) in male adult rats. Structural features were determined using high-performance liquid chromatography, Fourier-transformed infrared, and solid-state 1H and 13C-Nuclear magnetic resonance analysis. ACPs are found to be hetero-sulfated-anionic polysaccharides that contain carbohydrates, sulfate groups, and uronic acids. In vitro biological activities suggested the effective antioxidant and antimicrobial capacities of ACPs. For antioxidant testing in vivo, the biochemical analysis and plasma profiles displayed that oral administration of ACPs could mitigate blood lipid indicators, including total cholesterol, triglyceride, low and high-density lipoprotein cholesterol, and bilirubin. Liver function indexes involving alanine aminotransferase and aspartate aminotransferase showed that ACPs possessed prominent antioxidant activities. Additionally, the intervention of ACPs potentially inhibited lipid peroxidation, protein oxidation, key enzymes of lipid metabolism (<0.001), and improved antioxidant status (<0.05). Histomorphological observation confirmed that ACPs intervention could partially repair liver injuries caused by TEB. The computational results showed that A. corallinum monosaccharides bound 1JIJ, 1HD2, and 1WL4 receptors with acceptable affinities, which, together with deep embedding and molecular interactions, support the antioxidant, antimicrobial, and hypolipidemic outlined effects in the in vitro and in vivo findings. Given their prominent antioxidant effects, ACPs are promising candidates for liver diseases and must be considered in pharmaceutical applications.

Surface properties and heavy metals chelation of lipopeptides biosurfactants produced from date flour by Bacillus subtilis ZNI5: optimized production for application in bioremediation.

The present study summarizes the valorization of date flour by the production of lipopeptide biosurfactant (BioS) by Bacillus subtilis ZNI5 (MW091416). A Taguchi design permitted the formulation of a medium composed only of 6% date flour and 0.5% yeast extract within 2 days of incubation at 150 rpm with a maximal surface tension (ST) reduction of about 27.8 mN/m. The characterization of the lipopeptide shows a CMC value of about 400 mg/L with a minimal ST of 30 mN/m and an ability to disperse oil to about 80 mm at 800 mg/L. Having reduced phytotoxicity, the ZNI5 BioS and ZNI5 strain were assayed for Copper and Cobalt chelation and biosorption. The improvement of the germination index of radish seeds irrigated by the treated contaminated water showed the great potential application of ZNI5 lipopeptide in the bioremediation of heavy metals.

Valorization of date juice by the production of lipopeptide biosurfactants by a Bacillus mojavensis BI2 strain: bioprocess optimization by response surface methodology and study of surface activities.

Lipopeptides biosurfactants (BioS) are natural surface-active compounds produced by a variety of microorganisms. They have great interest in environmental, biomedical and agro-industrial fields. However their large-scale application and production is limited by the cost of culture media and the low yield of production. Therefore, the improvement of the production yields and the development of efficient and cost-effective bioprocess became of a great interest. In this aim, we applied the response surface method to optimize an economic BioS production by a newly isolated strain Bacillus mojavensis BI2 on date Juice called "Luegmi" as unique carbon and nitrogen source. Using a Box-Bhenken design, we studied the effect of three independent variables on lipopeptide production; Leugmi concentration, Na2HPO4 and incubation time. The results of this study showed that Leugmi concentration at 25%, Na2HPO4 at 0.1% and incubation time of 24 h were optimal conditions for BioS  production, with a maximum Surface Tension (ST) decreasing capacity of 55% corresponding to 27 mN/m and an Oil Dispersing Activity (ODA) of 30 cm2 corresponding to a diameter of 6 cm. Preliminary characterization of the BioS produced on Luegmi by UV-Spectra and Thin Layer Chromatography showed its lipopeptide nature. Physic-chemical characterization of the produced lipopeptide on Leugmi showed its great surface activities and stabilities at different pH, temperature and salts concentration. The results of this study suggested that Leugmi, an agricultural byproducts can be used as a low-cost substrate to enhance the yield of lipopeptide BioS with great surface activities for potential environmental application.

Structural elucidation and interfacial properties of a levan isolated from Bacillus mojavensis.

A strain with high exopolysaccharide (EPS) production was isolated from soil and identified as Bacillus mojavensis based on the 16S rRNA gene sequencing and biochemical properties. The EPS produced simultaneously with the growth phase reached a maximum of 22 g/L after attaining a stationary phase with sucrose used as sole carbon source. B. mojavensis EPS (BM-EPS) was recovered, fractionated by ethanol precipitation and analysed by NMR and methylation analyses. The BM-EPS was found to be composed of (ß2 â†’ 6)-Fruf residues, characteristic of a levan, with an average molecular weight of 2.3 MDa. A homogeneous micro-porous and rough structure matrix was observed by SEM of the freeze-dried powdered sample. A concentration-dependent water-soluble nature was observed, with good water (5.3 g/g) and oil (36 g/g) holding capacities. The levan displayed good emulsification activity with excellent stability against food grade oil, thus favoring it as a promising emulsifying agent to food industries.

Statistical optimization of levan: Influence of the parameter on levan structure and angiotensin I-converting enzyme inhibitory.

Based on Plackett-Burman design, steepest ascent method, and Box-Behnken design, statistical optimization for B. subtilis AF17 for levan production was carried out. Sucrose, tryptone and initial pH were found to be the most significant parameter (P < 0.05) for levan production. Result showed that the optimum condition was sucrose 162.5 g/L, tryptone 10 g/L, initial pH 7 and maximum yield was 7.9 ± 0.18 g/L in 72 h fermentation. Purified levan was characterized using various physicochemical techniques such as GC-MS, 1H NMR, 13C NMR spectroscopy and SEC/TDA. Based on this data, the structure of levan was independent of initial culture conditions. The biomedical potential of the isolated Bacillus subtilis A17 levan for its angiotensin-I converting enzyme (ACE) inhibition activities was exploited in vitro. Interestingly, levan possessed an important angiotensin I converting enzyme (ACE) inhibitory 81.1 ± 4.1% at 4 mg/mL. The overall, data suggested that levan presents a promising natural source of antihypertensive agents.

Levan from a new isolated Bacillus subtilis AF17: Purification, structural analysis and antioxidant activities.

A strain of Bacillus subtilis AF 17 with high exopolysaccharide (EPS) production ability was isolated and identified based on morphological and physiological characteristics and phylogenetic analysis of 16S rDNA sequences. EPS was isolated from the strain fermentation broth by alcohol precipitation and gel-filtration chromatography. Its structural characteristics were investigated and elucidated by methylation analysis, gas chromatography mass spectrometry and nuclear magnetic resonance spectroscopy. Based on the obtained data, the EPS was found to be a levan containing a backbone of 6-substituted ß-fructoses, with a low grade of branching at position 1 (linear/branched ratio 20:1). Levan showed a molecular weight of about 20 MDa. The antioxidant activity of this biopolymer was studied and revealed that levan showed an interesting 1,1-diphenyl-2-picrylhydrazyl (DPPH) radical-scavenging capacity (IC50 levan = 1.42 mg/mL), reducing power, and also a strong total antioxidant activity. Overall, the results suggest that levan is a promising source of natural antioxidants and can be used as additive in food and pharmaceutical preparations.

Characterization and production optimization of biosurfactants by Bacillus mojavensis I4 with biotechnological potential for microbial enhanced oil recovery.

Response surface methodology was applied to optimize the production of biosurfactants from Bacillus mojavensis I4 using Box-Behnken design with four variables. The optimal variable combination was 3% of glucose as carbon source, 0.6% of glutamic acid as nitrogen source, temperature of 35 °C and 10 g/l of NaCl which yielded to an optimal production of 4.12 g/l. Compositional analysis and FTIR spectrum revealed that the extracted biosurfactants was a lipopeptides. The biosurfactants achieved a critical micelle concentration value of 100 mg/l. Moreover, the extracted biosurfactants were effective at recovering up to 89.2% of motor oil from sand beach and achieved a dispersion rate of 78% of the initial diameter of the oil. These findings suggested the potential use of I4 biosurfactants in the oil industry.