Structure and size-dependent vibrational and thermal properties of Ni clusters: A systematic ab initio approach.

There is scarce information on the vibrational and thermal properties of small Ni clusters. Here, the outcomes of ab initio spin-polarized density functional theory calculations on the size and geometry effects upon the vibrational and thermal properties of Nin (n = 13 and 55) clusters, are discussed. For theses clusters a comparison is presented between the closed shell symmetric octahedral (Oh) and the icosahedral (Ih) geometries. The results indicate that the Ih isomers are lower in energy. Besides, ab initio molecular dynamics runs at T = 300K show that Ni13 and Ni55 clusters transform from their initial Oh geometries towards the corresponding Ih ones. For Ni13, we also consider the lowest energy less symmetric layered 1-3-6-3 structure, and the cuboid, recently observed experimentally for Pt13, which is competitive in energy but is unstable, as phonon analysis reveals. We calculate their vibrational density of states (νDOS) and heat capacity, and compare with the Ni FCC bulk counterpart. The characteristic features of the νDOS curves of these clusters are interpreted in terms of the clusters' sizes, the interatomic distance contractions, the bond order values as well as the internal pressure and strains of the clusters. We find that the softest possible frequency of the clusters is size and structure-dependent, being the smallest for the Oh ones. We identify mostly shear, tangential type displacements involving mainly surface atoms for the lowest frequency of the spectra of both Ih and Oh isomers. For the maximum frequencies of these clusters the central atom shows anti-phase movements against groups of nearest neighbor atoms. An excess of heat capacity at low temperatures with respect to the bulk is found, while at high temperatures a constant limiting value, close but lower to the Dulong and Petit value, is determined.

Synthesis and characterization of a bovine collagen: GAG scaffold with Uruguayan raw material for tissue engineering.

Tissue engineering (TE) and regenerative medicine offer strategies to improve damaged tissues by using scaffolds and cells. The use of collagen-based biomaterials in the field of TE has been intensively growing over the past decades. Mesenchymal stromal cells (MSCs) and dental pulp stem cells (DPSCs) are promising cell candidates for development of clinical composites. In this study, we proposed the development of a bovine collagen type I: chondroitin-6-sulphate (CG) scaffold, obtained from Uruguayan raw material (certified as free bovine spongiform encephalopathy), with CG crosslinking enhancement using different gamma radiation doses. Structural, biomechanical and chemical characteristics of the scaffolds were assessed by Scanning Electron Microscopy, axial tensile tests, FT-IR and Raman Spectroscopy, respectively. Once we selected the most appropriate scaffold for future use as a TE product, we studied the behavior of MSCs and DPSCs cultured on the scaffold by cytotoxicity, proliferation and differentiation assays. Among the diverse porous scaffolds obtained, the one with the most adequate properties was the one exposed to 15 kGy of gamma radiation. This radiation dose contributed to the crosslinking of molecules, to the formation of new bonds and/or to the reorganization of the collagen fibers. The selected scaffold was non-cytotoxic for the tested cells and a suitable substrate for cell proliferation. Furthermore, the scaffold allowed MSCs differentiation to osteogenic, chondrogenic, and adipogenic lineages. Thus, this work shows a promising approach to the synthesis of a collagen-scaffold suitable for TE.

Production of cadmium sulfide quantum dots by the lithobiontic Antarctic strain Pedobacter sp. UYP1 and their application as photosensitizer in solar cells.

BACKGROUND: Microbes are present in almost every environment on Earth, even in those with extreme environmental conditions such as Antarctica, where rocks may represent the main refuge for life. Lithobiontic communities are composed of microorganisms capable of colonizing rocks and, as it is a not so well studied bacterial community, they may represent a very interesting source of diversity and functional traits with potential for biotechnological applications. In this work we analyzed the ability of Antarctic lithobiontic bacterium to synthesize cadmium sulfide quantum dots (CdS QDs) and their potential application in solar cells. RESULTS: A basaltic andesite rock sample was collected from Fildes Peninsula, King George Island, Antarctica, and processed in order to isolate lithobiontic bacterial strains. Out of the 11 selected isolates, strain UYP1, identified as Pedobacter, was chosen for further characterization and analysis due to its high cadmium tolerance. A protocol for the biosynthesis of CdS QDs was developed and optimized for this strain. After 20 and 80 min of synthesis, yellow-green and orange-red fluorescent emissions were observed under UV light, respectively. QDs were characterized through spectroscopic techniques, dynamic light scattering analysis, high-resolution transmission electron microscopy and energy dispersive x-ray spectroscopy. Nanostructures of 3.07 nm, composed of 51.1% cadmium and 48.9% sulfide were obtained and further used as photosensitizer material in solar cells. These solar cells were able to conduct electrons and displayed an open circuit voltage of 162 mV, a short circuit current density of 0.0110 mA cm-2, and had an efficiency of conversion up to 0.0016%, which is comparable with data previously reported for solar cells sensitized with biologically produced quantum dots. CONCLUSIONS: We report a cheap, rapid and eco-friendly protocol for the production of CdS QDs by an Antarctic lithobiontic bacterium, Pedobacter, a genus that was not previously reported as a quantum dot producer. The application of the biosynthesized QDs as sensitizer material in solar cells was validated.

Antimicrobial evaluation of new metallic complexes with xylitol active against P. aeruginosa and C. albicans: MIC determination, post-agent effect and Zn-uptake.

Xylitol (xylH5) is metabolized via the pentose pathway in humans, but it is unsuitable as an energy source for many microorganisms where it produces a xylitol-induced growth inhibition and disturbance in protein synthesis. For this reason, xylitol is used in the prophylaxis of several infections. In the search of better antimicrobial agents, new copper and zinc complexes with xylitol were synthesized and characterized by analytical and spectrosco pic methods: Na2[Cu3(xylH−4)2]·NaCl·4.5H2O (Cu-xyl) and [Zn4(xylH−4)2(H2O)2]·NaCl·3H2O (Zn-xyl). Both copper and zinc complexes presented higher MIC against Pseudomona aeruginosa than the free xylitol while two different behaviors were found against Candida albicans depending on the complex. The growth curves showed that Cu-xyl presented lower activity than the free ligand during all the studied period. In the case of Znxyl the growth curves showed that the inhibition of the microorganism growth in the first stage was equivalent to that of xylitol but in the second stage (after 18 h) Zn-xyl inhibited more. Besides, the PAE (post agent effect)obtained for Zn-xyl and xyl showed that the recovery from the damage of microbial cells had a delay of 14 and 13 h respectively. This behavior could be useful in prophylaxis treatments for infectious diseases where it is important that the antimicrobial effect lasts longer. With the aim to understand the microbiological activities the analysis of the particle size, lipophilicity and Zn uptake was performed.

Control of cryopreservation procedures on blood vessels using fiber x-ray diffraction.

AIM: We sought to determine variations in fiber organization at the molecular level using x-ray diffraction analyses on human blood vessel specimens after cryopreservation processes. MATERIALS AND METHODS: Diffractometric profiles were performed on aortic and carotid cryopreserved-thawed vessel samples (CVS) versus the same fresh vessel samples (FVS). X-ray diffraction was performed on vascular tissues from 17 cadaveric donors after informed consent. Measurements utilized a Seifert Scintag PAD-II powder diffractometer with CuK(a) radiation; lambda = 1.5418 A. Scans were evaluated in the 5 degrees to 60 degrees range in theta -2theta mode, in the 5 degrees to 60 degrees range in 2-theta, with steps 0.1 degrees and 10 seconds per step. Ten aortic and 8 carotid diffractometric profiles were analyzed, using differential planimetric surfaces measured under x-ray diffraction curve. Diffractographic profiles were analyzed according to intervals based upon the ages of the donors. An ordering profile coefficient (OPC) was obtained as the quotient between the differential planimetric surface (DPS) of FVS versus CVS vessel ordering diffraction. RESULTS: There was a decreased ordering profile according to age: older donors showed less ordering than younger ones. Clear peaks at d-spacing of 2.86 A and 2.15 A (2-theta = 31.3 degrees and 42.0 degrees , respectively) were always confirmed despite the different profiles of samples. OPC showed a higher ordering profile among the CVS than FVS: 70% aortas and 62.5% carotids. CONCLUSION: The cryopreserved-thawed procedure does not damage the fibrillar organization of vessels.

Random deposition of two annihilating species in the (1+1) dimension.

We present simulation results for the one-dimensional random deposition of two annihilating species A and B, falling with probabilities p and q (p+q=1), which then react to produce an inert product, i.e., A+B-->0. Two different annihilation rules are defined: top annihilation and nearest-neighbor annihilation (NNA), leading to distinct scaling behaviors. In particular, the values of the scaling exponents for NNA are found to be dependent on probability p, suggesting different universality classes.