RESUMEN
The conversion of bioethanol to ethylene in gas phase and atmospheric pressure was investigated over γ-Al2O3 supported copper and nickel catalysts. These catalysts were prepared by co-precipitation and pre-treated with hydrogen at 450 °C. Six catalysts were studied at 450 °C under a nitrogen atmosphere. It was found that the monometallic Cu/γ-Al2O3 catalyst exhibited the highest ethylene concentration, with a selectivity of around 90 %. The bioethanol conversion obtained was between 57 %-86 %. Another catalyst that exhibited high concentration values was the NiCu1 : 7 bimetallic catalyst. The catalysts were characterised using XRD, SEM, EDS, TEM, TGA, FTIR, Raman, and N2-physisoption techniques. Furthermore, the Cu/γ-Al2O3 catalyst was studied under different reduction temperatures and gas flow conditions. It was found that the catalysts reduced at 350 °C and 35â ml/min N2 flow presented ethylene concentrations between (0.18-0.21)â g/L. Moreover, the catalyst deactivation was identified to be first order and the equation of the Cu/γ-Al2O3 catalyst deactivation model was determined. Carbonaceous deposits over the used sample were not detected by Raman and FTIR. It was determined that the Cu/γ-Al2O3 catalyst deactivation could be mainly attributed to the blocking of the catalytic sites by strongly adsorbed compounds and hydroxylation of the catalyst surface.
RESUMEN
Background: This work studied the use of the organic fertilizers DTPA-Fe and EDDS-Fe as iron chelates for solar driven photo-Fenton process at natural pH. This process was proposed to investigate its performance on removing a mixture of agrochemicals (propiconazole, imidacloprid and diuron) from pineapple processing wastewater to obtain a suitable effluent to be reused in the agricultural sector. Methods: Experiments were carried out in a solar simulator with a stirred cylindric photoreactor, with a volume of 150 mL and controlled temperature (20°C). The first set of experiments was carried out with ultrapure water to determine optimal iron and H 2O 2 concentrations. The second was performed with simulated wastewater of pineapple processing. Results: The optimized operational conditions for both iron complexes were 10 mg L -1 of Fe (III) and 25 mg L -1 of H 2O 2, since more than 80% of micropollutants (MP) (at an initial concentration of 1 mg L -1 of each compound) were removed in only 20 min with both DTPA-Fe and EDDS-Fe. The effect of organic matter and inorganic salts on radicals scavenging and chelates stability was also investigated in the experiments performed with synthetic pineapple processing wastewater. The results disclosed differences depending on the iron complex. Nitrites were the principal component influencing the tests carried out with EDDS-Fe. While carbonates at low concentration only significantly affected the experiments performed with DTPA-Fe, they were the major influence on the MPs removal efficiency decrease. In contrast, the presence of Ca 2+ and Mg 2+ only influence on this last one. Finally, the results of phytotoxicity disclosed the suitability of treated effluent to be reused in the agricultural sector. Conclusions: This work demonstrated that solar powered photo-Fenton catalysed by iron fertilizer EDDS is a suitable technology for depolluting water streams coming from pineapple processing plants at circumneutral pH, and its subsequent reuse for crop irrigation.