The Effect of Calcium Silicate-Based Materials on Tooth Discoloration and Evaluation of Color Change After Bleaching Treatment: A Spectrophotometric Study.

PURPOSE: To evaluate tooth discoloration after the use of calcium silicate-based materials and to examine the effect of internal bleaching on tooth discoloration. MATERIALS AND METHODS: The specimens were randomly divided into two experimental groups (n = 45) and a control group (n = 6). Cavities were filled with ProRoot MTA (Dentsply) in Group 1 and Biodentine (Septodont) in Group 2. Color measurements were taken with a spectrophotometer before and after the application of materials at 1 week and then at 13, and 6 months. After 6 months, Groups 1 and 2 were divided into three subgroups according to internal bleaching techniques. All color change ratios and lightness differences were calculated using the CIE L*a*b* system. Data were analyzed using repeated ANOVA and the Kruskal-Wallis test (P = .05). RESULTS: There were statistically significant differences between Groups 1 and 2 at all time intervals (P < .05). Group 1 showed more discoloration than Group 2 (P < .05). There were no significant differences between the bleaching agents (P > .05). Additionally, specimens in both groups became lighter than their initial color (P < .05). CONCLUSION: Teeth treated with ProRoot MTA exhibited darkening at 1 week that increased over time, whereas those treated with Biodentine maintained the lightness for 6 months.

Virgin Olive Oil, Soybean Oil, and Hank's Balanced Salt Solution Used as Storage Media on Periodontal Ligament Cell Viability.

Purpose: The purpose of this study was to compare the effects of virgin olive oil (VOO), soybean oil (SO), and Hank's Balanced Salt Solution (HBSS) on the vitality of periodontal ligament (PDL) cells of simulated avulsed teeth. Methods: Forty freshly extracted teeth were randomly divided into three experimental groups (n equals 10), one positive control group (n equals five), and one negative control group (n equals five). The experimental teeth were air-dried for 30 minutes and then soaked in one of the three storage solutions: HBSS, VOO, or SO. To quantify the number of viable cells, a collagenase-dispase assay was used. The viable PDL cells were determined via 0.4% Trypan blue staining. Data were statistically analyzed using the Kruskal-Wallis H test and Mann-Whitney U test with a significance level of 0.05. Results: The number of viable cells was significantly higher after storage in SO than in HBSS (P=0.004). There was no significant difference between SO and VOO in terms of PDL cell viability. Conclusion: Vegetable oils can be promising storage solutions for maintaining the periodontal ligament cell viability of avulsed teeth.

Physical characteristics of ceramic/glass-polymer based CAD/CAM materials: Effect of finishing and polishing techniques.

PURPOSE: The aim of this study was to compare the effect of different finishing and polishing techniques on water absorption, water solubility, and microhardness of ceramic or glass-polymer based computer-aided design and computer-aided manufacturing (CAD/CAM) materials following thermocycling. MATERIALS AND METHODS: 150 disc-shaped specimens were prepared from three different hybrid materials and divided into five subgroups according to the applied surface polishing techniques. All specimens were subjected up to #4000 grit SiC paper grinding. No additional polishing has been done to the control group (Group I). Other polishing procedures were as follows: Group II: two-stage diamond impregnated polishing discs; Group III: yellow colored rubber based silicone discs; Group IV: diamond polishing paste; and Group V: Aluminum oxide polishing discs. Subsequently, 5000-cycles of thermocycling were applied. The analyses were conducted after 24 hours, 7 days, and 30 days of water immersion. Water absorption and water solubility results were analyzed by two-way ANOVA and Tukey post-hoc tests. Besides, microhardness data were compared by Kruskal-Wallis and Mann-Whitney U tests (P<.05). RESULTS: Surface polishing procedures had significant effects on water absorption and solubility and surface microhardness of resin ceramics (P<.05). Group IV exhibited the lowest water absorption and the highest microhardness values (P<.05). Immersion periods had no effect on the microhardness of hybrid ceramic materials (P>.05). CONCLUSION: Surface finishing and polishing procedures might negatively affect physical properties of hybrid ceramic materials. Nevertheless, immersion periods do not affect the microhardness of the materials. Final polishing by using diamond polishing paste can be recommended for all CAD/CAM materials.

Tooth crown discoloration induced by endodontic sealers: a 3-year ex vivo evaluation.

OBJECTIVES: The aim of this study was to evaluate the tooth crown discoloration induced by commonly used and new-generation endodontic sealers after 1 month and 1 and 3 years. MATERIALS AND METHODS: The crowns of 60 extracted incisors were cut and the pulp chambers were cleaned. The specimens were divided randomly into four groups (n = 15 each). Pulp chambers were filled with Pulpispad in group 1, AH26 in group 2, MTA Fillapex in group 3, and EndoREZ in group 4. Specimen color was measured with a spectrophotometer before and after sealer placement. Commission International de L'Eclairage's (CIE's) lighteness (L*), red-green (a*), yellow-blue (b*) color system values and color difference (ΔE) were recorded at 1 month and 1 and 3 years. Data were analyzed using repeated-measures analysis of variance and Tukey's honestly significant difference test (α = 0.05). RESULTS: All sealers caused discoloration. At 1 month, ΔE values were significantly higher in groups 1 and 2 than in groups 3 and 4 (p < 0.05). At 1 year, ΔE values were significantly lower in group 3 than in the other groups (p < 0.05). At 3 years, ΔE values were significantly higher in group 1 than in the other groups (p < 0.05). CONCLUSIONS: All tested sealers induced varying chromatic alterations. After root canal obturation, thorough debridement of sealers from the pulp chamber is essential for the prevention of sealer-induced discoloration. CLINICAL RELEVANCE: Tooth discoloration induced by endodontic materials is a problem for clinicians and patients and may impair the esthetic of endodontically treated teeth. Therefore, evaluation of long-term discoloration effects commonly used, and new-generation endodontic sealers were purposed in this study.

Predicting intraoperative pain in emergency endodontic patients: clinical study.

This prospective observational study sought to investigate the incidence of intraoperative pain (IOP) among emergency endodontic patients and to construct an IOP prediction model that includes preoperative pain level (PPL). All patients who underwent emergency endodontic treatment at Gazi University, Ankara, Turkey, during the spring term of 2016 were considered for inclusion in the study. Demographic and clinical variables and PPL were recorded. Local anesthesia was provided to all patients before beginning routine endodontic treatment. IOP was defined as the condition of requiring supplementary anesthesia before the working length was established and exhibiting persistent moderate or severe pain despite supplementary anesthesia. Data from 85% and 15% of 435 patients (178 men, 257 women; mean age: 35 years) were used to develop predictive models by multiple logistic regression analysis and to test external validity of the models, respectively. Two multiple logistic regression models achieved good model fits. Model 1 included age, pulpal diagnosis, and arc (p < 0.05). In addition to these variables, Model 2 included periapical diagnosis and PPL (p < 0.15). Models 1 and 2 showed accuracies of 0.76 and 0.75, sensitivities of 0.74 and 0.77, and specificities of 0.76 and 0.74, respectively for the modeling data (internal validity), and accuracies of 0.82 and 0.80, sensitivities of 0.83 and 0.67, and specificities of 0.81 and 0.81, respectively for the control data (external validity). The IOP incidence was 10.3%. IOP in patients undergoing emergency endodontic treatment can be successfully predicted by using models that account for demographic and clinical variables, including PPL.

Predicting intraoperative pain in emergency endodontic patients: clinical study

Abstract This prospective observational study sought to investigate the incidence of intraoperative pain (IOP) among emergency endodontic patients and to construct an IOP prediction model that includes preoperative pain level (PPL). All patients who underwent emergency endodontic treatment at Gazi University, Ankara, Turkey, during the spring term of 2016 were considered for inclusion in the study. Demographic and clinical variables and PPL were recorded. Local anesthesia was provided to all patients before beginning routine endodontic treatment. IOP was defined as the condition of requiring supplementary anesthesia before the working length was established and exhibiting persistent moderate or severe pain despite supplementary anesthesia. Data from 85% and 15% of 435 patients (178 men, 257 women; mean age: 35 years) were used to develop predictive models by multiple logistic regression analysis and to test external validity of the models, respectively. Two multiple logistic regression models achieved good model fits. Model 1 included age, pulpal diagnosis, and arc (p < 0.05). In addition to these variables, Model 2 included periapical diagnosis and PPL (p < 0.15). Models 1 and 2 showed accuracies of 0.76 and 0.75, sensitivities of 0.74 and 0.77, and specificities of 0.76 and 0.74, respectively for the modeling data (internal validity), and accuracies of 0.82 and 0.80, sensitivities of 0.83 and 0.67, and specificities of 0.81 and 0.81, respectively for the control data (external validity). The IOP incidence was 10.3%. IOP in patients undergoing emergency endodontic treatment can be successfully predicted by using models that account for demographic and clinical variables, including PPL.