RESUMEN
OBJECTIVES: The aim for this pilot study was to investigate the effect of a sodium fluoride varnish on step height measured by a profilometer from human enamel worn by healthy volunteers with a novel in situ/ex vivo erosion design. METHOD: Healthy volunteers aged 18-70 years wore a palatal splint containing 8 human enamel samples and underwent two 3-day treatment periods for 6 h a day with a varnish containing sodium fluoride at 22,600 ppm and the control with the same ingredients but without fluoride. Each splint contained 4 polished and 4 unpolished samples. The interventions were applied to the surface of the enamel samples in randomised order, removed after 6 h, then immersed ex-vivo in 1 %, pH 2.7 citric acid for 2 min, repeated 4 times a day, over 2 days. Measurements of enamel were assessed blindly by microhardness on day 2 and by non-contact laser profilometry on day 3 for the two treatments. RESULTS: 24 volunteers, 2 males and 22 females aged 27-54 years, were screened and recruited. The delta microhardness, from polished samples removed at the end of day 2, for the control and fluoride treatment was 95.7 (22.9) kgf/mm2 and 123.7 (28.9) kgf/mm2, respectively (p < .005). The mean (SD) step height for the control polished enamel surfaces was 3.67 (2.07) µm and for the fluoride varnish was 1.79 (1.01) µm (p < .0005). The control unpolished enamel surfaces had a mean 2.09 (1.53) µm and the fluoride varnish was 2.11 (1.53) µm but no statistical difference was detected. CONCLUSIONS: The results from this pilot study, utilizing an in-situ model where enamel was exposed to acid over the course of 2 days, demonstrated that a high fluoride varnish containing sodium fluoride at 22,600 ppm prevented erosive wear compared to a control on the polished enamel surfaces. CLINICAL SIGNIFICANCE: Intra-oral study demonstrated that a high fluoride varnish containing sodium fluoride at 22,600 ppm reduced erosive tooth wear.