RESUMEN
The current information technology has been developed based on von Neumann type computation. In order to sustain the rate of development, it is essential to investigate alternative technologies. In a next-generation computation, an important feature is memory potentiation, which has been overlooked to date. In this study, potentiation functionality is demonstrated in a giant magnetoresistive (GMR) junction consisting of a half-metallic Heusler alloy which can be a candidate of an artificial synapse while still achieving a low resistance-area product for low power consumption. Here the Heusler alloy films are grown on a (110) surface to promote layer-by-layer growth to reduce their crystallisation energy, which is comparable with Joule heating induced by a controlled current introduction. The current-induced crystallisation leads to the reduction in the corresponding resistivity, which acts as memory potentiation for an artificial GMR synaptic junction.
RESUMEN
A new method of non-destructive sub-surface interfacial characterisation has been developed recently, which can be useful for quality assurance of a buried interface in nanoelectronic devices, such as magnetic random access memory. Since the cell size of these devices have been reducing their sizes, it is important to evaluate the resolution of the non-destructive imaging. A sub nanometric layer of different materials such as W and Pt was grown underneath a capping layer with controlled thickness for the evaluation of their sizes in this study. This provides systematic experimental data to show that the technique is capable to resolve down to approximately 2 nm in the plane, which is sufficient for the device imaging.
RESUMEN
Heusler alloys are theoretically predicted to become half-metals at room temperature (RT). The advantages of using these alloys are good lattice matching with major substrates, high Curie temperature above RT and intermetallic controllability for spin density of states at the Fermi energy level. The alloys are categorised into half- and full-Heusler alloys depending upon the crystalline structures, each being discussed both experimentally and theoretically. Fundamental properties of ferromagnetic Heusler alloys are described. Both structural and magnetic characterisations on an atomic scale are typically carried out in order to prove the half-metallicity at RT. Atomic ordering in the films is directly observed by X-ray diffraction and is also indirectly probed via the temperature dependence of electrical resistivity. Element specific magnetic moments and spin polarisation of the Heusler alloy films are directly measured using X-ray magnetic circular dichroism and Andreev reflection, respectively. By employing these ferromagnetic alloy films in a spintronic device, efficient spin injection into a non-magnetic material and large magnetoresistance are also discussed. Fundamental properties of antiferromagnetic Heusler alloys are then described. Both structural and magnetic characterisations on an atomic scale are shown. Atomic ordering in the Heusler alloy films is indirectly measured by the temperature dependence of electrical resistivity. Antiferromagnetic configurations are directly imaged by X-ray magnetic linear dichroism and polarised neutron reflection. The applications of the antiferromagnetic Heusler alloy films are also explained. The other non-magnetic Heusler alloys are listed. A brief summary is provided at the end of this review.
RESUMEN
Our recently developed non-destructive imaging technique was applied for the characterisation of nanoparticles synthesised by X-ray radiolysis and the sol-gel method. The interfacial conditions between the nanoparticles and the substrates were observed by subtracting images taken by scanning electron microscopy at controlled electron acceleration voltages to allow backscattered electrons to be generated predominantly below and above the interfaces. The interfacial adhesion was found to be dependent on the solution pH used for the particle synthesis or particle suspension preparation, proving the change in the particle formation/deposition processes with pH as anticipated and agreed with the prediction based on the Derjaguin-Landau-Verwey-Overbeek (DLVO) theory. We found that our imaging technique was useful for the characterisation of interfaces hidden by nanoparticles to reveal the formation/deposition mechanism and can be extended to the other types of interfaces.
RESUMEN
Synthesis and immobilization of caltrop cupric particles onto a Si substrate using X-ray radiolysis directly from a liquid solution of Cu(COOCH3)2 is demonstrated. Caltrop cupric oxide particles are formed in the X-ray radiolysis of aqueous solutions of Cu(COOCH3)2, which also contain methanol, ethanol, 2-propanol or 1-propanol as ^\bulletOH scavenger. The blade lengths of the caltrop particles are dependent on the alcohol chain length. In particular, it was found that an alkyl alcohol whose chain length is longer than four is unable to synthesize any particles in aqueous solutions of Cu(COOCH3)2 in X-ray radiolysis. These results are attributed to the alkyl alcohol chain length influencing the rate of reaction of radicals and determines the solvable ratio of its alcohol into water. In addition, it was found that the synthesized particle geometric structure and composition can also be controlled by the pH of the aqueous solution in the X-ray radiolysis. This study may open a door to understanding and investigating a novel photochemical reaction route induced under X-ray irradiation. The development of the X-ray radiolysis process enables us to achieve the rapid and easy process of synthesis and immobilization of higher-order nano/microstructure consisting of various materials.