Optimization of solid-phase extraction of parabens and benzophenones in water samples using a combination of Plakett-Burman and Box-Behnken designs.

An automated method for the analysis of methylparaben, propylparaben, benzophenone-3, and benzophenone-4 in water effluents via on-line solid-phase extraction coupled with high-performance liquid chromatography/ultraviolet detection was proposed. The preconcentration parameters were studied using Plackett-Burman and Box-Behnken experimental designs using a C18 sorbent material. The results demonstrated that the eluent volume, composition, and sorbent amount were statistically significant. Optimal conditions for these variables were an eluent volume of 1.55 mL, eluent composition of acetonitrile 100% v/v, and sorbent amount of 100 mg. The eluted sample was analyzed on-line using high-performance liquid chromatography equipped with a reversed-phase C18 column and ultraviolet detection. Separation of the analytes was achieved in 15 min using gradient elution with acetonitrile/water. A simple, sensitive, and rapid analytical method was proposed for personal care compounds without sophisticated or expensive equipment. The limits of detection were 1.20, 1.73, 2.51, and 4.67 µg/L for propylparaben, methylparaben, benzophenone-3, and benzophenone-4, respectively. The analysis time was 48 min, consuming only 1.59 mL of eluent acetonitrile for the solid phase extraction step, with minimal sample handling. The method was applied to the analysis of spiked swimming pool and wastewater, with recoveries between 65-107%. These results indicate the reliability of the flow-based procedure.

On-line monitoring of the photocatalytic degradation of 2,4-D and dicamba using a solid-phase extraction-multisyringe flow injection system.

A fully automated on-line system for monitoring the photocatalytic degradation of herbicides was developed using multisyringe flow injection analysis (MSFIA) coupled to a solid phase extraction (SPE) unit with UV detection. The calibration curves were linear in the concentration range of 100-1000 µg L(-1) for 3,6-dichloro-2-methoxybenzoic acid (dicamba) and 500-3000 µg L(-1) for 2,4-dichlorophenoxyacetic acid (2,4-D), while the detection limits were 30 and 135 µg L(-1) for dicamba and 2,4-D, respectively. The monitoring of the photocatalytic degradation (TiO2 anatase/UV 254 nm) of these two herbicides was performed by MSFIA-SPE system using a small sample volume (2 mL) in a fully automated approach. The degradation was assessed in ultrapure and drinking water with initial concentrations of 1000 and 2000 µg L(-1) for dicamba and 2,4-D, respectively. Degradation percentages of approximately 85% were obtained for both herbicides in ultrapure water after 45 min of photocatalytic treatment. A similar degradation efficiency in drinking water was observed for 2,4-D, whereas dicamba exhibited a lower degradation percentage (75%), which could be attributed to the presence of inorganic species in this kind of water.