A high-performance trace level acetone sensor using an indispensable V4C3T x MXene.

The development of a stringent sensor to detect low levels of acetone, yielding the potential for the point-of-care clinical diagnosis of diabetes, is still a great challenge but is urgently required. Most studies have focused on Ti3C2T x , yet other types of MXenes with good performance are rare. Herein, an emerging kind of MXene, V4C3T x , has been prepared from V4AlC3 via the selective etching of the Al layer using aqueous HF at room temperature (RT), and its performance as an acetone sensor is presented. A V4C3T x based acetone sensor delivers good performance, as demonstrated by its low working temperature of 25 °C, low detection limit of 1 ppm (lower than the 1.8 ppm diabetes diagnosis threshold), and high selectivity towards acetone in a mixed gas of acetone and water vapor, hopefully showing promise for application in the much faster and earlier diagnosis of diabetes. V4C3T x MXene is used for the first time in the field of acetone detection in this work, hopefully opening up a path for the investigation of applications of MXene in gas sensors, and such exciting findings distinguish V4C3T x as a comparable material to the well-known Ti3C2T x . In addition, we used DFT calculations to explore the mechanisms that result in the superior selectivity for acetone with respect to water vapor. Hopefully, the proposed mechanisms combining experimental results and theoretical study will shed light on the design and production of new high-performance acetone sensors.

[Initial experience of percutaneous coronary intervention guided by computed tomography coronary angiography derived roadmap and magnetic navigation system].

OBJECTIVE: To evaluate the feasibility, efficacy and safety of the percutaneous coronary intervention (PCI)guided by computed tomography (CT) coronary angiography derived roadmap and magnetic navigation system (MNS). METHODS: During June 2011 and May 2012, thirty consecutive patients receiving elective PCI were enrolled, coronary artery disease was primarily diagnosed by dual-source CT coronary angiography (DSCT-CA) at outpatient clinic and successively proved by coronary artery angiography in the hospital. Target vessels from pre-procedure DSCT-CA were transferred to the magnetic navigation system, and consequently edited, reconstructed, and projected onto the live fluoroscopic screen as roadmap. Parameters including characters of the target lesions, time, contrast volume, radiation dosage for guidewire crossing, and complications of the procedure were recorded. RESULTS: Thirty patients with 36 lesions were recruited and intervened by PCI. Among the target lesions, sixteen were classified as type A, 11 as type B1, 8 as type B2, 1 as type C. The average length of the target lesions was (22.0 ± 9.8) mm, and the average stenosis of the target lesions was (81.3 ± 10.3)%. Under the guidance of CT roadmap and MNS, 36 target lesions were crossed by the magnetic guidewires, with a lesion crossing ratio of 100%. The time of placement of the magnetic guidewires was 92.5 (56.6 - 131.3) seconds. The contrast volume and the radiation dosage for guidewire placement were 0.0 (0.0 - 3.0) ml and 235.0 (123.5 - 395.1) µGym(2)/36.5 (21.3 - 67.8) mGy, respectively. Guidewires were successfully placed in 21 (58.3%) lesions without contrast agent. All enrolled vessels were successfully treated, and there were no MNS associated complications. CONCLUSIONS: It is feasible, effective and safe to initiate PCI under the guidance of CT derived roadmap and MNS. This method might be helpful for the guidewire placement in the treatment of total occlusions.

Use of immuno-dominant epitope derived from genotype 4 as a diagnostic reagent for detecting the antibodies against Hepatitis E Virus.

BACKGROUND: Despite the genotype 4 has become the dominant cause of hepatitis E disease in China, none antigen derived from genotype 4 of hepatitis E virus (HEV) was used in current commercial anti-HEV immunoassay, and the serological reactivity of antigen derive from genotype 4 is not well-charactered. METHODS: We expressed and purified the 4 main immuno-dominant epitopes derived from genotype 1 and 4 including ORF2 (410-621aa) of genotype 4, ORF3 (47-114aa) of genotype 4, ORF2 (396-606aa) of genotype 1 and ORF3 (56-123aa) of genotype 4. RESULTS: The ORF2 of genotype 4 displayed good diagnostics performance according to ROC analysis using in-house panel, and the immunoassays based the ORF2 of genotype 4 was then developed to detect the anti-HEV IgG antibodies and evaluated further in 530 anti-HEV IgG positive specimens and 380 negative specimens. The sensitivity and the specificity is 98.1% (520/530) and 94.7% (360/380) for immunoassay based on ORF2 of genotype 4, 96.6% (512/530) and 92.6% (352/380) for commercial immunoassay based on genotype 1. It is noted that all of the positive samples will be detected by combing two assays together. The anti-HEV immunoassays based on genotype 4 are in accordance with Chinese anti-HEV national standard,and show an good agreement of 95.8% with commercial assay (kappa=0.913, P=0.014). CONCLUSIONS: The immunoassay based on ORF2G4 displays good performance, and combining assay based on genotype 1 together with genotype 4 will benefit the HEV diagnosis in large scale samples.

Biodegradable cross-linked poly(amino alcohol esters) based on LMW PEI for gene delivery.

Polyethylenimine (PEI, especially with M(w) of 25,000) has been known as an efficient gene carrier and a gold standard of gene transfection due to its high transfection efficiency (TE). However, high concomitant cytotoxicity limited the application of PEI. In this report, several cationic polymers derived from low molecular weight (LMW) PEI (M(w) 600) linked with diglycidyl adipate (DA-PEI) or its analogs (diglycidyl succinate, DS-PEI and diglycidyl oxalate, DO-PEI; D-PEIs for all 3 polymers) were prepared and characterized. GPC gave M(w)s of DA-PEI, DS-PEI and DO-PEI as 6861, 16,015 and 35,281, respectively. Moreover, degradation of the ester-containing DS-PEI was also confirmed by GPC. In addition, hydroxyls in these polymers could improve their water solubility. These polymers exhibited good ability to condense plasmid DNA into nanoparticles with the size of 120-250 nm. ζ-potentials of the polyplexes were found to be around +10-20 mV under weight ratios (polymer/DNA) from 0.5 to 32. Agarose gel retardation showed that DNA could be released from the polyplexes after being pre-incubated for 30 h. In vitro experiments were carried out and it was found that DS-PEI showed about 5 times of TE compared to that of the PEI/DNA polyplex under a weight ratio of 1 in A549 cells. Meanwhile, the cytotoxicity of D-PEIs assayed by MTT is lower than that of 25 kDa PEI in HEK293 cells. These results suggested that this series of PEI derivatives would be promising non-viral biodegradable vectors for gene delivery.