Numerical Analysis of the Porous Structure of Activated Carbons Derived from Synthetic Polymers.

This paper presents original results from the unique analysis of the porous structure of activated carbons (ACs) produced through the chemical activation of polyethylene terephthalate (PET) and polyacrylonitrile (PAN), as well as from a physical mixture of both polymers. An advanced method of adsorbent surface analysis-more specifically, the new method of numerical clustering-based adsorption analysis regarding the surface heterogeneity, pore geometry and adsorption energy distribution parameters-allowed us to obtain information about the porous structure of the ACs from the synthetic polymers mentioned above. As the results showed, ACs obtained with PAN were characterised by a first adsorbed layer with the highest volume. When the surface heterogeneity, highly desirable in most advanced adsorption processes, is taken into account, the materials with the best surface properties in both potassium carbonate (K2CO3) and potassium hydroxide (KOH) activation processes were the ACs obtained with a mass proportion of PET to PAN of 1:3, which were characterised by a low degree of surface heterogeneity and a first adsorbed layer presenting a relatively large volume.

Valorisation of Tectona Grandis tree sawdust through the production of high activated carbon for environment applications.

This work presents a first approach concerning the use of Tectona Grandis tree sawdust (from East Timor) for high activated carbon production, by physical activation with carbon dioxide at different temperatures. The activated carbons (AC) obtained exhibit a well-developed porous structure with a pore size distribution varying from micro to mesopores. Selected AC was successfully evaluated for pesticide removal, specific to 4-chloro-2-methylphenoxyacetic acid, from the liquid phase. The results presented are very promising, allowing to establish that Tectona Grandis sawdust is as an excellent precursor for the basic AC production and allow to expect good performance of theses adsorbents on the removal of a broad range of pollutants. It should also be noted that, this achievement is very relevant for developing countries, such East Timor, where Tectona Grandis sawdust is available and may constitute a source of income creating a handle to the technical and industrial development of this region.

Synthetic polymers blend used in the production of high activated carbon for pesticides removals from liquid phase.

For the activated carbon (AC) production, we used the most common industrial and consumer solid waste, namely polyethyleneterephthalate (PET), alone or blended with other synthetic polymer such polyacrylonitrile (PAN). By mixing PET, with PAN, an improvement in the yield of the AC production was found and the basic character and some textural and chemical properties were enhanced. The PET-PAN mixture was subjected to carbonisation, with a pyrolysis yield of 31.9%, between that obtained with PET (16.9%) or PAN (42.6%) separately. The AC revealed a high surface area (1400, 1230 and 1117 m2 g-1) and pore volume (0.46, 0.56 and 0.50 cm3 g-1), respectively, for PET, PAN and PET-PAN precursors. Selected ACs were successfully tested for 4-chloro-2-methylphenoxyacetic acid (MCPA) and diuron removal from the liquid phase, showing a higher adsorption capacity (1.7 and 1.2 mmol g-1, respectively, for MCPA and diuron) and good fits with the Langmuir (PET) and Freundlich equation (PAN and PET-PAN blend). With MCPA, the controlling factor to the adsorption capacity was the porous volume and the average pore size. Concerning diuron, the adsorption was controlled essentially by the external diffusion. A remarkable result is the use of different synthetic polymers wastes, as precursors for the production of carbon materials, with high potential application on the pesticides removals from the liquid phase.