RESUMEN
NaNO2/MgO/titania spheres prepared via aerosol-assisted self-assembly (AASA) were used as sorbents for CO2 adsorption at moderate temperature. The titania framework as support would allow MgO to disperse well, thereby increasing the contact between MgO and NaNO2 to enhance carbonation. In this study, the effect of Mg/Ti molar ratio and NaNO2 addition amount on CO2 adsorption was investigated. Results showed that the sorbent prepared by AASA with Mg/Ti molar ratio of 2 following the introduction of 30â wt% NaNO2 presented â¼1â µm particle size with rough sphere surface morphology and mesoporous properties, where the surface area and pore volume were 72â m2/g and 0.18â cm3/g, respectively. With NaNO2 addition, the kinetics and capacity of CO2 adsorption significant increased. In the cyclic adsorption/desorption experiment, the superior stability over the NaNO2/MgO/titania spheres was mainly ascribed to the confined space suppressed the degree of the sintering effect. These results indicated the potential application of the nanochannel-restricted sorbent for rapid, high-capacity, and stable CO2 capture at moderate temperatures.
RESUMEN
Calcium oxide (CaO) is a promising adsorbent to separate CO2 from flue gas. However, with cycling of carbonation/decarbonation at high temperature, the serious sintering problem causes its capture capacity to decrease dramatically. A CaTiO3-decorated CaO-based CO2 adsorbent was prepared by a continuous and simple aerosol-assisted self-assembly process in this work. Results indicated that CaTiO3 and CaO formed in the adsorbent, whereas CaO gradually showed a good crystalline structure with increased calcium loading. Owing to the high thermal stability of CaTiO3, it played a role in suppressing the sintering effect and maintaining repeated high-temperature carbonation and decarbonation processes. When the calcium and titanium ratio was 3, the CO2 capture capacity was as large as 7 mmol/g with fast kinetics. After 20 cycles under mild regeneration conditions (700 °C, N2), the performance of CO2 capture of CaTiO3-decorated CaO-based adsorbent nearly unchanged. Even after 10 cycles under severe regeneration conditions (920 °C, CO2), the performance of CO2 capture still remained nearly 70% compared to the first cycle. The addition of CaTiO3 induced good and firm CaO dispersion on its surface. Excellent kinetics and stability were evident.
RESUMEN
Efficient Ca(2+)-switched fluorescent sensors, where fluorescence output is governed by a light-activated ion-gated electron transfer pathway, can be obtained on combining BODIPY chromophores with a readily oxidized biocompatible and selective BAPTA receptor. Herein we report the synthesis and studies of two such conjugates, which vary in the nature of the spacer separating the two electroactive components, namely none (1) or phenyl (2). Single crystal X-ray crystallography and molecular modelling structures and calculations give information on molecular and electronic structure, while steady-state fluorescence experiments show high Ca(2+)-induced fluorescence enhancement factors of 122 and 23 and K(d) values of 0.50 µM and 0.13 µM for 1 and 2, respectively. Notably, studies of the ultrafast photoinduced processes (through transient absorption spectroscopy) give access to electron transfer dynamics in pseudo-physiological media as well as in a polar non-protic solvent and information about the fate of the excited molecules in the presence and absence of calcium. In water, electron transfer rates as high as 3.3 × 10(12) s(−1) and 8.3 × 10(11) s(−1) are measured for the ion-free, directly connected conjugate and the variant incorporating a phenyl spacer, respectively. This electron transfer pathway is efficiently blocked by the presence of an ion, restoring fluorescence.
